2007 MERCEDES-BENZ CLS63AMG clock

27 At a glance
Instrument cluster
Item
Page
1
LLeft turn signal
indicator lamp
2
vESP
® warning lamp
343
3
Speedometer
4
Multifunction display
141
5
lDistance warning
lamp
Vehicles without Distronic*:
Warning lamp without func-
tion. It illuminates with the
ignition on. It should go out
when the engine is running.
348
6
KRight turn signal
indicator lamp
7
Coolant temperature indi-
cator with:•Coolant temperature
warning lamp
347
Item
Page
8
Tachometer with:1Supplemental
Restraint System
(SRS) indicator lamp
350
-Antilock Brake Sys-
tem (ABS) indicator
lamp
342
348
AHigh beam headlamp
indicator lamp
132
9
Main odometer with:

Selector lever position
51


Program mode
177
a
Clock with:
159
;Brake warning lamp,
USA only
344
3Brake warning lamp,
Canada only
344
Item
Page
úEngine malfunction
indicator lamp, USA
only
345
±Engine malfunction
indicator lamp, Cana-
da only
345
HCombination low tire
pressure/TPMS mal-
function telltale,
USA only
351
Low tire pressure
telltale, Canada only
351
b
Fuel display with:AFuel tank reserve
warning lamp
348
c
Reset button for:

Resetting trip odometer
139


Adjusting instrument
cluster illumination
138


Confirming new time
settings
159

118 Controls in detailLocking and unlocking
Close the trunk (
page 113).

Remove the mechanical key from the
SmartKey (
page 396).

Insert the mechanical key in the trunk
lid lock.

Turn the mechanical key clockwise to
position2 to lock the trunk.
The trunk remains locked even when the
vehicle is centrally unlocked.

Insert the mechanical key in the trunk
lid lock.

Turn the mechanical key counterclock-
wise to neutral position1 to unlock the
trunk.
You can now open the trunk
(page 112).
Automatic central locking
The doors and the trunk automatically lock
when the ignition is switched on and the
wheels are turning at vehicle speeds of ap-
proximately 9 mph (15 km / h) or more.
The locking knobs in the doors move down.
You can open a locked door from the in-
side. Open door only when conditions are
safe to do so.
You can deactivate the automatic locking
mode using the control system
(page 165).
Locking and unlocking from the inside
You can lock or unlock the doors and the
trunk from inside using the central locking
switch. This can be useful, for example, if
you want to lock the vehicle before starting
to drive.
The fuel filler flap cannot be locked or un-
locked with the central locking switch.
i
You can only cancel the separate trunk lock-
ing mode by means of the mechanical key.
i
The doors are designed to unlock automati-
cally after an accident if the force of the impact
exceeds a preset threshold. The vehicle locks au-
tomatically when the ignition is switched on and
the wheels are turning at vehicle speeds of ap-
proximately 9 mph (15 km/h) or more. You could
therefore lock yourself out when the vehicle


is pushed or towed


is on a test stand
Warning!
G
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. A child’s unsupervised ac-
cess to a vehicle could result in an accident
and/or serious personal injury.

138 Controls in detailInstrument clusterFor a full view illustration of the instrument
cluster, see “At a glance” (
page 26).
1Reset button
The instrument cluster is activated when
you


open a door


switch on the ignition


press the reset button1


switch on the exterior lamps
You can modify the instrument cluster set-
tings in the instrument cluster submenu of
the control system (
page 157).Adjusting instrument cluster
illumination
Use the reset button (
page 138) to ad-
just the illumination brightness for the in-
strument cluster.To brighten illumination

Turn the reset button (
page 138)
clockwise.
The instrument cluster illumination will
brighten.
To dim illumination

Turn the reset button (
page 138)
counterclockwise.
The instrument cluster illumination will
dim.
Warning!
G
No messages will be displayed if either the
instrument cluster or the multifunction dis-
play is inoperative.
As a result, you will not be able to see infor-
mation about your driving conditions, such
as speed or outside temperature, warn-
ing/indicator lamps, malfunction/warning
messages or the failure of any systems.
Driving characteristics may be impaired.
If you must continue to drive, please do so
with added caution. Visit an authorized
Mercedes-Benz Center as soon as possible.
i
The instrument cluster illumination is
dimmed or brightened automatically to suit am-
bient light conditions.
The instrument cluster illumination will also be
adjusted automatically when you switch on the
vehicle’s exterior lamps.

257 Controls in detail
Useful features
Tele Aid
Shortly after the completion of your Tele
Aid acquaintance call, you will receive a
user ID and password. By visiting
www.mbusa.com and selecting “Tele Aid”
(USA only), you will have access to account
information, remote door unlock and
more.The Tele Aid system
(Tele
matic A
larm I
dentification on
D
emand)
The Tele Aid system consists of three
types of response:

automatic and manual emergency


roadside assistance


information
The Tele Aid system is operational provid-
ing that the vehicle’s battery is charged,
properly connected, not damaged and cel-
lular and GPS coverage is available.
The speaker volume of a Tele Aid call can
be adjusted when using the volume control
on the COMAND System or on the multi-
function steering wheel. To raise, turn the
rotary volume control on COMAND System
clockwise or press buttonæ on the
multifunction steering wheel. To lower,
turn the rotary volume control on
COMAND System control counterclock-
wise or press buttonç on the multi-
function steering wheel.

To activate, press the SOS button, the
Roadside Assistance button• or
the Information button¡, depend-
ing on the type of response required.
!
The initial activation of the Tele Aid system
may only be performed by completing the sub-
scriber agreement and placing an acquaintance
call using the ¡button. Failure to complete
either of these steps will result in a system that
is not activated.
If you have any questions regarding activation,
please call the Response Center at
1-800-756-9018 (in the USA) or
1-888-923-8367 (in Canada).
i
The SOS button is located in the overhead
control panel (
page 259).
The Roadside Assistance button• and the
Information button¡ are located below the
center armrest cover (
page 244).

284 OperationAt the gas station
Open fuel filler flap1 by pushing at
the point indicated by the arrow.
The fuel filler flap springs open.

Turn fuel cap2 counterclockwise and
hold on to it until possible pressure is
released.

Take off fuel cap2 and place it into
holder3 located on the inside of the
fuel filler flap.
To prevent fuel vapors from escaping
into open air, fully insert filler nozzle
unit.

Only fill your tank until the filler nozzle
unit cuts out – do not top off or over-
fill.

Replace fuel cap by turning it clockwise
until it audibly engages.

Close the fuel filler flap.Warning!
G
Overfilling of the fuel tank may create pres-
sure in the system which could cause a gas-
oline fuel discharge. This could cause the
gasoline fuel to spray back out when remov-
ing the fuel pump nozzle, which could cause
personal injury.i
Make sure to close the fuel filler flap before
locking your vehicle as the flap locking pin pre-
vents closing after you have locked the vehicle.
i
Leaving the engine running and the fuel cap
open can cause the yellow fuel tank reserve
warning lamp to flash and the malfunction indi-
cator lampú(USA only) or the malfunction
indicator lamp±(Canada only) to illuminate.
See also “Practical hints” section (
page 345).
i
Only use premium unleaded gasoline with a
minimum Posted Octane Rating of 91 (average of
96 RON/86 MON). Information on gasoline
quality can normally be found on the fuel pump.
For more information on gasoline, see the Facto-
ry Approved Service Products pamphlet.


290 OperationEngine compartmentCoolant level
The engine coolant is a mixture of water
and anticorrosion/antifreeze. To check
the coolant level, the vehicle must be
parked on level ground and the engine
must be cool.
The coolant expansion tank is located on
the driver’s side of the engine compart-
ment.
1Marking bar in the expansion tank
2Cap
3Coolant expansion tank

Using a rag, turn cap2 slowly approx-
imately one half turn counterclockwise
to release any excess pressure.

Continue turning the cap2 counter-
clockwise and remove it.
The coolant level is correct if the level:

for cold coolant: reaches marking
bar1 in the expansion tank3


for warm coolant: is approximately
0.6 in (1.5 cm) higher

Add coolant as required.

Replace and tighten cap2.
For more information on coolant, see the
“Technical data” section (
page 453).
Warning!
G
In order to avoid potentially serious burns:

Use extreme caution when opening the
hood if there are any signs of steam or
coolant leaking from the cooling system,
or if the coolant temperature gauge indi-
cates that the coolant is overheated.


Do not remove pressure cap on coolant
reservoir if coolant temperature is
above 158°F (70°C). Allow engine to
cool down before removing cap. The
coolant reservoir contains hot fluid and
is under pressure.


Using a rag, slowly open the cap approx-
imately
1/2 turn to relieve excess pres-
sure. If opened immediately, scalding
hot fluid and steam will be blown out
under pressure.


Do not spill antifreeze on hot engine
parts. Antifreeze contains ethylene gly-
col which may burn if it comes into con-
tact with hot engine parts.

391 Practical hints
Where will I find...?
Where will I find...?
First aid kit
The first aid kit is in the storage compart-
ment at the front edge of the front passen-
ger seat.
1Tab
Pull tab1 upward.

Fold the covering forward.

Remove the first aid kit.
Spare wheel
The spare wheel is located under the trunk
floor.
Lift the trunk floor and engage the han-
dle in the upper edge of trunk.

Remove the luggage box (
page 395).
Minispare wheel (CLS 550 only)
1Vehicle tool kit
2Minispare wheel
3Luggage bowlRemoving the Minispare wheel

Turn luggage bowl3 counterclock-
wise.

Remove Minispare wheel2.
Storing the Minispare wheel after use

Place Minispare wheel2 in wheel
well.

Turn luggage bowl clockwise to its stop
to secure the Minispare wheel.
i
Check expiration dates and contents for
completeness at least once a year and replace
missing/expired items.
!
Always lower trunk floor before closing the
trunk.

392 Practical hintsWhere will I find...?Collapsible tire (CLS 63 AMG only)
1Vehicle tool kit
2Collapsible tire
3Electric air pump
4Storage well casingRemoving the collapsible tire

Remove storage well casing that con-
tains the vehicle tool kit and the elec-
tric air pump.
1Collapsible tire
2Tensioning strap
(vehicles with 19" collapsible tire only)
3Retaining screw
4Storage well casing base
5Tensioning strap
(vehicles with 19" collapsible tire only)

Remove storage well casing base4.

Remove retaining screw3 by turning
it counterclockwise.

Remove collapsible tire1.
Storing the collapsible tire after use
If you wish to store the collapsible tire after
use, carry out the following steps. Other-
wise, the collapsible tire may not fit the
spare wheel well.

Unscrew the valve cap from the valve
of the collapsible tire.

Take the valve extractor from the
vehicle tool kit (
page 393).

Unscrew the valve insert from the valve
and allow the air to escape.

Screw the valve insert back into the
valve.

Screw the valve cap back onto the
valve.
!
Make sure the collapsible tire is dry before
storing it.
i
It may take a few minutes for the collapsible
tire to deflate completely.