2007 FIAT MULTIPLA Natural Power Manual

17
BODY VERSION CODE
Description
Fiat Multipla 186AMC1A 06G
Fiat Multipla
4-seater VAN 186BMC1A 02W
ENGINE
1.6
GENERAL REMARKS
Engine identification code 182B6000
Engine cycle Otto
Number and position of cylinders 4, in-line
Number of valves per cylinder 4
Pistor diameter and stroke mm 80.5 x 78.4
Total displacement cm31596
Compression ratio 10.5 : 1
kW
EC maximum rating HP
corresponding engine speed rpm
Nm
EC maximum torque kgm
corresponding engine speed rpm
Spark plugs NGK BKR6EKC
Fuel
Fuelling
by natural gas
68
92
5750
126
12.84
4000
Natural gas
Fuelling by
Petrol
76
103
5750
143
14.6
4000
Unleaded petrol
95 RON
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 17

18
FUEL FEED (Natural gas)
Electronic injection specific to the natural gas.
Type: Sequential, timed Multipoint injection.
Injection pressure: approximately 9 bar.
Stoichiometric metering of the air/natural gas mixture.
The natural gas injection system is controlled by a
special control unit by making use of the sensors
previously fitted to the vehicle, including the oxygen
sensor for fuel metering control.
IGNITION
Electronics with static advance integrated with
injection.ENGINE COOLING
Engine cooling system with branching-off to bring hot
fluid in contact with the pressure reducer (which is
subject, during its operation, to heavy cooling).
PERFORMANCE
Maximum speeds in the 5
thgear (kph):
petrol fuelling: 168
natural gas fuelling: 157
Any modification or repair made to the fuel feed system in a wrong way and
without considering the technical features of the system may cause operating
anomalies with a risk of fire.WARNING
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 18

19
WEIGHTS
1.6 VAN
4-seater
1520
4p + 230
1100
1050
2050
1000
400
70
80 1.6
1470
580
1100
1050
2050
1000 (900*)
400
70
80
(1) In the presence of special outfits (trailer towing device, etc.) the no-load weight increases and, as a result, the maximum carrying ca-
pacity decreases, in accordance with the maximum permitted loads.
(2) Loads not to be exceeded. The user shall place the goods in the luggage compartment and/or on the loading plane in accordance with
the maximum permitted loads.
(*) For specific markets
(
") The operating speed shall be restricted to 100 kph when the vehicle tows a trailer.
Weights (kg) per versions
Vehicle curb weight
(including fill-up, spare wheel, tools and accessories):
Maximum carrying capacity, including driver (1):
Maximum permitted load (2)
– front axle:
– rear axle:
– total:
Towable loads "
– braked trailer:
– non-braked trailer:
Maximum load on tow hitch (trailer with brakes):
Maximum load permitted on the roof:
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 19

20
F0E0653m
DIMENSIONS
Boot volume (VDA standards):
❒in normal conditions: 430 dm
3.
❒flush with the roof and with the rear
seats removed: 1,900 dm
3.
Height is meant with the car unladen.
Dimensions (mm)
ABCDE FGH
100 16V837 2666 586 4089 1721 1515 1871 1520
VAN 100 16V837 2666 586 4089 1695 1515 1871 1520
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 20

21
FUELLING AND FILLING
Person transport version
Petrol .................................................................. litres 38
❐ including a reserve of .................................. litres 5
Natural gas (*)
❐ bottle ................................................................ litres 164
❐ Natural gas (*) ............................ m338.9 (kg 26.49)
(*) Natural gas in standard conditions: 15°C; 1.013 bar; density: 0.680
kg/m3.
IMPORTANT! Please be reminded that when natural
gas is used to fuel the vehicle, the fuel distance may
vary to some extent since it depends on the vehicle
maintenance and driving conditions as well as the
temperature of the gas in the bottle.
In fact, natural gas heats up when it is filled and cools
when the vehicle is running, thus undergoing pressure
variations that reduce the amount of gas that can be
used.ENGINE OIL
IMPORTANT! As regards the engines powered by
alternative fuels (natural gas), a multigrade engine oil
shall be used, which shall feature very high fluidity,
grade: SAE 5W30, specifications ACEA A1-A5 - API SL
and FIAT 9.55535-M1.
Therefore, it is recommended that you use the
SELENIA PERFORMER MULTIPOWER oil.
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 21

22
FUEL CONSUMPTION
The consumption values shown below refer only to
the vehicles used for carrying persons.
The fuel consumption values, illustrated in the table,
have been determined in accordance with the
homologation tests prescribed by the relevant
European Directives.
Consumption values are defined by means of the
following procedures:
❐ urban cycle: it involves a cold start followed by a
simulated drive in the city street traffic;
❐ extra-urban cycle: it involves simulating a drive
outside a city with frequent accelerations in all the
gears; speed ranges from 0 to 120 kph;
❐ average combined: it is determined by considering a
weighed covered distance of approximately 37%
urban cycle and approximately 63% extra-urban
cycle.
IMPORTANT! The different types of route, traffic
conditions, weather conditions, driving style, general
conditions of the vehicle, body
versions/outfits/accessories, utilization of the air
conditioner, vehicle loaded conditions, roof-racks and
any other condition that may affect the vehicle’s drag
or rolling resistance will result in fuel consumption
values other than the detected ones.
Consumption according to the EC Directive 1999/100/CE
Natural gas Petrol Fuel distance
(m3x 100km) (litres x 100km) natural gas fuelling
Urban 11.5 11.9 323
Extra-urban 7.6 7.5 504
Average combined 9 9.1 419
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 22

23
CO2 EMISSIONS
The CO2 emission values, shown in the table below, refer to the average
combined consumption.
CO
2emissions according to the EC Directive 1999/100/CE (g/km)
Persons transport version:
Natural gas .................................................................................................. 161
Petrol ............................................................................................................ 216
FUSES
The Natural Power version makes use of special fuses to protect the
various components of the system.
Control unit next to the battery
To open, press the two locking tabs (A) and take the cover off.
The fuses protect:
1 - 7.5 A Fiat code control unit
2 - 10A ABS
3 - 20A Headlamp washing pump
Fuses on the passenger compartment partition wall.
The fuses protect:
4 - 7.5A Gas solenoid valves
5 - 5A Gas injection control unit
6 - 15A Electric injectors
7 - 5A + 15 CCM and Fiat code control unit
8 - 15A Oxygen sensor
9 - 10A Petrol pump
F0E0560m
F0E0691m
F0E0693m
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 23

Fiat Group Automobiles S.p.A. - Servizi al Cliente - Assistenza Tecnica
Ingegneria Assistenziale - Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Print n° 603.83.424 - 1I/2007 - 1
stEdition
ENGLISH
603.83.424 Multipla NatPow gb 5-10-2007 15:27 Pagina 24