Page 176 of 441

175 Controls in detail
Automatic climate control
USA only (depending on vehicle production
date)
Canada only
Item
1Left side defroster vent, fixed
2Left side air vent, adjustable
3Thumbwheel for air volume control
for left side air vent
4Thumbwheel for air volume control
for left center air vent
5Left center air vent, adjustable
6Right center air vent, adjustable
7Thumbwheel for air volume control
for right center air vent
8Thumbwheel for air volume control
for right side air vent
9Right side air vent, adjustable
aRight side defroster vent, fixed
bAutomatic climate control panel
iFor draft-free ventilation, move the sliders
for the center air vents and side air vents to the
middle position.
Item
1Left side air distribution control
2Front defroster
3Temperature control, left, raising
4Display
5Air volume control, raising
6Temperature control, right, raising
7Rear window defroster
8Right side air distribution control
9Charcoal filter
aAC cooling on/off
Residual heat/ventilation
bTemperature control, right, lowering
cAir volume control, lowering
dTemperature control, left, lowering
eAir recirculation
fAutomatic climate control on/off
(complete system)
gAir distribution and air volume
(automatic mode)
Page 179 of 441

178 Controls in detail
Automatic climate control
Setting the temperature
Use temperature controls3 andd for
the left side or6 andb for the right side
(
page 175) to separately adjust the air
temperature on each side of the passenger
compartment. You should raise or lower
the temperature setting in small incre-
ments, preferably starting at 72°F (22°C).
The automatic climate control will adjust
to the set temperature as fast as possible.
Increasing
Press temperature button3
and/or6 (
page 175) until the de-
sired temperature appears in the
display4 (
page 175).
The automatic climate control system
will correspondingly adjust the interior
air temperature.Decreasing
Press temperature buttonb
and/ord (
page 175) until the de-
sired temperature appears in the
display4 (
page 175).
The automatic climate control system
will correspondingly adjust the interior
air temperature.
Adjusting air distribution
Use air distribution controls1 and8
(
page 175) to separately adjust the air
distribution on each side of the passenger
compartment. The following symbols are
found on the controls:
Turn air distribution control1 or8
(
page 175) to the desired symbol.
The indicator lamp on the buttonU
(
page 175) goes out.
iIf you increase the temperature for one side
of the vehicle to the highest adjustable value
then you will see the message
HI in the display.
This also increases the temperature for the other
side of the vehicle.
iIf you decrease the temperature for one side
of the vehicle to the lowest adjustable value then
you will see the message
LO in the display. This
also decreases the temperature for the other
side of the vehicle.
SymbolFunction
aDirects air through the center,
side and rear passenger
compartment air vents
ZDirects air to the windshield
and the side defroster vents
bDirects air into the entire
vehicle interior
YDirects air to the footwells
Page 181 of 441
180 Controls in detail
Automatic climate control
Deactivating
Press buttonP or 0
(
page 175) again.
The indicator lamp on the button goes
out.
The previous settings are once again in
effect.Windshield fogged on the outside
Switch the windshield wipers on
(
page 51).
If the automatic mode of the automatic cli-
mate control is switched off:
Turn air distribution control1 or8
toa orY (
page 175).
Maximum cooling MAXCOOL
If the left and right air distribution controls
as well as the airflow volume control are
set toU (
page 175) and there is a
high need for cooling, the display
“MAXCOOL” appears.
This provides the fastest possible cooling
of the vehicle interior (when side windows
and tilt/sliding sunroof* are closed).
iIf you have switched on the defrost function
using thePor0 button, you cannot
make any other settings.
iThe cooling remains switched on.
iKeep this setting selected only until the
windshield is clear again.
Page 189 of 441
188 Controls in detail
Audio system
Operating and display elements
Page 190 of 441
189 Controls in detail
Audio system
ItemPage
1CD changer mode selector
AUX mode selector201
193
2Single CD mode selector 204
3Radio mode selector
4Mute function (radio)196
Pause (CD)208
5Volume distribution192
6Sound settings191
7Display
8Alphanumeric keypad
ItemPage
9Speed dialing memory
(telephone) in descending
order
aAccepting a call
(telephone)212
bTelephone mode selector208
cSpeed dialing memory
(telephone) in ascending
order210
dTerminating a call
(telephone)213
eCD slot
fCD ejection204
ItemPage
gSoft keys190
hVolume190
jSwitching on/off190
kManual tuning/seek tuning
(radio)195
Track search, reverse (CD)207
lManual tuning/seek tuning
(radio)195
Track search,
fast forward (CD)207
Page 191 of 441

190 Controls in detail
Audio system
Button and soft key operation
In these instructions, the alphanumeric
keypad (right side of radio panel) and the
function buttons (left side of radio panel)
are referred to as “buttons”. The four keys
below the display panel are referred to as
“soft keys”.Operation
Switching the unit on/off
Switching on
Turn the SmartKey in the starter switch
to position1 or2.
If the audio system was on as you
removed the SmartKey from the starter
switch, the audio system will
automatically come back on as you
turn the SmartKey to position1 or2.
or
Press M button.Switching off
Remove SmartKey from starter switch.
or
Press M button.
Adjusting the volume
Turn rotary control of N button.
The volume will increase or decrease
depending on the direction turned.
!Do not press directly in the display face.
Otherwise, the display will be damaged.
iIf the radio is switched on without the Smart-
Key in the starter switch, it will automatically
switch off again after approx. 30 minutes.
If your vehicle is equipped with a telephone, the
display may prompt you to enter your PIN (GSM
network) or code (TDMA or CDMA network).
iShould excessively high temperatures occur
while the audio system is being operated, the
display will dim. If temperatures continue to rise,
HIGH TEMP will appear in the display, after which
the audio system will be switched off for a
cooling-down period.
iIf your vehicle equipment includes a Mer-
cedes-Benz specified mobile telephone*, you
can adjust its volume separately from the volume
of the audio system while the telephone is being
used.
Page 192 of 441

191 Controls in detail
Audio system
Adjusting sound functions
The bass and treble functions are called up
by pressing the O button.
Settings for bass and treble are stored
separately for the AM and FM wavebands,
weather band, CD mode and telephone
mode.
Bass
Press O button repeatedly until
BASS appears in the display.
Press + or– soft key to increase or
decrease tone level accordingly.
or
Press RES soft key briefly to reset bass
tones to their center level.The radio switches back to the
standard radio menu 8 seconds after
the last soft key is pressed.
Adjusting treble
Press O button repeatedly until
TREBLE appears in the display.
Press + or– soft key to increase or
decrease tone level accordingly.
or
Press RES soft key briefly to reset treble
tones to their center level.
The radio switches back to the
standard radio menu 8 seconds after
the last soft key is pressed.Sound system*
You can either program the sound settings
manually (
page 191) or choose settings
via preset sound characteristics.
You can select from among the following
settings:
STANDARD: conventional stereo sound.
SURROUND: the sound is set for better
three-dimensional acoustic character-
istics.
SPEECH: the sound is optimized for the
spoken word.
Press O button repeatedly until
STANDARD, SURROUND, or SPEECH appears
in the display.
Press X or Y soft key repeatedly
until the desired sound setting has
been reached.
The sound is set accordingly.
or
Page 193 of 441

192 Controls in detail
Audio system
Press RES soft key briefly.
The sound setting is reset depending
on the sound source activated.
Radio mode: STANDARD
CD/AUX mode: SURROUND
Telephone: SPEECH
The radio switches back to the
standard radio menu 8 seconds after
the last soft key is pressed.
Returning sound functions to factory
settings
Press O button to call up settings
menu in the display.
Press RES soft key briefly; the respec-
tive sound function is reset to its center
level.
or
Press and hold RES soft key until RESET
appears in the display.
The sound settings for bass and treble
are returned to their center level and
the volume is set to a predefined level.
Vehicles with sound system*:
The sound setting is reset depending
on the sound source activated.
Radio mode: STANDARD
CD/AUX mode: SURROUND
Telephone: SPEECH
The radio switches back to the
standard radio menu 4 seconds
after the last soft key is pressed.
Adjusting volume distribution
Call up fader and balance functions by
pressing the P button.Fader
Press P button repeatedly until
FADER appears in the display.
Press V or W soft key.
The volume is distributed accordingly
between the front and rear of the
vehicle.
or
Press RES soft key briefly.
The fader is reset to its center level.
The radio switches back to the
standard radio menu 8 seconds after
the last soft key is pressed.