2007 MERCEDES-BENZ G55AMG flat tire

391 Practical hints
Flat tire
Mounting the spare wheel
Preparing the vehicle
Prepare the vehicle as described
(
page 390).
Remove the spare wheel from the
spare wheel carrier (
page 368).
Take the vehicle tool kit out of its
storage compartment (
page 366).
Take the vehicle jack out of its storage
compartment (
page 367).Lifting the vehicle
Prevent the vehicle from rolling away
by blocking wheels with wheel chocks
(not included) or other sizeable
objects.
When changing wheel on a level surface:
Place one wheel chock in front of and
one behind the wheel that is diagonally
opposite to the wheel being changed.
Always try lifting the vehicle using the jack
on a level surface. However, should
circumstances require you to do so on a
hill, place the wheel chocks as follows:
Place the wheel chocks on the downhill
side blocking both wheels of the axle
not being worked on.
Warning!G
For your safety, remove spare wheel from
spare wheel carrier before undertaking any
further steps.
Warning!G
The jack is designed exclusively for jacking
up the vehicle under the axle housing. To
help avoid personal injury, use the jack only
to lift the vehicle during a wheel change.
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always firmly set parking brake and block
wheels before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface.
Make sure the jack is positioned correctly
under the axle housing. Always lower the
vehicle onto sufficient capacity jackstands
before working under the vehicle.
If the vehicle is not raised as described, it
could slip off the jack as a result of vibra-
tions (e.g. opening or closing a door or the
tailgate).


392 Practical hints
Flat tire
Wheel wrench
Take the wheel wrench out of the
vehicle tool kit.
On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with the
wheel wrench).
Pump handle (three pieces)
1Indent for activation of release bolt2
Take the pump handle out of the
vehicle tool kit.
Assemble the pump handle for the
jack.
Jack
2Release bolt
Set indent1 of the pump handle onto
release bolt2.
Using the pump handle, turn release
bolt2 clockwise until its stop.
Release bolt2 is closed.
Remove the pump handle from release
bolt2.
Set the pump handle into the pump
lever (indicated by the arrow).


393 Practical hints
Flat tire
Place jack on firm ground.
Position jack under the axle housing,
so that it is always vertical (plumb-line)
as seen from the side, even if the
vehicle is parked on an incline.
Be certain the jack arm is positioned
correctly under the axle housing (axle
must fall into jack contour).
Jack up the vehicle by pumping
(indicated by the arrow) until the wheel
is a maximum of 1.2 in (3 cm) from the
ground. Removing the wheel
Remove the wheel bolts.
Remove the wheel.
!Do not position the jack on the body of the
vehicle, as this may cause damage to the
vehicle.
Warning!G
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.

Never start the engine when the vehicle
is raised.

Never lie down under the raised vehicle.
!Do not place wheel bolts in sand or dirt. This
could result in damage to the bolt and wheel hub
threads.
Warning!G
Make sure no one is injured when removing
the wheel.
Grip wheel from the sides.
Keep hands from beneath the wheel.

394 Practical hints
Flat tire
Mounting the new wheel
Clean contact surfaces of wheel and
wheel hub.
Push the wheel onto the wheel hub and
press firmly.
Insert wheel bolts and tighten them
slightly.Lowering the vehicle
Using the pump handle, turn the
release bolt of the jack counter-
clockwise approximately one turn
(
page 392).
Lower the vehicle until it is resting fully
on its own weight.
Remove the jack.
!To avoid paint damage, place wheel flat
against hub and hold it there while installing first
wheel bolt.
Warning!G
Always replace wheel bolts that are
damaged or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be
repaired immediately. Do not continue to
drive under these circumstances! Contact
an authorized Mercedes-Benz Light Truck
Center.
Incorrect wheel bolts or improperly tight-
ened wheel bolts can cause the wheel to
come off. This could cause an accident.
Make sure to use the correct wheel bolts.
Warning!G
Only use genuine Mercedes-Benz wheel
bolts. Other wheel bolts may come loose.
Do not tighten the wheel bolts when the
vehicle is raised. Otherwise the vehicle
could tip over.
iNever turn the release bolt of the jack more
than one or two revolutions. Otherwise hydraulic
fluid can escape.

395 Practical hints
Flat tire
1-5 Wheel bolts
Tighten the five wheel bolts evenly,
following the diagonal sequence illus-
trated (1 to 5), until all wheel bolts
are tight. Observe a tightening torque
of 96 lb-ft (130 Nm).
Disassemble the pump handle
(
page 392).
Put the pump handle and the wheel
wrench back into the vehicle tool kit.
Store the vehicle tool kit in the
designated storage compartment
(
page 366).
Press the jack piston in again and close
the lowering screw (
page 392).
Store the jack in the designated
storage compartment (
page 367).
After changing the wheel, secure the
damaged wheel on the spare wheel
carrier (
page 369). Make sure the
wheel cannot come loose.
Check the tire inflation pressure and
correct it if necessary.
Follow recommended cold tire inflation
pressures listed on the Tire and
Loading Information placard on the
driver’s door B-pillar (
page 280).
Warning!G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
96 lb-ft (130 Nm).

416 Technical data
Rims and tires
!Only use tires which have been tested and
approved by Mercedes-Benz. Tires approved by
Mercedes-Benz are developed to provide best
possible performance in conjunction with the
driving safety systems on your vehicle such as
ABS or ESP
®. Tires specially developed for your
vehicle and tested and approved by
Mercedes-Benz can be identified by finding the
following on the tire’s sidewall:

MO = Mercedes-Benz Original equipment
tires
Using tires other than those approved by
Mercedes-Benz may result in damage that is not
covered by the Mercedes-Benz Limited
Warranty.
!Using tires other than those approved by
Mercedes-Benz can have detrimental effects,
such as

poor handling characteristics

increased noise

increased fuel consumption
Moreover, tires and rims not approved by
Mercedes-Benz may, under load, exhibit dimen-
sional variations and different tire deformation
characteristics that could cause them to come
into contact with the vehicle body or axle parts.
Damage to the tires or the vehicle may be the
result.
iFurther information on tires and rims is
available at any authorized Mercedes-Benz Light
Truck Center. The Tire and Loading Information
placard with the recommended tire inflation
pressures is located on the driver’s door B-pillar.
Some vehicles may have supplemental tire
inflation pressure information for driving at high
speeds (
page 287) or for vehicle loads less
than the maximum loaded vehicle condition
(
page 287). If such information is provided, it
can be found on the tire inflation pressure label
located on the inside of the fuel filler flap.The tire inflation pressure should be checked
regularly and should only be adjusted on cold
tires. Follow tire manufacturer’s maintenance
recommendation included with vehicle.
iThe following pages also list the approved
wheel rim and tire sizes for equipping your
vehicles with winter tires. Winter tires are not
available as standard or optional factory equip-
ment, but can be purchased from an authorized
Mercedes-Benz Light Truck Center.
Depending on vehicle model and the standard or
optional factory-equipped wheel rim/tire
configuration on your vehicle, equipping your
vehicle with winter tires approved for your
vehicle model may also require the purchase of
two or four wheel rims of the recommended size
for use with these winter tires. See an authorized
Mercedes-Benz Light Truck Center for more
information.

432 Index
Air pressure 304
Air pressure see Tire inflation pressure
Air recirculation mode 188
Activating 188
Deactivating 189
Air vents, Rear
Climate control 191
Air volume
Adjusting 186
Alarm
Audible 87, 96
Canceling 97, 98
Visual 96
Alarm system
Anti-theft 96
Anticorrosion/antifreeze 428
Anti-theft alarm system
Arming 97
Canceling alarm 97
Disarming 97
Anti-theft systems 96
Anti-theft alarm system 96
Tow-away alarm 98
Aquaplaning see HydroplaningArmrest
Storage box in front of 217
Storage compartments below 216
Telephone* tray below 216
Ashtrays 220
In center console 220
In rear passenger compartment 221
Aspect ratio 304
At the gas station 264
ATF (automatic transmission fluid) 273
Audio menu 141
Selecting radio station 141
Audio search function 155
Auto-dimming for rear view mirror 177
Automatic central locking
Activating/deactivating (control
system) 155
Automatic headlamp mode 118
Automatic locking when driving 106
Automatic operation
Interior lighting control 125Automatic transmission 162
Accelerator position 166
Emergency operation (Limp Home
Mode) 169
Fluid level 273
Gear ranges 167
Gear selector lever 162
Gear selector lever position 163, 164
Gear shifting malfunctions 169
Kickdown 166
One-touch gearshifting 168
Shifting procedure 163
Transmission fluid 273
B
BabySmart
TM
Air bag deactivation system 81
Compatible child seats 81
Self-test 82
Backup lamp
Message in display 357
Backup lamps
Bulbs 378
Replacing bulbs 386
Bar 304
BAS 88, 90

435 Index
Cockpit 24
Cold tire inflation pressure 304
COMAND see separate operating
instructions
Combination switch 25, 122
High beam flasher 57, 122
High beam headlamps 122
Turn signals 57
Windshield wipers 58
Control and operation of radio
transmitters 261
Control system 133
Audio menu 141
Convenience submenu 156
Display digital speedometer 140
Display outside temperature 140
Functions 135, 137, 139
Instrument cluster submenu 149
Lighting submenu 151
Menus 136, 137, 139
Multifunction display 133
Multifunction steering wheel 134
NAVI menu 144
Satellite radio (USA only) 142
Selecting radio system 141
Settings menu 146Standard display menu 140
Submenus 135, 137, 139
TEL menu 159
Trip computer menu 157
Vehicle status message memory
menu 144
Vehicle submenu 154
Convenience feature 194
Convenience submenu 156
Activating easy-entry/exit
feature 156
Coolant 274, 427
Adding 275
Anticorrosion/antifreeze
quantity 428
Capacities 422
Checking level 274
Messages in display 347–350
Temperature 263
Temperature gauge 131
Coolant level
Checking 266, 274
Coolant temperature gauge 27
Corner-illuminating front fog lamps 122
Crossing obstacles 258Cruise control 197
Canceling 198
Driving downhill 198
Driving uphill 198
Fine adjustment 199
Message in display 350
Setting current speed 198
Setting speed 199
Cruise control lever 198
Cup holders 219
In front passenger footwell 220
In rear passenger footwell 220
Next to armrest 219
Curb weight 304