2007 HONDA CIVIC SEDAN Owner's Manual (in English)

µ
µ
µ
µ If the f ront wheels are turned, the
anti-thef t lock may make it dif f icult
to turn the key. Firmly turn the
steering wheel to the lef t or right as
you turn the key.
You can
operate the audio system and the
accessory power sockets in this
position.
This is the normal key
position when driving. Several of the
indicators on the instrument panel
come on as a test when you turn the
ignition switch f rom the
ACCESSORY (I) to the ON (II)
position.
Use this position
only to start the engine. The switch
returns to the ON (II) position when
you let go of the key.
You can insert or
remove the key only in this position.
To turn the key, push it in slightly. If
your vehicle has an automatic
transmission, the shif t lever must
also be in park. The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Immobilizer System, Ignition Switch
A CCESSORY (I)
ON (II)
ST A RT (III)
Ignition Switch
LOCK (0)
78

Each door has a lock tab next to the
inside door handle. Pull the tab out
to lock the door, and push it in to
unlock the door.To lock any passenger’s door when
getting out of the vehicle, pull the
lock tab out, and close the door. To
lock the driver’s door, pull and hold
the outside door handle, then pull
the lock tab out. Release the handle,
then close the door.
You will hear a reminder beeper if
you leave the key in the LOCK (0) or
the ACCESSORY (I) position and
open the driver’s door. Remove the
key to turn of f the beeper.
If your vehicle has an automatic
transmission, the shif t lever must be
in Park bef ore you can remove the
key f rom the ignition switch.
On DX models
Ignit ion Swit ch, Door L ocks
Door L ocks
Inst rument s and Cont rols
79
LOCK TAB
To lock
To unlock
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control of the
vehicle.
Remove the key from the
ignition switch only when
parked.

To lock the passenger’s door when
getting out of the vehicle, pull out
the lock tab and close the door. To
lock the driver’s door, remove the
key f rom the ignition switch and pull
out the lock tab or push the top of
the master switch, then close the
door. The lock tab on the passenger’s door
locks and unlocks only that door.
Pushing in the driver’s door lock tab
only unlocks the driver’s door.
To lock the doors, push the top of
the master door lock switch on
either f ront door, pull out the lock
tabonthedriver’sdoor,orusethe
keyintheoutsidelockonthedriver’s
door. To unlock only the driver’s door
f rom the outside, turn the key and
release it. If you turn it again, all
doors unlock.
With any door open and the key in
the ignition, both master door lock
switches are disabled. They are not
disabled when all the doors are
closed, or when the key is not in the
ignition.
Pushing the bottom of either master
door lock switch unlocks all doors. The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position, the door
cannot be opened f rom the inside
regardless of the position of the lock
tab. To open the door, push the lock
tab in, and use the outside door
handle.
If equipped
Door L ocks
L ockout Prevent ion
Power Door L ocks
Childproof Door L ocks
80
MASTER DOOR LOCK SWITCH
To lock
To unlock LEVER
LockUnlock

CONT INUED
On all mo
dels except DX
Your ve h

icle has customizable
settings f or the doors to
automatically lock and unlock. Make
all settings bef ore you start driving. In addition to normal locking
functions, all doors can be set to lock
automatically in two modes for
automatic transmission vehicles
Door L ocks
A uto Door L ocking/Unlocking
A uto Door L ock Modes
Inst rument s and Cont rols
81
(Park Lock mode or Drive Lock mode)
and one mode for manual transmission
vehicles (Drive Lock mode). The
default setting from the factory is all
doors lock in Drive Lock mode. To
program modes, refer to the following
instructions.
Apply the parking brake.
Move the shift lever to P, and close
the driver’s door.
Turn the ignition switch to the
ON (II) position.
1.
2.
3.
(automatic transmission vehicles only).
To program the Park Lock mode:
Locks all doors when the shift lever is moved out of t he Park (P) position

Release the switch and, within 5
seconds, turn the ignition switch
to the ACCESSORY (I) position.
On A/T vehicles, move the shift
lever to the P position.
Turn the ignition switch to the
LOCK (0) position.
5.
6.
Door L ocks
82
master door lock switch on the
driver’s door. You will hear a click. Keep holding the switch until you
hear another click (after about 5 seconds). Push and hold the front of the
4.Locks all doors when the vehi cl e's speed
reaches about 9 mph (15 km/h).
Apply the parking brake.
On A/T vehicles, push and hold
the brake pedal, and move the
shift lever out of P.
1.
3.
To program the Drive Lock mode:
A/T models
Turn the ignition switch to the ON
(II) position, and close the driver’s
door.
2.
Pushandholdthe
front of the
master door lock switch on the
driver' s door. You will hear a
click. Keep holding the switch
until you hear another click (after
about 5 seconds).
Release the switch and, within 5
seconds, turn the ignition switch
to the LOCK (0) position.
4.
5.

The driver’s door or all doors can be
set to unlock automatically in two
CONT INUED
Door L ocks
A uto Door Unlock Modes
Inst rument s and Cont rols
83
modes for automatic transmissionvehicles (Park Unlock mode or
Ignition Switch Unlock mode) and
one mode for manual transmission
vehicles (Ignition Switch Unlock
mode). The default setting from the
factory is the driver’s door unlocks in
Park Unlock mode (A/T) or IgnitionSwitch Unlock mode (M/T). To
program modes, refer to the following
instructions.
Apply the parking brake.
Turn the ignition switch to the ON
(II) position, and open the driver’s
door.
On A/T vehicles, move the shift
lever to P.
1.
2.
3.
To turn off the Auto Door Lock
modes:Push and hold the front of the
master door lock switch on the
driver' s door until you hear a
click (af ter about 5 seconds).
Release the switch and, within
5 seconds, turn the ignition
switch to the LOCK (0) position.
4.
5.

Apply the parking brake.
Turn the ignition switch to the ON
(II) position, and close the driver’s
door.
1.
2.
Unlocks the driver’s door or all doors
when the i gnition switch is moved out of the ON (II) position.
Door L ocks
To program the Ignition SwitchUnlock mode:
84
A/T models
Move the shift lever to P, and close
the driver’s door.
Turn the ignition switch to the ON
(II) position. Apply the parking brake.
1.
2.
3.
To program the Park Unlock mode:
Unlocks the driver’s door or all doorsWhen the shift lever is moved into thePark (P) position (automatic
transmission vehicles only).
• U ntil you hear another click (after about 5 seconds) to activate
driver's door unlock, or
• U ntil you hear two more clicks
(af ter about 10 seconds) to
activate all doors unlock .
Release the switch and, within 5
seconds, turn the ignition switch
to the LOCK (0) position. Pushandholdtherearof the
master door lock switch on the
driver' s door. You will hear a
click. Continue to hold the switch:
4.
5.

CONT INUED
Door L ocks
Inst rument s and Cont rols
85
On A/T vehicles, push and hold
the brake pedal, then move the
shift lever out of P.
Pushandholdtherearof the
master door lock switch on the
driver’ s door. You will hear a
click. Continue to hold the switch:
• Until you hear another click
(after about 5 seconds) to
activate driver's door unlock, or
• U ntil you hear two more clicks
(af ter about 10 seconds) to
activate all doors unlock .
Release the switch and, within 5
seconds, turn the ignition switch
to the ACCESSORY (I) position.
On A/T vehicles, move the shift
lever to P.
3.
4.
5.
Turn the ignition switch to the
LOCK (0) position.
6.
Turn the ignition switch to the ON
(II) position, and open the driver’s
door.
On A/T vehicles, move the shift
lever to P. Apply the parking brake.
1.
2.
3.
To turn off the Auto Door Unlock
modes:
Release the switch and, within 5
seconds, turn the ignition switch to
the LOCK (0) position. P ush
a
ndholdtherearof the
master door lock switch on the
driver’ s door. You will hear a click
and, af ter about 5 seconds, you
will hear another click.
4.
5.