2007 FIAT PANDA spec

SIDE DIRECTION INDICATORS
To change the bulb, proceed as follows:
❒push the transparent cover A-fig. 27
towards car running direction (it is
pressure-fitted);
❒remove connector G-fig. 25;
❒release the bulb holder catch H;
❒remove the burnt bulb I-fig. 26and fit
the new bulb;
❒refit by reversing the above mentioned
operations.
fig. 25F0G0093mfig. 27F0G0095m
fig. 26F0G0094m
140
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
❒remove the burnt bulb F-fig. 24and fit
the new bulb;
❒refit by reversing the above mentioned
operations.
To replace the main/dipped beam light
bulb, proceed as follows:
❒release clip A-fig. 21and remove cap
B;
fig. 24F0G0092m
123-154 Panda New GB 21-06-2007 13:51 Pagina 140

141
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
❒remove the transparent cover A-fig.
28from bulb holder (it is pressure-fit-
ted);
❒remove the bulb Band replace it;
❒ refit the lens.
❒loosen cover C-fig. 30and remove the
connector D;
❒release clip E-fig. 31and remove the
bulb F;
❒refit by reversing the above mentioned
operations. FRONT FOG LIGHTS
(where provided)
To change the halogen bulb, proceed as
follows:
❒slacken the two fog light fastening
screws A-fig. 29on the bumper;
❒slacken the two fog light fastening
screws Bunder the bumper;
❒remove the protection including the fog
light and remove the connector;
fig. 29F0G0227mfig. 28F0G0604mfig. 30
TOPOFFON
F0G0228m
fig. 31F0G0229m
123-154 Panda New GB 21-06-2007 13:51 Pagina 141

142
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
Figure 34
D12V-21W bulb for reversing light on
right light unit;
❒rear fog light on left light unit;
❒on right hand drive versions, re-
versing light in the left rear light
cluster and in the rear fog lamp in
the right rear light cluster;
E12V-21W bulb for direction indica-
tors;
F12V-21/5W double-light bulb for stop
light and taillights;
❒slacken the four screws B-fig. 33from
their seats;
❒remove the bulb-holder C;
❒remove the bulbs, pushing them slight-
ly anti-clockwise;
❒refit by reversing the above mentioned
operations.
fig. 33F0G0097mfig. 34F0G0098m
REAR LIGHT UNIT
To change the bulb proceed as follows:
❒slacken the three screws A-fig. 32
from their seats, pull gently outwards
until releasing the whole headlight from
the three clips (press-fitted) and release
the connector;
fig. 32F0G0096m
123-154 Panda New GB 21-06-2007 13:51 Pagina 142

143
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
Number plate light
To change the bulb, proceed as follows:
❒use a screwdriver to remove the re-
taining spring as shown in fig. 35;
fig. 35F0G0099mfig. 36F0G0100m
THIRD STOP LIGHT
To change the bulb, proceed as follows:
❒slacken the two screws A-fig. 37and
remove the whole cover;
❒disconnect connector B-fig. 38and re-
move the light unit;
fig. 37F0G0101m
fig. 38F0G0210m
❒remove the transparent A-fig. 36and
the bulb Bfrom the bulb holder;
❒change the 12V-5W bulb pressure-fit-
ted in the bulb holder;
❒ refit the lens.
123-154 Panda New GB 21-06-2007 13:51 Pagina 143

144
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
❒release clip C-fig. 39and remove the
light unit from the lens unit;❒replace the pressure-fitted burnt out
bulb D;
❒refit by reversing the above mentioned
operations.
fig. 39F0G0211m
IF AN INTERIOR LIGHT
BURNS OUT
For the type of bulb and power rating, see
“When needing to change a bulb”.
CEILING LIGHT
To change the bulb, proceed as follows:
❒insert the screwdriver supplied with the
car in the point shown by the arrow
and remove the ceiling light A-fig. 40;
123-154 Panda New GB 21-06-2007 13:51 Pagina 144

145
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
❒open cover B-fig. 41as shown;BOOT LIGHT (where provided)
To change the bulb, proceed as follows:
❒open the tailgate;
❒insert the screwdriver supplied with the
car in the point shown by the arrow
and remove the ceiling light A-fig. 43.
fig. 40F0G0193m
fig. 41F0G0213m
fig. 42F0G0214mfig. 43F0G0102m
❒replace the bulb C-fig. 42releasing the
side contacts, insert the new bulb and
make sure that it is correctly clamped
between the contacts;
❒close the cover and refit the transpar-
ent.
123-154 Panda New GB 21-06-2007 13:51 Pagina 145

146
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
IF A FUSE BLOWS
GENERAL fig. 45
The fuse is a protective device for the
electric system: it comes into action (i.e.
it cuts off) mainly due to a fault or im-
proper action on the system.
When a device does not work, check the
efficiency of its fuse: the conductor ele-
ment Amust be intact. If not, replace the
fuse with one of the same amp rating
(same colour).
Bundamaged fuse.
Cfuse with damaged filament.
To facilitate fuse replacement, use the pli-
ers Dhooked to the fusebox on the in-
strument panel left-hand side.
Refer to the tables on the following pages
to identify the protection fuse.
❒open the bulb cover B-fig. 44and re-
place the pressure-fitted bulb C;
❒refit the cover Bon the transparent;
❒refit correctly the light pressing one
side and then the other until the lock-
ing click is heard.
fig. 44F0G0103mfig. 45F0G0087m
Never replace a fuse with
metal wires or anything else.
Never replace a fuse with
another with a higher amp
rating; DANGER OF FIRE.
WARNING
If a general fuse (MEGA-
FUSE, MIDI-FUSE, MAXI-
FUSE) cuts in, do not attempt any re-
pair and contact a Fiat Dealership.
WARNING
If a fuse blows again, contact
a Fiat Dealership.
WARNING
Before replacing a fuse,
make sure the ignition key
has been removed and that all the
other services are switched off and/or
disengaged.
WARNING
123-154 Panda New GB 21-06-2007 13:51 Pagina 146

147
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
FUSE LOCATION
The fusebox is on the steering wheel left-
hand sidefig. 46and 47.
To gain access to the fusebox, slacken the
cover Ffastening screw E.
Gwired control unit.
HBody-computer control unit.
Dfuse extracting pliers.
The number identifying the electrical com-
ponent corresponding to each fuse is on
the cover back.
fig. 47 fig. 46
F37
18
916
F0G0139m
F0G0260m
123-154 Panda New GB 21-06-2007 13:51 Pagina 147