2007 Lancia Musa change time

AUTOMATIC OPERATION (AUTO)
For engaging/disengaging the automatic operating mode (AUTO),
move lever A to A/M: automatic mode activation is indicated by
message AUTO and gear engaged on the display (see figure).
With AUTO mode active, the system decides to change gear
depending on car speed, engine rpm and how the accelerator pedal is
pressed. It is however possible to change gears with the control lever
without deactivating the automatic mode: this function called “gear
advice” suspends the automatic mode for the time required to change
gear.
194
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D1243g
L0D0333m
L0D0332m

220
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
Warning
light on
dialMessage on
multifunction
display
m
d
GLOW PLUGS (Multijet versions)
Turning the ignition key to MAR, the warning light on the dial comes
on and goes off when glow plugs reach the preset temperature. Start
the engine immediately after warning light switching off.
IMPORTANT With high ambient temperature, warning light stays on
for very short time. amber
amber
ASR - Wheel Antiskid System (amber)
Messages are displayed when the ASR function is
activated/deactivated manually.
ASR system switching off is indicated by the switching on of the ASR
button led.
BRAKE PAD WEAR (where provided)
The warning light on the dial turns on if the front brake pads are
worn; in this case have them changed as soon as possible.
On certain versions the dedicated message is displayed.

262
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
WARNING
The jack should only be used to change a wheel on the car for which it was
designed. It should not be put to other uses or employed to raise other models of
cars. Under no circumstances should it be used when carrying out repairs under
the car. An incorrectly positioned jack may cause the car to fall.
Do not use the jack to lift loads exceeding that indicated on the label attached to
the jack itself.
Do not fit snow chains on a space-saver spare wheel.
If a front wheel (drive wheel) is punctured and you require snow chains to
proceed, take a standard wheel from the rear axle and fit the space-saver spare
wheel in its place.
Having fitted two standard wheels on the front drive axle you can use snow
chains, thus solving the emergency situation.
WARNING
When driving with a space-saver spare wheel fitted, the driving performance of
your car may change. Avoid accelerating or braking suddenly, steering abruptly
or fast cornering.
The lifespan of a space-saver spare wheel is approximately 3000 km, after which
it will need to be replaced with another spare wheel of the same type. Never fit a
standard tyre on the space-saver spare wheel rim.
Have the wheel replaced and refitted as soon as possible. Never use two or more
spare wheels at the same time. Do not lubricate the bolt threads before fitting
them back: they could come loose.
WARNING
Fasten the wheel cap correctly to prevent the wheel from coming free in motion.
Never tamper with the inflation valve.
Never place tools between the rim and tyre. Check the tyre and space-saver spare
wheel pressure regularly. The tyre inflation pressure is shown in the “Technical
specifications” chapter.

265
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
❒Warn anybody nearby that the car is about to be lifted. They must
stay clear and not touch the vehicle until it is back on the ground;
❒Fit the handle L to operate the jack and lift the car until the wheel
to be changed is several centimetres off the ground;
❒For versions with wheel cap, remove the wheel cap after unloosing
the three fastening bolts and finally unloose the fourth bolt and
extract the wheel;
❒For versions with press-fit wheel cap, remove it with care to
prevent damages;
❒Make sure the contact surfaces between spare wheel and hub are
clean so that the fastening bolts will not come loose;
L0D0164m

293
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
Thousands of km
Check and adjust handbrake lever stroke
Check exhaust emissions/smoke
(1.3 Multijet and 1.9 Multijet versions)
Check exhaust emissions (petrol versions)
Check antievaporation system (petrol versions)
Change fuel filter cartridge (“green filter”) (diesel versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (1.9 Multijet versions) (❏)
Top up fluids
(engine coolant, brakes, windscreen washer, battery, DFN etc.)
Check timing belt conditions (■)
Replace timing belt (*) (■)
Change spark plugs (petrol versions)
Check engine control system operation
(through diagnosis socket)
Change engine oil and oil filter (❏)
Change engine oil and oil filter (Multijet version with DPF) (**)
Change brake fluid (or every 2 years)
Change pollen filter (or every year)
(*) Or every 4 years for particularly demanding use:
- cold/hot climates;
- driving in the city idling for a long time;
- dusty roads or roads covered with sand and/or salt
Or every 5 years, regardless of the km covered and conditions of use.
(**) Engine oil and oil filter shall be changed when the corresponding warning light turns on (see section “Warning lights and Messages”),
or in any case every 2 years.
(
❏) Every 30.000 km for 1.3 Multijet versions
(
■) Excluding 1.3 Multijet versions
20 40 60 80 100 120 140 160 180
●● ● ●
●● ● ●
●● ● ●
●●
●●●
●●●
●●●●● ●●●●
●●●●● ●●●●
●●
●
●● ● ●
●● ● ●
●●●●● ●●●●
(●)(●)(●)(●)(●)(●)(●)(●)(●)
●●●
●●●●● ●●●●