2007 FORD FIESTA drum

206-02-8 o Drum Brake 206-02-8
REMOVAL AND INSTALLATION
Detach the brake shoes from the wheel 11. Disconnect the parking brake cable from
cylinder. the
brake shoe.
I
9. Remove the brake shoe return springs. 12. Remove the brake shoes.
Installation
I. N0TE:Make sure that the brake shoe adjuster
is fully released.
N0TE:lnstall a new parking brake cable retaining
clip.
To install, reverse the removal procedure.
Apply grease to the brake shoe adjuster strut.
Clean the backing plate and apply silicon
dieletic compound to the brake shoe contact
points.
10. Remove the brake shoe adjuster from the 2, Adjust the parking brake cable. For
brake shoes.
additional information, refer to
Section
206-05 [Parking Brake and
Actuation].
2006.0 Fiesta 1212006 G149887en
procarmanuals.com

206-02-9 Drum Brake 206-02-9
REMOVAL AND INSTALLATION
Wheel Cylinder(l2 305 0)
\* , General Equipment 2. Bleed the brake system. For additional
Brake hose clamp information, refer to Section 206-00 [Brake
System
- General Information].
Removal
A CAUTI0N:lf brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold water.
1. Remove the brake shoes.
For additional information, refer to Brake
Shoes in this section.
2m ACAUTION:C~~ the brake tube to prevent
fluid loss or dirt ingress.
Disconnect the brake tube from the wheel
cylinder.
1. Using a suitable brake hose clamp, clamp
the brake hose.
2. Disconnect the brake tube.
3. Remove the wheel cylinder.
Installation
I. To install, reverse the removal procedure.
2006.0 Fiesta 1212006 GI 49888en
procarmanuals.com

206-02-1 0 Drum Brake 206-02-1 0
REMOVAL AND INSTALLATION
Brake Backing Plate(l2 31 3 0)
General Equipment
I Electric hand drill I
I Blind rivet gun-hand I
Removal
I. Remove the wheel cylinder.
For additional information, refer to Wheel
Cylinder in this section.
2. Detach the parking brake cable from the
backing plate.
I. Depress the retaining clip.
2. Detach the cable.
3.
Remove the brake backing plate.
Using a suitable electric hand drill remove
the rivets
Installation
1. To install, reverse the removal procedure.
Using a suitable blind rivet gun-hand, install
new rivets.
2006.0 Fiesta 1212006 G149889en
procarmanuals.com

206-05-1 Parking Brake and Actuation 206-05-1
SECTION 206-05 Parking Brake and Actuation
VEHICLE APPLICATION:2006.0 Fiesta
CONTENTS
PAGE
SPECIFICATIONS
................ Specifications ........................................................................\
............................. ; 206-05-2
DESCRIPTION AND OPERATION
........................................................................\
............................................. Parking Brake 206-05-3
Overview ........................................................................\
..................................................... 206-05-3
DIAGNOSIS AND TESTING
Parking Brake ........................................................................\
............................................. 206-05-5
Inspection and Verification ........................................................................\
.......................... 206-05-5
........................................................................\
........................................... Symptom Chart 206-05-5
Pinpoint Tests ........................................................................\
............................................. 206-05-5
GENERAL PROCEDURES
-- ........ Parking Brake Cable Adjustment Vehicles With: Rear Drum Brakes (12 662 0) 206-05-9
. Parking Brake Cable Adjustment
Vehicles With: Rear Disc Brakes .......... (1 2 662 0) 206-05-1 1
REMOVAL AND INSTALLATION
. Parking Brake Cable Vehicles With: Rear Drum Brakes ........................... (1 2 675 0) 206-05-1 3
. Parking Brake Cable Vehicles With: Rear Disc Brakes ............................. (1 2 675 0) 206-05-1 5
Parking Brake Control ........................................................................\
............ (1 2 664 0) 206-05-1 7
procarmanuals.com

206-0516 Parking Brake and Actuation 206-05-6
DIAGNOSIS AND TESTING
TEST CONDITIONS
A2: CHECK FOR WORN BRAKE SHOES OR PADS
rn Inspect the brake shoes or pads for excessive
wear.
REFER to: Specifications (206-00, Specifica-
tions)
I Brake Shoes (206-02 Drum Brake, Removal
and Installation)
I Brake Pads (206-04, Removal and Installation).
Are the brake shoe linings or brake pads OK?
+ Yes
GO to A3.
+ No
INSTALL new brake shoes or pads.
REFER to: Brake Shoes (206-02 Drum Brake,
Removal and Installation)
I Brake Pads (206-04, Removal and Installa-
tion).
TEST the system for normal operation.
A3: CHECK FOR DAMAGED PARKING BRAKE CABLES
lnspect the parking brake cables and conduits
for damage, rust or fraying.
Are the parking brake cables and conduits OK?
+ Yes
CHECK for other causes such as loose
parking brake control or conventional brake
system components.
+ No
REPAIR or INSTALL cables and conduit as
necessary. TEST the system for normal
operation.
2006.0 Fiesta 1212006 GI 7495en
procarmanuals.com

206-05-8 Parking Brake and Actuation 206-05-8
DIAGNOSIS AND TESTING
TEST CONDITIONS
B4: CHECK REAR PARKING BRAKE CABLES
Disconnect the parking brake at the rear brakes,
one at a time.
- Rotate the wheel affected by the disconnected
parking brake.
Did the wheel turn freely?
-+ Yes
INSTALL a new parking brake control lever
on the rear drum brakes or caliper assembly
on rear disc brakes.
REFER to: Brake Shoes (206-02 Drum Brake,
Removal and Installation)
I Brake Caliper (206-04, Removal and Install-
ation).
TEST the system for normal operation.
-+ No
REFER to: Brake System (206-00, Diagnosis
and Testing).
2006.0 Fiesta 1212006 GI 7495en
procarmanuals.com

206-05-9 Parking Brake and Actuation 206-05-9
GENERAL PROCEDURES
Parking Brake Cable Adjustment - Vehicles With: Rear Drum
I. Remove the parking brake control trim panel. Stage 5: Depress the brake pedal firmly
fifteen times.
2. Loosen the parking brake cable adjustment
nut to the end of the thread.
Discard the retaining clip.
3. Release the parking brake.
4. Make sure that the parking brake cable is
correctly located.
5. N0TE:Prior to carrying out the adjustment
to a new or relocated parking brake cable,
settle the parking brake system.
Settle the parking brake system in five
stages.
Stage 1 : Raise the parking brake control four
notches.
Stage 2: Tighten the adjustment nut until
increased torque is detected.
Stage 3: Operate the parking brake control
firmly ten times.
Stage 4: Loosen the adjustment nut to the
end of the thread.
6. Release the parking brake.
7. Remove the brake backing plate inspection
cover on both sides (left-hand side shown).
8. N0TE:Make sure that the parking brake
control is fully released.
Adjust the parking brake cable in two stages
Stage 1 : With the aid of another technician,
tighten the parking brake cable adjustment
nut until the parking brake levers operate
(left-hand side shown).
Stage 2: When movement is observed on
both levers, tighten the parking brake cable
adjustment nut two full turns.
2006.0 Fiesta 1212006 GI 49892en
procarmanuals.com

206-05-1 3 Parking Brake and Actuation 206-05-1 3
REMOVAL AND INSTALLATION
Parking Brake Cable - Vehicles With: Rear Drum
Brakes(l2 675 0)
I Lubricant I ESE-M99B144-B I
5. Disconnect the parking brake cable on both
Removal
Materials
I. Release the parking brake. sides.
2. Raise and support the vehicle. For additional
information, refer to: (100-02 Jacking and
Lifting) Name
Specification
Jacking (Description and Operation),
Lifting (Description and Operation).
3m ~CAUTION:T~~~ care when removing the 6, Detach the parking brake cable from the exhaust hanger insulators to prevent
damage. beam
axle on both sides.
Detach the exhaust rear muffler from the
exhaust hanger insulators.
4. Detach the center section of the exhaust
system heat shield from the floor panel. 7.
Detach the parking brake cables from the
parking brake cable equalizer. 1. Detach the parking brake cables from the
parking brake cable support bracket.
2. Detach the parking brake cables from the
parking brake cable equalizer.
2006.0 Fiesta 1212006 G89185en
procarmanuals.com