Flat tyre
321
X
Using the wheel wrench, loosen the wheel
bolts on the wheel you wish to change by
about one full turn. Do not unscrew the
bolts completely. G
Risk of accident
If you fail to position the jack correctly, the
vehicle may :
R slip off the jack
R injure you or others
R be damaged
It is thus important to ensure that the jack
is positioned correctly in the respective
jacking points. Before positioning the jack ,
remove any dirt that may have collected in
the jacking points.
The jacking points for the jack are located
behind the wheel housings of the front wheels
and in front of the wheel housings of the rear
wheels (arrows). 1
Jacking poin t
2 Jack
X Position jack 2at jacking point 1. X
Make sure that the base of the jack is posi-
tioned directly under the jacking point.
X Turn the crank until the tyre is raised a
maximum of 3 cm from the ground .
X Unscrew the wheel bolts.
! Do not place wheel bolts in sand or on a
dirty surface. This could cause damage to
the bolt and wheel hub threads.
X Remove the wheel.
Fitting a new wheel G
Risk of accident
Replace damaged or corroded wheel bolts.
Never oil or grease wheel bolts. Practical advice
204_AKB; 2; 3, en-G
B
mkalafa , 2007-06-26T23:11:51+02:00 - Seite 321
