Page 191 of 266
190
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
REAR LIGHT CLUSTER
To change the bulb, proceed as follows:
❒from inside the boot release and remove cover (A) by turning the
retaining knob (B), then remove pin (C) to reach the third nut;
❒loosen the two visible nuts (D) and the third one that can be reached
through hole (E); remove the light unit;
❒remove connectors, loosen the three screws (F) and open the light
holder unit;
❒remove the burnt out bulb, by pressing it slightly and turning it
counterclockwise.
The same operations stand valid for the left light unit.
Bulbs are the following:
G - 12V-5/21W, two-light, for taillights and brake lights
H - 12V-21W for reversing light
I - 12V-21W for direction indicators
L - 12V-21W for rear fog lights
After replacing, refit the headlight by reversing the above operations.
F0E0673m
F0E0674m
F0E0675m
Page 192 of 266
191
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
THIRD BRAKE LIGHTS
To replace 12V-3W bulbs:
❒with the tailgate open, undo the four fastening screws under the caps
(shown by the arrows) and remove the panel;
❒take out connection (A);
❒undo the four screws securing the light unit and remove the cover
(B);
❒remove the bulbs (C) to be replaced from their seats.
After replacing the bulb, refit the two halves of the light unit then secure
the latter to the covering panel after reconnecting the electric
connection; refit the panel to the tailgate.
NUMBER PLATE LIGHTS
To replace the 12V-5W bulb:
❒using a screwdriver in the direction of the arrow, compress catch (F)
and take out the number plate light unit;
❒remove bulb holder and lens (D);
❒take out the bulb holder turning it slightly and replace the bulb (E).
F0E0254m
F0E0146m
F0E0676m
Page 198 of 266
197
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
1
2
2
3
3
3
4
5
6
6
6
6
6
6
6
7
7
7
7
8
8
8
8
9
9
10 10
10
10
20
20
20
10
30
10
10
10
10
10
10
10
10
10
10
10
10
10
10
10
15
15
20
Fuses inside the car Ampere Fuse no.
Right-hand main beam
Left-hand main beam
Main beam warning light
Rear fog lights
Rear fog lights warning light
Side/taillight power
Left-hand dipped beam
Car interior fan
Right-hand number plate light
Right-hand front sidelight
Cigar lighter light
Ashtray light
Side/taillight warning light
Sound system light
Left-hand taillight
Left-hand number plate light
Left-hand front sidelight
Right-hand taillight
Heating system lighting
Right-hand dipped beam
Brake fluid warning light
Headlight beam adjuster
Headlight washer relay coil
Cigar lighter
Conditioner compressor
Headlight washer
Page 199 of 266
198
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
10
10
11
12
12
12
12
12
12
12
12
12
12
12
13
13
13
13
13
13
13
13
13
13
13 20
20
20
10
10
10
10
10
10
10
10
10
10
10
15
15
15
15
15
15
15
15
15
15
15Windscreen wiper
Rear window wiper
Horn
+ 30 instrument panel
+ 30 front ceiling light
+ 30 EOBD Fiat tester
+ 30 rear ceiling light
+ 30 sound system
+ 30 connect-nav
+ 30 navigator
+ 30 clock
+ 30 sunroof
+ 30 webasto (additional heater)
+ 30 anti-theft control unit
Reversing light
Front direction indicators
Brake light
Third brake light
Rear direction indicators
Direction indicator warning light
Side direction indicators
Hazard light warning light
+ 15 cellular phone
+ 15 sound system
+ 15 connect-nav
Fuses inside the car Ampere Fuse no.
Page 205 of 266
204
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
WARNINGDo not start the engine when towing the vehicle.
Before starting to tow, turn the ignition key to MAR and then to STOP. Do not
remove the key. If the key is removed, the steering lock engages automatically
resulting in the impossibility to steer the wheels. WARNING
WARNINGWhen towing, remember that without the help of the servobrake and power
steering, a greater effort is required on the pedal and steering wheel. Do not use
flexible cables for towing and avoid jerks. During towing operations make sure that
fastening the joint to the car does not damage the components in contact with it.
When towing the car, you must comply with the specific traffic regulations
regarding the tow ring and how to tow on the road.
Page 208 of 266

207
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
CAR
MAINTENANCE
SERVICE SCHEDULE
20 40 60 80 100 120 140 160 180
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●
●●●
●●●●● ●●●●
●●
●● ●
●●
●● ● ●
●●●●● ●●●●
Thousands of km
Check tyre conditions/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators,
hazard lights, boot lights, passenger compartment lights,
glovebox lights, warning lights, etc.)
Check windscreen wiper/washer operation, adjust nozzles
Check windscreen/rear window blade position/wear
Check front disk brake pad conditions and wear
and wear indicator operation
Check rear drum brake linings conditions and wear
(where provided)
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: bodywork, underbody
protection, pipes and hoses (exhaust - fuel - brakes), rubber
parts (boots, sleeves, bushes, etc.) fuel and brake system hoses
Check tension and adjust accessory drive belts (excluding
engines with automatic belt tighteners)
Sight inspect accessory drive belt conditions (petrol versions)
Sight inspect accessory drive belt conditions (diesel versions)
Check clutch pedal height or stroke and adjust if necessary
Check cleanness of locks, bonnet and boot and lever cleanness
and lubrication
Page 209 of 266

208
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
Thousands of km
●●●
●● ● ●
●● ● ●
●
●●
●●●●● ●●●●
●●
●●●●● ●●●●
●●●
●●●●● ●●●●
●●
●●
●
●
●● ● ●
●● ● ●
●●●●● ●●●●
●●●
●●●●● ●●●●
20 40 60 80 100 120 140 160 180
(*) Or every 4 years for particularly demanding use (cold climates, driving in the city idling for a long time)
Or every 5 years, regardless of the km covered
(**) Engine oil and oil filter shall be changed when the corresponding warning light turns on (see section “Warning lights and Messages”), or in
any case every 2 years.
Check and adjust tappet clearance, if required (JTD 120 versions)
Check and adjust handbrake lever stroke
Check exhaust emissions/smoke (JTD 120 versions)
Check exhaust emissions
Check antievaporation system
Change fuel (JTD 120 versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (diesel versions)
Replace fuel filter cartridge (diesel versions)
Check and top up, if required, fluid levels (engine coolant,
brakes, windscreen washer, battery, etc.)
Check mechanical oil level
Check timing belt conditions
Replace timing belt (*)
Replace auxiliary belt
Change spark plugs (petrol versions)
Check engine control system operation
(through diagnostic socket)
Change engine oil and oil filter (petrol versions)
Change engine oil and oil filter
(JTD versions with DPF) (**)
Change brake fluid (or every 24 months)
Change pollen filter (or every 12 months)
Page 210 of 266
209
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
CAR
MAINTENANCE
PERIODICAL CHECKS
Every 1,000 km or before long journeys, check and top
up if required:
❒engine coolant fluid level;
❒brake fluid level;
❒windscreen washer fluid level;
❒tyre pressure and conditions.
❒check light system operation (headlights, direction
indicators, hazard lights, etc.);
❒check windscreen wiper/washer operation and
windscreen/rear window blade position/wear;Every 3,000 km check and top up if required: engine
oil level.
You are recommended to use FL Seleniaproducts,
designed and produced specifically for Fiat cars (see
table “Capacities” in section “Technical
specifications”).