2007 MERCEDES-BENZ G55AMG turn signal bulb

358 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
.Turn signal
front left
Auxiliary bulb
onThe left front turn signal lamp is mal-
functioning. A substitute bulb has been
brought into use.Replace the bulb as soon as possible
(
page 383).
Turn signal
front right
Auxiliary bulb
onThe right front turn signal lamp is mal-
functioning. A substitute bulb has been
brought into use.Replace the bulb as soon as possible
(
page 383).
Turn signal
rear left
Auxiliary bulb
onThe left rear turn signal lamp is malfunc-
tioning. A substitute bulb has been
brought into use.Replace the bulb as soon as possible
(
page 385).
Turn signal
rear right
Auxiliary bulb
onThe right rear turn signal lamp is malfunc-
tioning. A substitute bulb has been
brought into use.Replace the bulb as soon as possible
(
page 385).

377 Practical hints
Replacing bulbs
Replacing bulbs
Bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp
assemblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See an authorized
Mercedes-Benz Light Truck Center for
headlamp adjustment.iIf the headlamps or front fog lamps are
fogged up on the inside as a result of high
humidity, driving the vehicle a distance with the
lights on should clear up the fogging.iSubstitute bulbs will be brought into use
when the following lamps malfunction:

Turn signal lamps

Tail lamps

Parking lamps

Rear fog lamp
Read and observe the messages in the
multifunction display (
page 354).

378 Practical hints
Replacing bulbs
Front lamps Rear lamps
LampType
1Additional turn signal
lampLED
2Locator lighting lampW6W
3Turn signal lamp1156 NA
4Side marker lampT4W
5Bi-Xenon headlamp:
Low and high beam1
1Bi-Xenon headlamp: Low beam and high beam use
the same D1S-35 W lamp. Do not replace the
Bi-Xenon bulbs yourself. Contact an authorized
Mercedes-Benz Light Truck Center.
D1S-35 W
Parking and standing
lampW5W
Blue vision
6Front fog lampH11 (55 W)
LampType
7High mounted brake
lampLED
8Turn signal lampPY 21 W
Brake and tail lampP21/5W
Tail, parking and
standing lampW5W
9Backup lampP21W
aLicense plate lampsC5W
bRear fog lampP21W
cSide marker lampT4W

379 Practical hints
Replacing bulbs
Notes on bulb replacement

Only use 12-volt bulbs of the same type
and with the specified watt rating.

Switch lights off before changing a bulb
to prevent short circuits.

Always use a clean lint-free cloth when
handling bulbs.

Your hands should be dry and free of oil
and grease.

If the newly installed bulb does not
come on, contact an authorized
Mercedes-Benz Light Truck Center.Have the LEDs and bulbs for the following
lamps replaced at an authorized
Mercedes-Benz Light Truck Center:

the additional turn signal lamps in the
exterior rear view mirrors

the high mounted brake lamp

the Bi-Xenon lamps

the locator lighting lamps in the
exterior rear view mirrors
Warning!G
Bulbs and bulb sockets can be very hot.
Allow the lamp to cool down before
changing a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas.
A bulb can explode if you:

touch or move it when hot

drop the bulb

scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
!Do not replace the LEDs yourself. You could
otherwise damage the LEDs or parts of the vehi-
cle. Only have the LEDs replaced at an autho-
rized Mercedes-Benz Light Truck Center.

383 Practical hints
Replacing bulbs
7Bulb
Pull bulb7 out of its bulb socket.
Insert the new bulb into the bulb
socket.
Hold front fog lamp5, insert bulb
socket6 into front fog lamp5, and
turn bulb socket6 clockwise to its
stop.
Insert front fog lamp5 and install and
tighten front fog lamp-securing
screws3.
Install front fog lamp trim panel2 and
the seal.
Install and tighten securing screws1.Front turn signal lamp bulb
1Securing screw
2Turn signal lens
Loosen and remove securing
screws1.
Remove turn signal lens2.3Bulb
Press bulb3 gently into the socket,
turn counterclockwise and remove it.
Press the new bulb gently into the
socket and turn clockwise until it
engages.
Reinstall turn signal lens2.
Install and tighten securing screws1.
iG55AMG:
Remove the protective grille before replacing the
bulbs.
iDo not overtighten securing screws1.
Otherwise turn signal lens2 could be damaged.

385 Practical hints
Replacing bulbs
Reinstall side marker lamp housing2.
Install and tighten securing screws1.
Additional turn signal lamps
The additional turn signal lamps in the
exterior rear view mirrors have LEDs.
If a malfunction occurs or LEDs fail to
function, the entire turn signal unit must be
replaced. Have the turn signal unit
replaced at an authorized Mercedes-Benz
Light Truck Center.Locator lighting lamps
The locator lighting lamps in the exterior
rear view mirrors have bulbs.
Have the bulbs replaced at an authorized
Mercedes-Benz Light Truck Center.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following first:
Turn the exterior lamp switch to
positionM (
page 117).Bulbs in tail lamp unit
Left tail lamp lens shown, right tail lamp
lens laterally reversed
1Securing screw
2Tail lamp lens
Loosen and remove securing
screws1.
Remove tail lamp lens2.
iDo not overtighten securing screws1.
Otherwise side marker lamp housing2 could
be damaged.
iG55AMG:
Remove the protective grille before replacing the
bulbs.


386 Practical hints
Replacing bulbs
Left tail lamp unit shown, right tail lamp
unit laterally reversed
3Turn signal lamp bulb
4Brake, tail, parking and standing lamp
bulb
5Tail, parking and standing lamp bulb
Press gently onto respective
bulb3,4, or5 and turn counter-
clockwise out of its bulb socket.
Press the new bulb gently into the bulb
socket and turn clockwise until it
engages.
Reinstall tail lamp lens2.
Install and tighten securing screws1.Rear fog lamp bulb/Backup lamp bulb
The following description applies to both,
the rear fog lamp and the backup lamp.
Rear fog lamp shown
1Securing screw
2Lamp lens
Loosen and remove securing
screws1.
Remove lamp lens2.3Bulb
Press gently onto bulb3 and turn
counterclockwise out of its bulb
socket.
Press the new bulb gently into the bulb
socket and turn clockwise until it
engages.
Reinstall lamp lens2.
Install and tighten securing screws1.
iDo not overtighten securing screws1.
Otherwise tail lamp lens2 could be damaged.
iDo not overtighten securing screws1.
Otherwise lamp lens2 could be damaged.


433 Index
Batteries
SmartKey (replacing) 376
Batteries, SmartKey
Check lamp 103
Checking 103
Battery box
Fuse box in 408
Battery discharged
Jump starting 399
Battery, vehicle 396
Charging 398
Disconnecting 398
Messages in display 344–345
Reconnecting 398
Reinstalling 398
Removing 398
Bead 304
Block heater (Canada only) 310
Blocking rear door window operation 86
B-pillar 412
Brake fluid 266, 425
Message in display 346
Brake lamp bulbs, left and right 378
Brake lamp, high mounted 378
Brake lamps
Messages in display 354Brake pads
Message in display 347
Brakes 246
Warning lamp 326–327
Break-in period 244
Brush guard 375
Lowering 375
Raising and securing 375
Bulbs, replacing
Additional turn signals 378
Backup lamps 378, 386
Brake lamps 378, 386
Front fog lamps 378, 382
Front lamps 378
Front turn signal lamps 378, 383
High beam lamps 378
High mounted brake lamp 378
License plate lamps 378, 387
Locator lighting lamps 378
Low beam lamps 378
Parking lamps 378, 380
Rear fog lamp 378, 386Rear lamps 378
Rear turn signal lamps 378
Side marker lamps 378, 384
Standing lamps 378, 380
Tail lamp assemblies 378
Tail lamp unit 385
C
Call priority, Tele Aid 235
Calling up
Maintenance service indicator
display 313
Range (distance to empty) 158
Capacities
Fuels, coolants, lubricants, etc. 422
Cargo area see Cargo compartment
Cargo compartment
Expanding 206
Tailgate 105
Tie-down rings 209
Cargo compartment cover blind 214
Installing 214
Removing 214
Rolling out 214
Rolling up 214
Cargo compartment lamps 127