2007 MERCEDES-BENZ GL320CDI coolant level

473 Practical hints
What to do if …
Display symbolDisplay messagesPossible cause/consequencePossible solution
Ï Coolant level
Stop car, switch engine offThe coolant is too hot.
Among other possible causes
(the cooling fan could be
malfunctioning), the poly-V-belt
could be broken.Stop the vehicle in safe location or as
soon as it safe to do so.
Apply the parking brake (page 68).
Turn off the engine.
Check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise, the
engine will overheat due to an inoperative
water pump which may result in damage
to the engine. Contact an authorized
Mercedes-Benz Light Truck Center.
If it is intact:
Do not continue to drive the vehicle with
this message displayed. Doing so could
result in serious engine damage that is
not covered by the Mercedes-Benz Limit-
ed Warranty.
(Continued on next page)

475 Practical hints
What to do if …
Display symbolDisplay messagesPossible cause/consequencePossible solution
B Top up Coolant
See Oper. ManualThe coolant level is too low.Add coolant (page 382).
If you have to add coolant frequently,
have the cooling system checked by an
authorized Mercedes-Benz Light Truck
Center.
Warning!G
Do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts. You could be seriously burned.
!Do not ignore the low engine coolant level
warning. Extended driving with the message and
symbol displayed may cause serious engine
damage not covered by the Mercedes-Benz
Limited Warranty.
Do not drive without sufficient amount of coolant
in the cooling system. The engine will overheat
causing major engine damage.

565 Technical data
Fuels, coolants, lubricants
Coolants
The engine coolant is a mixture of water
and anticorrosion/antifreeze, which
provides:

Corrosion protection

Freeze protection

Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -35°F (-37°C) and corro-
sion protection.If the antifreeze mixture is effective to
-35°F (-37°C), the boiling point of the cool-
ant in the pressurized cooling system is
reached at approximately 266°F (130°C).
The coolant solution must be used year
round to provide the necessary corrosion
protection and increase boil-over protec-
tion. Refer to Maintenance Booklet for
replacement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification are used to
renew the coolant concentration or bring it
back up to the proper level.
For information on other Mercedes-Benz
approved products of equal specification,
refer to the Factory Approved Service
Products pamphlet (USA only) or contact
an authorized Mercedes-Benz Light Truck
Center.To provide important corrosion protection,
the solution must be at least 50% anticor-
rosion/antifreeze (equivalent to freeze
protection to approximately -35°F
[-37°C]). If you use a solution that is more
than 55% anticorrosion/antifreeze (freeze
protection to approximately -49°F
[-45°C]), the engine temperature will
increase due to the lower heat transfer
capability of the solution. Therefore, do not
use more than this amount of anticorro-
sion/antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion/Antifreeze
should be used to bring it up to the proper
level (have cooling system checked for
signs of leakage). Please make sure the
mixture is in accordance with label instruc-
tions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality, con-
sult an authorized Mercedes-Benz Light
Truck Center.
!Add premixed coolant solution only. Adding
water and MB 325.0 Anticorrosion/Antifreeze
separately from each other, could cause engine
damage not covered by the
Mercedes-Benz Limited Warranty.

572 Index
Children in the vehicle 93
Air bags 77, 93
Blocking rear door window
operation 100
Indicator lamp, Front passenger front
air bag 85, 87, 450
Infant and child restraint systems 88,
94
LATCH-type child seat anchors 97
Occupant Classification System*
(OCS) 81
Cigarette lighter* 324
Climate control 216
Air conditioning refrigerant 561
Air conditioning, Cooling 226, 227
Air distribution, Front 221
Air distribution, rear 229
Air recirculation mode 224
Air vents*, second-row seats 222
Air vents, Front 222
Air volume 222
Control panel*, Rear 228
Control panel, Front 218
Deactivating system 220
Defogging 224
Defrosting 223Rear window defroster 215
Residual engine heat (REST) 227
Clock 27, 176
Setting time 176
Cloth upholstery, Cleaning and
care of 434
Cockpit 24
Cockpit Management and Data System
see COMAND System
Cold tire inflation pressure 416
Collapsible wheel chock 498
COMAND System see separate operating
instructions
Combination switch 63, 65, 149
Compass 345
Adjustment 181
Calibration 182
Calling up the compass 345
Control and operation of radio
transmitters 372
Control system 157
Multifunction display 157
Multifunction steering wheel 158
Resetting to factory default 171Control system menus 157
Audio 166
DISTRONIC* 169
NAV* 168
Off-road 168
Settings 170
Standard display 164
TEL* 189
Trip computer 187
Vehicle configuration 185
Vehicle status message memory 169
Control system submenus 161, 163, 173
Comfort* 184
Instrument cluster 174, 175
Lighting 178
Time/Date 176
Vehicle 181
Coolant 382, 565
Anticorrosion/antifreeze mixing ratio
and quantity 566
Capacities 560
Checking coolant level 377, 382
Messages in the
multifunction display 473, 475
Temperature 374
Temperature display 164

575 Index
Emergency operation
Fuel filler flap 501
Locking/unlocking the vehicle 500,
501
Power tilt/sliding sunroof*,
Manual operation 503
Emergency operation
(Limp-Home Mode) 202
Emergency operations
Exit for third-row seats 134
Remote door unlock, Tele Aid 338
Tailgate, Opening from the inside
manually 124
Emergency Tensioning Device see ETD
Emergency, In case of
Battery, Jump starting 538
Engine shut-down 546
First aid kit 495
Flat tire 523
Fuses 544
Hazard warning flasher 151
Instrument cluster, Indicator
lamps 436, 437, 438, 439, 440,
441, 442, 443, 444, 445, 446
Roadside Assistance 12, 336
Towing the vehicle 540Emission control 373
Information label 551
System warranties 10
Vacuum line routing diagram
label 551
Engine
Belt layout 552
Belt layout (GL 320 CDI) 552
Break-in recommendations 381
Cleaning 427
Compartment 379
Emergency engine shut-down 546
Malfunction indicator lamp 29, 472
Maximum engine speed 156, 553
Messages in the
multifunction display 472
Number 551
Starting 57
Starting with KEYLESS-GO* 59
Starting with the SmartKey 58
Tachometer 29, 156
Technical data 553
Turning off with KEYLESS-GO* 70
Turning off with the SmartKey 70Engine coolant see Coolant
Engine oil 381, 562
Adding 382, 562
Additives 562
Changing 382, 562
Checking level 381
Checking with the oil dipstick 381
Consumption 381
Filler neck 382
Messages in the
multifunction display 476
Recommended engine oils and oil
filters 562
Enhanced Off-road Package*
Vehicle level control 285
ESP® 27, 105
Four wheel electronic traction system
with ESP® 105
Messages in the
multifunction display 459, 460
Off-road-ESP® 108
Warning lamp 27, 441, 442