2007 FIAT DOBLO 1.3 multijet

199TECHNICAL SPECIFICATIONS
Weights (kg) - Fiat Doblò Combi versions N1
(*) If special equipment is fitted (wing window, tow hitch, etc.), the unladen vehicle weight increases, thus reducing the specified payload.
(**) Loads not to be exceeded. The driver is responsible for arranging the loads so that they comply with these limits.
Weight empty
(including fluids, 90% fuel in the
tank and no optional)
Payload including driver (*):
Maximum allowed loads (**)
– front axle:
– front axle:
– total:
Towable weight:
– trailer with brakes
– trailer without brakes
Maximum load on roof
Maximum load on ball coupling
(trailer with brakes)1.4
8V
1240
680
1010
1150
1920
1000
500
100
601.3
85HPMultijet
1340
680
1010
1150
2020
1300
500
100
601.9 120HPMultijet
1330
680
1010
1150
2010
1300
500
100
601.9 120HPMultijet
1350
680
1010
1150
2030
1300
500
100
60 1.3
75HPMultijet
1320
680
1010
1150
2000
1200
500
100
60

201TECHNICAL SPECIFICATIONS201
1.9 Multijet
litres kg
60 –
5 - 7 –
6.5 –
4.0 (❍) 3.5 (❍)
4.3 (❍) 3.7 (❍)
1.98 1.8
1.3 1.2
0.5 –
0.55 –
7– 1.3 Multijet
litres kg
60 –
5 - 7 –
6.5 –
3.0 (■) 2.6 (■)
3.2 (■) 2.8 (■)
1.98 1.8
1.3 1.2
0.5 –
0.55 –
7–
(▲) For particularly hard climate conditions, we recommend use of a 60% PARAFLU UP and 40% demineralized water mixture.
(❍) For particularly cold temperatures use SELENIA WR.
Fuel tank:including a reserve of:
Engine cooling
system:
Engine sump:
Engine sump and filter:
Manual gearbox:
Power steering
Front and rear brakes
hydraulic circuit:
Hydraulic brake circuit
with ABS:
Windscreen and rear window
washer fluid reservoir: Prescribed fuel
Recommended products
Diesel fuel for motor vehicles
(EN590 Specification)
50 - 50 mixture of distilled water
and PARAFLU UP
(▲)
SELENIA TURBO DIESEL(❍)
SELENIA WR(■)
TUTELA CAR ZC 75 SYNTH
TUTELA GI/E
TUTELA TOP 4
TUTELA TOP 4
Mixture of water and TUTELA
PROFESSIONAL SC 35

202TECHNICAL SPECIFICATIONS
FLUIDS AND LUBRICANTS
PRODUCTS WHICH MAY BE USED AND THEIR CHARACTERISTICS
Specifications of the lubricants and fluids to use
for best operation
Synthetic-based engine oils grade SAE 10W-40
that pass ACEA A3 and API SL specifications.
Synthetic-based engine oils grade SAE 5W-30
that pass ACEA A1-A5 - API SL and
FIAT 9.55535-M1specifications.
Synthetic-based engine oils grade SAE 10W-40
that pass ACEA B3 and API CD specifications.
Synthetic-based engine oils grade SAE 5W-40
that pass ACEA B4, API CF and
FIAT 9.55535-M2specifications.
Synthetic-based engine oils grade SAE 5W-40 that pass
ACEA B4, API CF and FIAT 9.55535-M2specifications
F0A0175b
(*) For very low temperatures, we recommend SELENIA MULTIPOWER.
(**) For very low temperatures, we recommend SELENIA WR.
Applications Use
Lubricants for
petrol engines (*)
Lubricants for
diesel engines (**)
Lubricants for
diesel engines
(1.3 Multijet versions)
Fluids and lubricants
recommended
SELENIA 20K
SELENIA
MULTIPOWER
SELENIA
TURBO DIESEL
SELENIA
WR

204TECHNICAL SPECIFICATIONS
FUEL
CONSUMPTIONIMPORTANT Road and traffic
conditions, weather, driving style,
fittings and accessories, load, roof
racks, special devices and over-
all vehicle conditions can penalise
aerodynamic penetration and in-
Fuel consumption according to European Directive 2004/3/EC
litres x 100 km)
fluence fuel consumption rates
which can be different from the
values shown in the table (see
“Cheap running that respects the
environment”). The fuel consumption figures given in
the table below are determined on the
basis of the homologation tests set
down by specific European Directives.
Consumption values are defined by
means of the following procedures:
– urban cycle:consisting of a cold
start and a simulated drive in city
streets;
– extra-urban cycle:consisting in
frequent accelerations, in all gears,
simulating normal conditions of use.
Speed ranges from 0 to 120 km/h;
– average combined cycle:con-
sisting of 37% urban cycle and 63% ex-
tra-urban cycle.
Urban Extra-urban Combined
1.49.2 6.3 7.4
1.4 high roof9.4 6.5 7.6
1.4 7 seater9.2 6.3 7.4
1.3 Multijet 75 HP6.5 4.7 5.4
1.3 Multijet 85 HP6.3 4.5 5.2
1.3 Multijet 85 HP high roof6.8 4.9 5.6
1.3 Multijet 85 HP 7 seater6.3 4.5 5.2
1.9 Multijet 100/105 HP7.5 4.8 5.8
1.9 Multijet 120 HP7.5 5.2 6.1
1.9 Multijet 120 HP high roof7.7 5.3 6.2
1.9 Multijet 120 HP 7 seater7.5 5.2 6.1

205TECHNICAL SPECIFICATIONS205
CO2EMISSION AT EXHAUST
The CO2emission levels at the ex-
haust given in the following table refer
to combined consumption.CO2emissions according to Directive 1999/100/EC (g/km)
1.4174
1.4 high roof178
1.4 7 seater174
1.3 Multijet 75 HP142
1.3 Multijet 85 HP137
1.3 Multijet 85 HP high roof148
1.3 Multijet 85 HP 7 seater137
1.9 Multijet 100/105 HP153
1.9 Multijet 120 HP160
1.9 Multijet 120 HP high roof163
1.9 Multijet 120 HP 7 seater160

FUEL CAPACITY (litres) ENGINE OIL CHANGE
1.4 1.3 Multijet 1.9 Multijet
litres kg litres kg litres kg
Oil sump2.4 2.1 3.0 2.6 4.0 3.5
Oil sump and filter2.6 2.25 3.2 2.8 4.3 3.7
Dispose of waste oil properly
Versions Size Medium load Full load
Front Rear Front Rear
Passenger Transportation 185/65 R15 88T 2.3 (*) 2.3 (*) 2.3 2.7
Family (7 seater) 185/65 R15 92T 2.3 2.7 2.3 2.7
Cargo standard capacity/Combi N1185/65 R15 92T 2.3 2.7 2.3 2.7
Cargo extra capacity/Long wheelbase 175/75 R14 C99/98T 3.0 3.5 3.0 3.5
Combi N1 exra capacity 175/75 R14 C99/98T 2.8 3.0 3.0 3.5
Passenger Transportation Natural Power 175/70 R14 C95/93S 2.6 3.0 2.6 3.0
Cargo Natural Power 175/70 R14 C95/93S 2.8 3.5 2.8 3.5
With warm tyres the pressure should be +0.3 bar in relation to the prescribed value. Check again the correct pressure when the tyres are cold.
(*) Up to 3 people + 50 kg.
Tank capacity.................................................................................................................... 60
Reserve.......................................................................................................................... 5 - 7
Use only unleaded petrol with a rated octane number (RON) not less than 95.
Refuel diesel vehicles with diesel fuel for motor vehicles (EN590 Specification).
COLD TYRE INFLATION PRESSURE (bar)
Fiat Group Automobiles S.p.A.
Quality - Assistenza Tecnica - Ingegneria Assistenziale
Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Print no. 603.81.242 - 07/2007 - 1
stedition