2007 JEEP WRANGLER radio

The Security Alarm System is designed to protect your
vehicle; however, you can create conditions where the
system will arm unexpectedly. If you remain in the
vehicle and lock the doors with the transmitter, once the
system is armed (after 16 seconds), when you pull the
door handle to exit the alarm will sound. If this occurs,
press the “Unlock” button on the remote keyless entry
transmitter to disarm the system. You may also acciden-
tally disarm the system by unlocking the driver’s door
with the key and then locking it. The door will be locked
but the Security Alarm will not arm.
ILLUMINATED ENTRY
The interior lights will come on when you open any door.
The lights will remain on after all of the doors are closed,
and then fade to off or they will immediately fade to off
once the ignition switch is turned on.
REMOTE KEYLESS ENTRY — IF EQUIPPED
This system allows you to lock or unlock the doors and
swing gate or activate the panic alarm from distances a
maximum of 66 feet (20 meters) using a hand held radio
transmitter. The transmitter need not be pointed at the
vehicle to activate the system.
Three Button Transmitter
20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

2. While the “Lock” button is pressed (after 4 seconds),
press the PANIC button. Release both buttons.
The “Sound Horn On Lock” feature can be reactivated by
repeating this procedure.
Using The Panic Alarm
To turn the panic alarm feature ON or OFF, press and
hold the PANIC button on the transmitter for at least one
second and release. When the panic alarm is on, the
headlights and park lights will flash, the horn will pulse
on and off and the interior lights will turn on.
The panic alarm will stay on for 3 minutes unless you
turn it off by pressing the PANIC button a second time or
if the vehicle speed is 5 mph (8 km/h) or greater.
NOTE:When you turn off the panic alarm by pressing
the PANIC button a second time, you may have to be
closer to the vehicle due to the radio frequency noises of
the system.
To Turn Off “Flash Lights With Lock”
NOTE:The Flash Lights With Lock feature can be
turned on or off by performing the following steps:
1. Press the “Unlock” button for 4 to 10 seconds.
2. While the “Unlock” button is pressed, (after 4 seconds)
press the “Lock” button. Release both buttons.
3. Test the flash lamps with LOCK feature while outside
of the vehicle, by pressing the “Lock” button on the key
fob with the ignition in the LOCK position, and the key
removed.
NOTE:Pressing the “Lock” button on the key fob, while
you are in the vehicle, will activate the Security Alarm.
Opening a door with the Security Alarm activated will
cause the alarm to sound. Press the “Unlock” button to
deactivate the Security Alarm.
22 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

11. A single chime will be heard.
12. Repeat steps 8 through 10 to program up to six
additional fobs.
13. Turn the ignition to the OFF position.
14. Your vehicle will remain in program mode up to 60
seconds from when the original chime was heard. After
60 seconds, all programmed fobs function normally.
NOTE:If you do not have a programmed transmitter,
contact your dealer for details.
General Information
This device complies with part 15 of FCC rules and with
RS-210 of Industry Canada. Operation is subject to the
following conditions:
1. This device may not cause harmful interference.2. This device must accept any interference that may be
received including interference that may cause undesired
operation.
NOTE:Changes or modifications not expressly ap-
proved by the party responsible for compliance could
void the user’s authority to operate the equipment.
If your Remote Lock Control fails to operate from a
normal distance, check for these two conditions.
1. Weak batteries in transmitter. The expected life of
batteries is five years.
2. Closeness to a radio transmitter such as a radio station
tower, airport transmitter, military base, and some mobile
or CB radios.
24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

WINDOWS
Power Windows — If Equipped
The power window switches are located on the instru-
ment panel center stack (below the radio). The top left
switch controls the left front window and the top right
switch controls the right front window. The lower left
switch controls the left rear passenger window (4 door
models), and the lower right switch controls the right
rear passenger window (4 door models). The switches
will continue to function for up to 10 minutes after the
ignition key has been removed, or until a door is opened.
Power Window Switches
32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

When a door is open and the interior lights are on,
rotating the dimmer control all the way down to the OFF
detent will cause all the interior lights to go out. This is
also known as thePartymode because it allows the
doors to stay open for extended periods of time without
discharging the vehicle’s battery.Daytime Brightness Feature
Certain instrument panel components (odometer, radio
display) can be illuminated at full brightness during the
daytime. This can be helpful when driving with your
headlights on during the daytime such as in a parade or
a funeral procession. To activate this feature, rotate the
left stalk one detent lower than the dome light.
Multi-Function Control Lever
The multi-function control lever controls the operation of
the parking lights, headlights, headlight beam selection,
passing light, fog lights, instrument panel light dimming,
and turn signals.
Rear Cargo Lamp (4 Door Only)
98 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

UNDERSTANDING YOUR INSTRUMENT PANEL
CONTENTS
Instrument Panel And Controls.............200
Instrument Cluster......................201
Instrument Cluster Description.............202
Compass And Trip Computer — If Equipped . . . 211
▫Control Buttons......................211
▫Trip Conditions.......................212
▫Compass Temperature Display............213
Radio General Information................216
▫Radio Broadcast Signals.................216▫Two Types Of Signals..................216
▫Electrical Disturbances..................216
▫AM Reception.......................216
▫FM Reception........................217
Sales Code REQ — AM/FM Stereo Radio
And 6–Disc CD/DVD Changer
(MP3/WMA Aux Jack)...................217
▫Operating Instructions - Radio Mode.......217
▫Operation Instructions - (Disc Mode For CD
And MP3/WMA Audio Play, DVD-Video)....2264

▫Notes On Playing MP3/WMA Files........228
▫List Button (Disc Mode For MP3/WMA
Play)..............................230
▫Info Button (Disc Mode For MP3/WMA
Play)..............................231
Sales Code RES — AM/FM Stereo Radio
With CD Player (MP3 Aux Jack)............233
▫Operating Instructions - Radio Mode.......233
▫Operation Instructions - CD Mode For CD
And MP3 Audio Play..................239
▫Notes On Playing MP3 Files.............241
▫List Button (CD Mode For MP3 Play).......244
▫Info Button (CD Mode For MP3 Play).......244
Sales Code RER — AM/FM/CD/DVD Radio
With Navigation System — If Equipped.......245▫Operating Instructions — Satellite Radio.....246
▫Clock Setting Procedure.................246
Satellite Radio — If Equipped..............247
▫System Activation.....................247
▫Electronic Serial Number/Sirius Identification
Number (ENS/SID)....................248
▫Selecting Satellite Mode (RSC Radios).......248
▫Satellite Antenna......................248
▫Reception Quality.....................248
▫Operating Instructions - Satellite Mode......249
▫Operating Instructions - Hands Free Phone
(If Equipped)........................251
▫Operating Instructions - Video Entertainment
System (VES) (If Equipped).............251
198 UNDERSTANDING YOUR INSTRUMENT PANEL

CD/DVD Disc Maintenance...............251
Radio Operation And Cellular Phones........252
Climate Controls.......................252
▫Manual Heater Only...................252▫Manual Air Conditioning And Heating
System — If Equipped..................254
▫Operating Tips.......................258
UNDERSTANDING YOUR INSTRUMENT PANEL 199
4