µIf the driver’s
window senses any obstacle while it
is closing automatically, it will
reverse direction, and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it. Start the engine. Push down and
hold the driver’s window switch
until the window is f ully open.
Pull and hold the driver’s window
switch to close the window
completely, then hold the switch
f or about 2 seconds.If the power windows do not operate
properly af ter resetting, have your
vehicle checked by your dealer.
If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window f use is removed, the
AUTO f unction will be disabled. The
power window system needs to be
reset af ter reconnecting the battery
or installing the f use.
1.
2.
Power Windows
AUTO REVERSE
Inst rument s and Cont rols
95
If you lose the card, you must obtain
the code number f rom a dealer. To
do this, you will need the system’s
serial number. Your vehicle’s audio system will
disable itself if it is disconnected
f rom electrical power f or any reason.
To make it work again, you must
enter a specif ic f ive-digit code in the
preset buttons. Because there are
hundreds of number combinations
possible f rom f ive-digits, making the
system work without knowing the
exact code is nearly impossible.
Youshouldhavereceivedacardthat
lists your audio system code number
and serial number. It is best to store
this card in a saf e place at home. In
addition, you should write the audio
system’s serial number in this owner’s
manual.You will have to store your favorite
stations in the preset buttons after
the system begins working. Your
original settings were lost when the
power was disconnected.
If your vehicle’s battery is
disconnected or goes dead, or the
radio f use is removed, the audio
system will disable itself . If this
happens, you will see ‘‘ENTER
CODE’’ in the f requency display the
nexttimeyouturnonthesystem.
Use the preset buttons (icons on
vehicles with navigation system) to
enter the code. The code is on the
radio code card included in your
owner’s manual kit. When it is
entered correctly, the radio will start
playing.
If you make a mistake entering the
code, do not start over; complete the
sequence, then enter the correct
code. You have ten tries to enter the
correct code. If you are unsuccessf ul
in ten attempts, you must then leave
the system on f or 1 hour bef ore
trying again.
On EX and EX-L models
Radio T hef t Protection
Features
139
µ
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor f or that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
HomeLink stores the code in a
permanent memory. There should
be no need to retrain HomeLink if
your vehicle’s battery goes dead or is
disconnected. The HomeLinkuniversal
transceiver built into your vehicle
canbeprogrammedtooperateupto
three remotely controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
If your garage door opener was
manuf actured bef ore April 1982, you
may not be able to program
HomeLink to operate it. They do not have the safety feature that causes
the motor to stop and reverse if an
obstacle is detected during closing,
increasing the risk of injury.
Always ref er to the opening
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with HomeLink. If
you do not have this inf ormation,
contact the manuf acturer of the
equipment.
For quick and accurate training,
make sure the remote transmitter
for the device (garage door,
automatic gate, security system, etc.)
has a fresh battery.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the first button. To do this,
press and hold the two outside
buttons on the HomeLink
transceiver fo r about 25 seconds,
until the red indicator f lashes.
Release the buttons, then proceed to
step 1.
If you are training the second or
third buttons, go directly to step 1.
Unplug the garage door opener
motor f rom the electrical outlet.
Holdtheendof thegaragedoor
opener remote transmitter 2 to 5
inches f rom HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink.
1.
2.
If equipped
CONT INUED
General Inf ormation T raining HomeL ink
Important Saf ety Precautions
Bef ore you begin
HomeL ink Universal Transceiver
Features
181
If your vehicle’s battery has been
disconnected or gone dead, these
codes are erased. It takes at least
three days of driving under various
conditions to set the codes again.
To check if they are set, turn the
ignition switch to the ON (II)
position without starting the engine.
The malfunction indicator lamp will
come on for 20 seconds. If it then
goes off, the readiness codes are set.
If it blinks 5 times, the readiness
codes are not set. If possible, do not
take your vehicle for a state
emissions test until the readiness
codes are set. Refer to
for more
info rmation (see page ).
If
this indicator comes on
while driving, it means one
of the engine’s emission control
systems may have a problem. Even
though you may feel no difference in
your vehicle’s performance,
continued operation may cause
serious damage.
If you have recently refueled your
vehicle, the indicator coming on
could be due to a loose or missing
fu el fill cap. You will also see a
‘‘CHECK FUEL CAP’’ message on
the information display. Tighten the
cap until it clicks at least once (see
page ). Tightening the cap will
not turn the indicator of f
immediately; it takes at least three
days of normal driving.
If the indicator remains on or the
f uel cap was not loose or missing,
have the vehicle checked by the
dealer as soon as possible. If the malf unction indicator lamp
comes on along with the ‘‘D’’
indicator, there is a problem in the
automatic transmission control
system.
Your vehicle has certain ‘‘readiness
codes’’ that are part of the on-board
diagnostics f or the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed.
298
187
State
Emissions T esting
Readiness Codes
Malf unction Indicator L amp
T aking Care of t he Unexpect ed
277
If you keep driving with the
malf unction indicator lamp on, you can
damage your vehicle’s emissions
controls and the engine. Those repairs
may not be covered by your vehicle’s
warranties.
If you take your vehicle f or a state
emissions test shortly af ter the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the on-
board diagnostics f or the emissions
systems. These codes are erased
when the battery is disconnected,
and set again only after several days
of driving under a variety of
conditions.
If the testing f acility determines that
the readiness codes are not set, you
will be requested to return at a later
date to complete the test. If you must
get the vehicle retested within the
next two or three days, you can
condition the vehicle f or retesting by
doing the f ollowing.Make sure the gas tank is nearly,
but not completely, f ull (around
3/4).
Without touching the accelerator
pedal, start the engine, and let it
idle f or 20 seconds.
Keep the vehicle in Park. Increase
the engine speed to 2,000 rpm, and
hold it there until the temperature
gauge rises to at least 1/4 of the
scale (about 3 minutes).
Select a nearby lightly traveled
major highway where you can
maintain a speed of 50 to 60 mph
(80to97km/h)foratleast20
minutes. Drive on the highway in
D. Do not use the cruise control.
When traffic allows, drive for 90
seconds without moving the
accelerator pedal. (Vehicle speed
may vary slightly; this is okay.) If
you cannot do this f or a
continuous 90 seconds because of
traf f ic conditions, drive f or at least
30 seconds, then repeat it two
more times (for a total of 90
seconds).
Make sure the vehicle has been
parked with the engine of f f or 6
hours or more.
Make sure the ambient
temperature is between 40° and
95°F.
T esting of Readiness Codes
State Emissions T esting
298
........................
Certif ication Label .286
............................................
Chains .261
....................
Changing a Flat Tire .267
Change Oil
........................................
How to .240
......................................
When to .229
...
Charging System Indicator . 62, 276
............
Checklist, Bef ore Driving .198
..................
Childproof Door Locks .83
Child Seats
.........................................
LATCH .47
..........
Tether Anchorage Points .51
...............
Climate Control System .112
.........................
Clock, Setting the .140
.....................
Code, Audio System .139
........................
CO in the Exhaust .295
............
Cold Weather, Starting in .199
......................
Compact Spare Tire .266
...................
Console Compartment .99
.................
Consumer Inf ormation .302
.............
Controls, Instruments and .59
Coolant
........................................
Adding .242
....................................
Checking .190
.........................
Proper Solution .242
...................
Temperature Gauge .71 ...................
Conversation Mirror .100
Crankcase Emissions Control
........................................
System .295
............
Cruise Control Operation .175
....
Customer Service Inf ormation .302
..............................
Economy, Fuel .190
............
Emergencies on the Road .265
.............
Battery, Jump Starting . 272
...........
Brake System Indicator . 278
................
Changing a Flat Tire . 267
.....
Charging System Indicator . 276
..................
Checking the Fuses . 279
.....
Low Oil Pressure Indicator . 276
...
Malf unction Indicator Lamp . 277
..................
Overheated Engine . 274
...........................
Emergency Brake .97
......................
Emergency Flashers .77
......................
Emergency Towing .279
.......................
Emissions Controls .295
.............
Emissions Testing, State . 298
...............
DANGER, Explanation of . iii
...................................
Dashboard . 4, 60
................
Daytime Running Lights . 76
Daytime Running Lights .......................................
Indicator .67
.................................
Dead Battery .272
............
Def ects, Reporting Saf ety . 304
................
Def ogger, Rear Window . 77
......
Defrosting the Windows . 108, 110
....................................
Dimensions .288
...............
Dimming the Headlights . 75
Dipstick ..........
Automatic Transmission . 244
..................................
Engine Oil .189
....................
Directional Signals . 66,75
........
Disc Brake Wear Indicators . 209
.....................
Disposal of Used Oil .241 Doors
..............
Locking and Unlocking . 82
..........
DOT Tire Quality Grading . 290
...........
Driver and Passenger Safety . 7
...........................................
Driving .197
....................................
Economy .190
...................................
DVD Player .142
........
DVD Player Error Message . 171
Index
D
E
II
CONT INUED
...............................
Signaling Turns .75
.....................................
Snow Tires .261
................................
Sound System .115
Spare Tire
......................................
Inf lating .266
............................
Specif ications .289
....................
Specif ications Charts .288
................................
Speed Control .175
..........
SRS, Additional Inf ormation .25
...
Additional Safety Precautions .37
.............................
Airbag Service .36
How the Side Airbag Of f
........................
Indicator Work .34
..
How the SRS Indicator Works .33
How Your Front Airbags
.........................................
Work .28
...
How Your Side Airbags Work .31
........................
SRS Components .25
.............................
SRS Indicator . 33, 63
....
START (Ignition Key Position) .81
.......................
Starting the Engine .199
In Cold Weather at High ..................................
Altitude .199
................
With a Dead Battery .272
..............
State Emissions Testing .298
........
Steam Coming f rom Engine .274 Steering Wheel
..................................
Adjustment .78
.............
Anti-theft Column Lock .81
...............................
Buttons . 138, 175
...................
Stereo Sound System .115
....................
Storing Your Vehicle .263
........................
Sunglasses Holder .100
........................................
Sun Visor .101
Supplemental Restraint System
......................................
Servicing .36
.........................
SRS Indicator .33,63
...................
System Components .25
..................................
Synthetic Oil .240
......
Taillights, Changing Bulbs in .252
.
Taking Care of the Unexpected .265
Technical Descriptions
......
DOT Tire Quality Grading .290
.....
Emissions Control Systems .295
..........
State Emissions Testing .298
Three Way Catalytic
...............................
Converter .297
.......................
Temperature Gauge .71
........
Temperature, Inside Sensor .114 ....................
Temperature, Outside .71
...................
Tensioners, Seat Belts .23
........
Testing of Readiness Codes .298
..............
Tether Anchorage Points .51
............................
Thef t Protection .139
..
Three Way Catalytic Converter .297
..........................
Time, Setting the .140
..................
Tilt the Steering Wheel .78
....................................
Timing Belt .245
....................................
Tire Chains .261
.........
Tire, How to Change a Flat .267
Tire Pressure Monitoring
........................
System (TPMS) .205
Index
INDEX
T
VII