Page 135 of 314
134
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
BONNET
TO OPEN THE BONNET
Proceed as follows:
❒pull lever (A) in the direction of the arrow;
❒move the lever (B) to the right as shown by the arrow;
❒lift the bonnet and at the same time release the rod (C) from the clip
(D), then insert the rod end in its housing (E) on the bonnet.
IMPORTANT Before opening the bonnet, check that windscreen wiper
arms are not lifted from the windscreen.
F0H0114m
WARNINGFor safety reasons the bonnet shall always
be perfectly closed when travelling.
Always check for proper bonnet locking. If
the bonnet is left inadvertently open, stop
the car immediately and close the bonnet.
F0H0113m
F0H0115m
Page 136 of 314
135
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
TO CLOSE THE BONNET
Proceed as follows:
❒hold the bonnet up with one hand and with the
other remove rod (C) from recess (D) and replace
it in its locking device (E);
❒lower the bonnet at approx. 20 centimetres from
the engine compartment and then let it drop,
ensuring that it is fully closed and not just held in
position by the safety catch. If the bonnet does not
close properly, do not push it down but open it
again and repeat the above procedure.IMPORTANT Always check that the bonnet is closed
properly to avoid its opening while the car is travelling.
WARNINGIf the supporting rod is not positioned correctly the bonnet may fall violently.
WARNINGCarry out operations when the vehicle is stationary.
Page 284 of 314

283
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
❒wipe a sponge with a slightly soapy solution over
the bodywork, frequently rinsing with the sponge;
❒rinse well with water and dry with a jet of air or a
chamois leather.
When drying, take particular care with the less visible
parts like door surrounds, bonnet and around the
headlights where water may stagnate. The car should
not be taken to a closed area immediately, but left in
the open so that residual water can evaporate.
Do not wash the car after it has been left in the sun or
with the bonnet hot: this may alter the shine of the
paintwork.
Exterior plastic parts must be cleaned in the same way
as the rest of the vehicle.
Where possible, do not park under trees; the resinous
substance many species release give the paint a dull
appearance and increase the possibility of triggering
rust processes.
IMPORTANT Bird droppings must be washed off
immediately and thoroughly as the acid they contain is
particularly aggressive.Windows
Use specific window cleaner products. Use also clean
cloths to avoid scratching the glass or damaging the
transparency.
IMPORTANT The inside of the rearscreen should be
wiped gently with a cloth in the direction of the
filaments to avoid damaging the heating device.
Front headlights
IMPORTANT When cleaning plastic lenses of front
headlights, never use aromatic substances (e.g. petrol)
or ketones (e.g.: acetone).
Detergents cause water pollution. Therefore the car should be washed in areas equipped for
collecting and purifying the liquid used in the washing process.