2007 FIAT IDEA key

216
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
AIR BAG FAILURE
Turning the ignition key to MAR the warning
light on the dial turns on, but it should go off
after few seconds. The warning light stays on
glowing steadily (on certain versions together
with the message on the display) if there is a fail-
ure in the air bag system.
¬
red
WARNING
WARNINGIf warning light ¬does not come on when turning the key to MAR or if it stays
on when travelling it could indicate a failure in restraint systems; in this case air
bags or pretensioners could not trigger in the event of an accident, or in a restrict-
ed numbers of cases they could trigger accidentally. Stop the car and contact Fiat
Dealership to have the system checked immediately.
The failure of the
¬warning light (warning light off) is also indicated by the
flashing for more than the normal seconds of the passenger’s front air bag deacti-
vated warning light
F(where required).
Warning
light on dialMessage on reconfigurable
multifunction displayMessage on
multifunction display

217
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
TWILIGHT SENSOR FAILURE
(where provided)
The warning light on the dial turns on (on certain
versions together with the message on the dis-
play) when failure is detected in twilight sensor
(adjusting headlight sensitivity).
è
INJECTION SYSTEM FAILURE
(Multijet versions)
In normal conditions, turning the ignition key to
MAR, the warning light turns on, but it should go
off when the engine has started. The initial turn-
ing on indicates that the warning light is working
properly.
If the warning light stays on or turns on while
travelling, this indicates that the injection system
is not working perfectly with possible lack of per-
formance, poor handling and high consumption.
In these conditions it is possible to continue dri-
ving without however requiring heavy effort or
high speed from the engine. In any case, contact
Fiat Dealership as soon as possible.U
amber
amber
Warning
light on dial Message on
multifunction displayMessage on reconfigurable
multifunction display

218
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
EOBD - ENGINE CONTROL SYSTEM
FAILURE (petrol versions)
In normal conditions, turning the ignition key to
MAR, the warning light turns on, but it should
go off when the engine has started. The initial
turning on indicates that the warning light is
working properly.
If the warning light stays on or turns on when
travelling (on certain versions together with the
message on the display):
❒glowing steadily - means a fault in the
supply/ignition system which could cause high
emissions at the exhaust, possible lack of
performance, poor handling and high con-
sumption levels.
In these conditions it is possible to continue dri-
ving without however requiring heavy effort or
high speed from the engine. Prolonged use of
the car with the warning light on may cause
damages. Contact Fiat Dealership as soon as
possible.
The warning light goes off if the fault disappears,
but it is still stored by the system.
U
amber
8:30
continues on next page
Warning
light on dialMessage on reconfigurable
multifunction displayMessage on
multifunction display

219
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
❒flashing- indicates the possibility of damage
to the catalyst (see “EOBD system” in section
“Dashboard and controls”).
If the light flashes, it is necessary to release the
accelerator pedal to lower the speed of the
engine until the warning light stops flashing; con-
tinue the journey at moderate speed, trying to
avoid driving conditions that may cause further
flashing and contact Fiat Dealership as soon as
possible.U
amber
amber
8:30
continued from previous page
If with ignition key at MAR, the
Uwarning light does not turn on or if it turns on with fixed
light or flashing when the car is travelling (on certain versions together with the message on
the display), contact Fiat Dealership as soon as possible. Warning light
Uoperation can by
checked by traffic agents by proper equipment therefore, comply with laws and regulations
in force in the country where you are driving.
GENERIC FAILURE INDICATION
The warning light on the dial comes on when the
engine oil pressure sensor is faulty and, for
Multijet versions with modal instrument panel,
also when a failure is detected in diesel fuel sen-
sor. Contact Fiat Dealership as soon as possible.
è
Warning
light on dial Message on
multifunction displayMessage on reconfigurable
multifunction display

221
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
DOOR OPENING/CLOSING
Emergency door locking device from outside
The doors are fitted with a device which makes it possible to close the
doors with the lock without power supply.
To close, proceed as follows:
❒insert the ignition key in the pawl (B)
❒turn the device to position 1 and close the ledge.
To open, proceed as follows:
❒insert the key in the pawl and turn it clockwise
❒open the driver’s door
❒from the vehicle inside open the remaining doors by operating the
levers located in the handles.
F0H0247m

222
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
ENGINE STARTING
EMERGENCY START-UP
If the Fiat CODE cannot deactivate the engine
immobilising system, the
Yand Uwarning lights
stay on and the engine will not start.
To start the engine the emergency start-up can be
performed.
Read the whole procedure carefully before trying to
carry it out. If you make a mistake, you must turn the
ignition key back to STOP and repeat the whole
operation from beginning.
Proceed as follows:
❒Read the 5-figure electronic code given on the
CODE card;
❒Turn the ignition key to MAR;
❒Press and hold down the accelerator pedal. The
instrument panel warning light
Uwill come on for
about 8 seconds and then go out;
❒Release the accelerator pedal and get ready to
count the flashes of the
Uwarning light;
❒Count the number of flashes that corresponds to
the first figure of the code on the CODE card, then
press the accelerator pedal and keep it there until
the
Uwarning light comes on for four seconds
and then goes out; release the accelerator pedal;
❒The Uwarning light will start flashing again: after it
has flashed the number of times that corresponds
to the second figure on the CODE card, press the
accelerator pedal to the floor and keep it there;
❒Do the same for the remaining figures on the
CODE card;
❒Once the final figure has been entered, keep the
accelerator pedal pressed. The
Uwarning light
will light up for four seconds and then go out;
release the accelerator pedal;
❒Rapid flashing of the warning light U(for about 4
seconds) confirms the operation has been carried
out successfully;
❒Start the engine by turning the ignition key from
MAR to AVV.
If however the warning light
Ustays on, turn the
ignition key to STOP and repeat the procedure from
step one
IMPORTANT After an emergency start-up, you should
contact a Fiat Dealership otherwise you will have to
repeat the procedure described each time you want to
start the engine.

248
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0H0198m
IF A FUSE BLOWS
GENERAL
The fuse is a protective device for the electric system: it comes into
action (i.e. it cuts off) mainly due to a fault or improper action on the
system.
If an electric device is not working, check the efficiency of its fuse. The
conductor element (A) must be intact; if not, replace the fuse with one of
the same amp rating (same colour).
(B): Undamaged fuse
(C): Fuse with broken filament.
Remove the blown fuse using the pincer (D) provided in the control box
on the dashboard.
Never replace a broken fuse with anything other than a new fuse.
WARNING
WARNINGIf a general fuse (MEGA-FUSE, MIDI-FUSE, MAXI-FUSE) cuts in, do not attempt
any repair and contact Fiat Dealership. Before changing a fuse, check the ignition
key has been removed and that all the other electric devices have been turned
off/disabled.
If the fuse blows again, have the car inspected at Fiat Dealership.
WARNINGNever change a fuse with another with a higher amp rating, DANGER OF FIRE.

251
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
FUSE SUMMARY TABLE
Control box on dashboard
USERFUSE AMPERE
Right-hand dipped beam headlightF12 15
Left-hand dipped beam headlight / headlight aiming device F13 15
Reversing lights / engine compartment control box relay coils / body computer F31 7.5
+30 Driver’s / passenger’s door control units (*)F32 15
Left rear power windowF33 20
Right rear power windowF34 20
+15 Cruise control, signal from switch on brake pedal for control units (*) F35 7.5
+30 Presetting for trailer control unit, rear locks front locks with single door control unit (*) F36 20
+15 Third brake light, instrument panel, brake lights (*) F37 10
Boot unlockingF38 15
+30 EOBD diagnostic socket, sound system, navigator, tyre pressure control unit (*)F39 10
Rear heated screenF40 30
Heated door electric mirrorsF41 7.5
+15 ABS / ESP control unit (*)F42 7.5
Windscreen wiper/washerF43 30
Cigar lighter / current socket on tunnelF44 20
Heated seatsF45 15
Boot current socketF46 20
Driver’s door control unit power supply (power window, lock) F47 20
Passenger’s door control unit power supply (power window, lock) F48 20
+15 utilities (left and central dashboard control lights, electric mirrors, heated seat control
lighting,presetting for radiotelephone, navigator, rain / daylight sensors, parking sensor control unit,
sunroof control lighting) (*)F49 7.5
Airbag control unitF50 7.5
+15 Tyre pressure control unit, ECO / Sport control (*) F51 7.5
Rear screen wiper/washerF52 15
+30 Direction indicators, hazard lights, instrument panel (*) F53 10
(*) +30 = battery directive positive terminal (not under key)
+15 = positive terminal under key