309 Operation
Engine compartment
For more information on engine oil, see 
“Fuels, coolants, lubricants, etc.” 
(
page 448).
For more information on messages in the 
multifunction display concerning engine 
oil, see the “Practical hints” section 
(
page 384).
Adding engine oil
1Filler cap
Unscrew filler cap1 from filler neck.
Add engine oil as required.
Be careful not to overfill with oil.
Be careful not to spill any oil when adding. 
Avoid environmental damage caused by oil 
entering the ground or water.
Screw filler cap1 back on filler neck.
More information on engine oil can be 
found in the “Technical data” section 
(
page 448) and (page 450).
Transmission fluid level
The transmission fluid level does not need 
to be checked. If you notice transmission 
fluid loss or gear shifting malfunctions, 
have an authorized Mercedes-Benz Center 
check the automatic transmission.
!Only use approved engine oils and oil filters 
required for vehicles with Maintenance System 
(U.S. vehicles) or FSS (Canada vehicles). For a 
listing of approved engine oils and oil filters, 
refer to the Factory Approved Service Products 
pamphlet in your vehicle literature portfolio, or 
contact an authorized Mercedes-Benz Center.
Using engine oils and oil filters of specification 
other than those expressly required for the 
Maintenance System (U.S. vehicles) or FSS 
(Canada vehicles), or changing of oil and oil filter 
at change intervals longer than those called for 
by the Maintenance System (U.S. vehicles) or 
FSS (Canada vehicles) will result in engine or 
emission control system damage not covered by 
the Mercedes-Benz Limited Warranty.
!Excess oil must be siphoned or drained off. 
It could cause damage to the engine and emis-
sion control system not covered by the 
Mercedes-Benz Limited Warranty. 
450 Technical data
Fuels, coolants, lubricants, etc.
Engine oils
Engine oils are specifically tested for their 
suitability in our engines and durability for 
our service intervals. Therefore, only use 
approved engine oils and oil filters re-
quired for vehicles with Maintenance 
System (U.S. vehicles) or FSS (Canada 
vehicles). For a listing of approved engine 
oils and oil filters, refer to the Factory Ap-
proved Service Products Pamphlet, or 
contact an authorized Mercedes-Benz 
Center.
Engine oil additives
Do not blend oil additives with engine oil. 
They may damage the engine.
Damage or malfunctions resulting from 
blending oil additives are not covered by 
the Mercedes-Benz Limited Warranty.
Air conditioning refrigerant
R-134a (HFC) refrigerant and special PAG 
lubricating oil are used in the air 
conditioning system.
Never use R-12 (CFC) or mineral-based 
lubricating oil. Otherwise damage to the 
system will occur.
Brake fluid
During vehicle operation, the boiling point 
of the brake fluid is continuously reduced 
through the absorption of moisture from 
the atmosphere. 
Only brake fluid approved by 
Mercedes-Benz is recommended. An 
authorized Mercedes-Benz Center will 
provide you with additional information.
!Using engine oils and oil filters of specifica-
tion other than those expressly required for the 
Maintenance System (U.S. vehicles) or FSS 
(Canada vehicles), or changing of oil and oil filter 
at change intervals longer than those called for 
by the Maintenance System (U.S. vehicles) or 
FSS (Canada vehicles) will result in engine or 
emission control system damage not covered by 
the Mercedes-Benz Limited Warranty. Please follow Maintenance System 
(U.S. vehicles) or FSS (Canada vehicles) recom-
mendations for scheduled oil changes. Failure to 
do so will result in engine or emission control 
system damage not covered by the 
Mercedes-Benz Limited Warranty.
Warning!G
Under extremely strenuous operating condi-
tions, this moisture content can lead to the 
formation of bubbles in the system, thus re-
ducing the system’s efficiency.
Therefore, the brake fluid must be replaced 
regularly. Refer to your vehicle's Mainte-
nance Booklet for replacement interval.