2007 MERCEDES-BENZ CLS550 fuse

ContentsReplacing bulbs ................................. 404
Bulbs ............................................ 404
Replacing bulbs for front lamps.... 407
Replacing bulbs for rear lamps ..... 409
Replacing wiper blades ...................... 410
Wiper blades ................................ 410
Flat tire .............................................. 412
Preparing the vehicle.................... 412
Mounting the spare wheel ............ 412
MOExtended system*................... 419
Battery ............................................... 420
Disconnecting the battery ............ 421
Removing the battery ................... 421
Charging and reinstalling
the battery.................................... 422
Reconnecting the battery ............. 422
Jump starting ..................................... 423
Towing the vehicle ............................. 425
Installing towing eye bolt.............. 426
Fuses ................................................. 428
Main fuse box in passenger
compartment................................ 429
Fuse box in trunk.......................... 429
Technical data................................. 431
Parts service ...................................... 432
Warranty coverage............................. 433
Loss of Service and Warranty
Information Booklet ..................... 433
Identification labels ........................... 434
Layout of poly-V-belt drive ................. 436
CLS 550 ....................................... 436
CLS 63 AMG ................................ 436
Engine................................................ 437
Rims and tires.................................... 438
Same size tires ............................. 439
Mixed size tires ............................ 441
MOExtended tires* ....................... 444
Spare wheel ................................. 445
Electrical system ............................... 447
Main dimensions and weights............ 448
Main dimensions .......................... 448
Weights ........................................ 448Fuels, coolants, lubricants etc. .......... 449
Capacities .................................... 449
Engine oils ................................... 451
Engine oil additives ...................... 451
Air conditioning refrigerant .......... 451
Brake fluid.................................... 451
Premium unleaded gasoline ......... 452
Fuel requirements ........................ 452
Gasoline additives ........................ 453
Coolants ...................................... 453
Windshield washer system and
headlamp cleaning system*......... 456
Index................................................. 457

214 Controls in detailPower tilt/sliding sunroofFully opening (Express-open) and clos-
ing (Express-close) the power tilt/slid-
ing sunroof
To open or close the tilt/sliding sun-
roof, move the sunroof switch past the
resistance point in the direction of
arrow1to2 and release.
The tilt/pop up roof opens or closes
completely.
Stopping the power tilt/sliding sunroof
during Express-operation

Move the sunroof switch in any direc-
tion.Synchronizing the power tilt/sliding
sunroof
The tilt/sliding sunroof must be synchro-
nized

after the battery has been
disconnected or discharged


after the tilt/sliding sunroof has been
closed manually (
page 400)


after a malfunction


if the tilt/sliding sunroof does not open
smoothly

Remove the respective fuse from the
main fuse box (
page 428).

Reinsert the fuse in the main fuse box.

Switch on the ignition (
page 38).

Move and hold the sunroof switch in
the direction of arrow3 until the
tilt/sliding sunroof is fully raised at the
rear.
Keep holding the sunroof switch in the
direction of arrow3 for approximately
1 second.

Check the Express-open feature
(page 214).
If the tilt/sliding sunroof opens com-
pletely, the roof is synchronized. Other-
wise repeat the above steps.
i
If the movement of the tilt/sliding sunroof is
blocked during the closing procedure, the
tilt/sliding sunroof will stop and reopen slightly.

331 Operation
Maintenance
Calling up the maintenance service indicator
You can call up the maintenance service in-
dicator display, in the multifunction dis-
play, every time, to check when the next
maintenance service is due.
Switch on the ignition (
page 38).
The standard display of the control sys-
tem appears (
page 147).

Press buttonè orÿ on the mul-
tifunction steering wheel repeatedly
until the standard display appears in
the multifunction display (
page 141).

Press buttonk or j until the
maintenance service indicator display
with the service symbol9 and the
service deadline appears in the multi-
function display.Resetting the maintenance service
indicator
In the event that the maintenance service
on your vehicle is not carried out by an au-
thorized Mercedes-Benz Center, you can
have the maintenance service indicator re-
set. The automotive maintenance facility
carrying out the maintenance service will
find the information for resetting the main-
tenance service indicator in the mainte-
nance-relevant literature for your vehicle.
Such literature is available from either your
authorized Mercedes-Benz Center or
directly from Mercedes-Benz.
i
The menu overview can be found on
(
page 145).
i
If the battery is disconnected, the days of
disconnection will not be included in the count
shown by the maintenance service indicator. To
arrive at the true maintenance service deadline,
you will need to subtract these days from the
days shown in the maintenance service indicator
message or the maintenance service indicator
display.
Do not confuse the maintenance service indica-
tor with the engine oil level indicator:.
i
If the maintenance service indicator was in-
advertently reset, have an authorized
Mercedes-Benz Center correct it.
Only reset if the proper maintenance service has
been performed. Resetting the system without
performing the proper service as called for by
the maintenance service indicator will result in
engine damage and/or other vehicle damage not
covered by the Mercedes-Benz Limited
Warranty.

335 Operation
Vehicle care
Hand-wash
Do not use hot water or wash your vehicle
in direct sunlight. 
Only use a mild car wash detergent,
such as Mercedes-Benz approved Car
Shampoo.

Thoroughly spray the vehicle with a dif-
fused jet of water.
Direct only a very weak spray towards
the ventilation intake.

Use plenty of water and rinse the
sponge and chamois frequently.

Rinse with clean water and thoroughly
dry with a chamois.
Do not allow cleaning agents to dry on
the finish.Automatic car wash
You can have your car washed in an auto-
matic car wash from the start. Automatic
car washes without brushes are prefera-
ble.

To protect the filter system, switch the
automatic climate control to air recir-
culation mode (
page 192) or
(
page 193).
If the vehicle is very dirty, prewash it be-
fore running it through the automatic car
wash.Ornamental moldings
For regular cleaning and care of ornamen-
tal moldings, use a damp cloth.
!
Do not use scouring agents on these parts.
Never apply strong force and only use a soft,
non-scratching cloth when cleaning the vehicle.
Do not attempt to wipe the surface with a dry
cloth or sponge.
Otherwise you may scratch or damage the paint.
!
Do not clean your vehicle in an automatic
touchless car wash which uses caustic spray.
Otherwise the caustic spray will damage the
paint or ornamental moldings.
!
Make sure that the windshield wiper switch
is set to 0(
page 57). Otherwise, e.g. the rain
sensor could activate and cause the wipers to
move unintentionally. This may lead to vehicle
damage.
Due to the width of the vehicle, fold in exterior
rear view mirrors prior to running the vehicle
through an automatic car wash to prevent dam-
age to the mirrors.
i
After running the vehicle through an auto-
matic car wash, wipe any wax off of the wind-
shield (
page 337). This will prevent smears
and reduce wiping noise which can be caused by
residual wax on the windshield.
When leaving the car wash, make sure that the
mirrors are folded out. Otherwise they may vi-
brate.
!
Do not use chrome cleaner on ornamental
moldings. Although ornamental moldings may
have chrome appearance, they could be made of
anodized aluminum that will be damaged when
cleaned with chrome cleaner. Instead, use a
damp cloth to clean those ornamental moldings.
For very dirty ornamental moldings of which you
are sure are chrome-plated, use a chrome clean-
er. If in doubt whether an ornamental molding is
chrome-plated, contact an authorized
Mercedes-Benz Center.

341 Practical hints
What to do if …
Where will I find...?
Unlocking/locking in an emergency
Opening/closing in an emergency
Resetting activated head restraints
Replacing SmartKey batteries
Replacing bulbs
Replacing wiper blades
Flat tire
Battery
Jump starting
Towing the vehicle
Fuses

393 Practical hints
Where will I find...?

Store the collapsible tire by carrying
out the steps described in “Removing
the collapsible tire” (
page 392) in re-
verse order.
Compressing the collapsible tire
(CLS 63 AMG with Performance Pack-
age* only)
The 19" collapsible tire must be com-
pressed with two tensioning straps before
you can store it back in the trunk.

Extend the tensioning strap by pulling
the slider.

Place tensioning strap around spare
wheel rim and collapsible tire with the
buckle facing the inside of the rim.

Close the buckle.

Pull the loose end of the tensioning
strap.
The tensioning strap must be pulled as
tight as possible.
Vehicle tool kit
The vehicle tool kit is stored in the com-
partment underneath the trunk floor
(page 391).
The vehicle tool kit includes:


One pair of universal pliers


One towing eye bolt


One wheel wrench


One alignment bolt


One fuse extractor


One collapsible wheel chock


Spare fuses
i
Vehicles with 19" collapsible tire only: Be-
fore storing the collapsible tire in trunk fasten
tensioning straps, see “Compressing the col-
lapsible tire (CLS 63 AMG with Performance
Package* only)” (
page 393).
!
Always lower trunk floor before closing the
trunk.
i
The electrical air pump is located in the stor-
age well casing (
page 392).
i
The tensioning straps are shown in red for
illustration purposes. The tensioning straps on
the spare wheel of your vehicle are black.

428 Practical hintsFusesThe electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
The following aids are available to help you
replace fuses:


Fuse chart
The fuse chart is located in the fuse box
in the passenger compartment
(page 429). The fuse chart explains
the fuse allocation and fuse amperag-
es.


Spare fuses
Spare fuses are located in the vehicle
tool kit in the trunk (
page 393).


Fuse extractor
The fuse extractor is located in the ve-
hicle tool kit in the trunk (
page 393).The electrical fuses are located in different
fuse boxes:


Main fuse box in passenger compart-
ment (
page 429)


Fuse box in trunk (
page 429)
Before replacing fuses:

Apply the parking brake (
page 59).

Make sure the gear selector lever is set
to position P (
page 171).

Turn off all electrical consumers.

Turn off the engine (
page 60).

Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door.
Warning!
G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.i
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to advise
you on this subject.

429 Practical hintsFuses
Main fuse box in passenger compartment
1CoverOpening

Open the front passenger door.

Insert flat, blunt object as a lever in into
on the edge of cover1 at the position
indicated by the arrow.

Loosen cover1 from the dashboard
using lever.

Using your hands, pull cover1 in the
direction of the arrow and remove.
Closing

Hook cover1 into the opening at the
front.

Press cover1 back on until it engag-
es.
Fuse box in trunk
2Cover
3Catches
Turn catches3 counter-clockwise
and remove cover2.
!
Do not use sharp objects such as a screw
driver to open the fuse box cover1 in the dash-
board, as this could damage it.