2007 DODGE SPRINTER battery

291 Practical hints
Display messages
5
k
Visit
workshop
WARNING
G
ASR has been deactivated due to a mal-
function. Cruise control is also switched
off as a result.
The engine power output may then be
lower.
\1Continue driving, but with even greater
care.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
WARNING
G
BAS has been deactivated due to a mal-
function.
The brake system continues to function
with the normal braking effect but with no
electronic support.
\1Continue driving, but with even greater
care.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
k
unavailable
ASR as well as BAS have been switched
off due to undervoltage.
The battery may not be being charged.
The brake system is still available with
the normal braking effect.
\1Continue driving, but with even greater
care.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
ì
Please enter PIN:
You have not yet entered your details in
the telephone.
\1Enter the PIN for your SIM card.
<
Seatbelt sys.
Visit
workshop
WARNING
G
The belt system has malfunctioned.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
Display symbol
Display message
Possible cause / result
Possible solution

315 Practical hints
Changing the batteries
5
\3 Changing the batteriesIf the remote control batteries (remote
keyless entry) are discharged, you will only
be able to lock and unlock the vehicle man-
ually using the key.
If the batteries in the auxiliary heating re-
mote control are discharged, you will only
be able to switch the auxiliary heating on
or off using the auxiliary heating / heater
booster switch inside the vehicle
(\2page 140).
It is advisable to have the batteries
changed at an authorized Sprinter Dealer.You need two CR 2025 3 V cell batteries or
equivalent.
Do not touch the battery contact surfaces.Warning
G
Keep batteries away from children.
Consult a doctor immediately if a battery is
swallowed.
Dispose of used batteries in an environmen-
tally responsible manner.
Danger of explosion if the battery is not cor-
rectly replaced.
Replacements should always be either of
the same type or one which has been rec-
ommended by the manufacturer.
Environmental note
H
Batteries contain materials that can harm
the environment if disposed of improperly.
Recycling of batteries is the preferred meth-
od of disposal. Many states require sellers
of batteries to accept old batteries for recy-
cling.iAlways replace all the batteries at the
same time. Suitable batteries are avail-
able from an authorized Sprinter Deal-
er. You can also have the batteries
changed there and return used batter-
ies.
Remote control
(remote keyless entry)iWhen inserting the batteries, make
sure that they are clean and lint-free.!
CAUTION
Do not operate the remote control
while the battery is being replaced.

316 Practical hintsChanging the batteries
5
1Battery cover
2Release button for mechaniocal key
\1Release the mechanical key by press-
ing the release button2.
\1Remove the battery cover1.\1Remove the battery and install a new
one (note correct polarity; positive ter-
minal up).
\1Press battery cover1 until it snaps
into place.
\1Check the function of all remote con-
trol buttons on vehicle.You need three Micro / AAA / LR03 batter-
ies or equivalent.
1Battery cover
2Batteries
\1Remove battery cover1 using a suit-
able implement, for example a key, and
put it to one side.
\1Remove old batteries2.
\1Insert three new batteries2. Observe
the plus and minus signs in the remote
control.
\1Slide battery cover1 onto the remote
control as illustrated.
\1
Check the auxiliary heating functions on
the vehicle using the remote control.Auxiliary heating remote control*
N83.00-2062-31

318 Practical hintsFuel system
5
\1Drain the fuel filter again if the/ in-
dicator lamp remains lit.If the fuel tank on a vehicle with diesel en-
gine has been run dry, there is a possibility
that the engine may not start immediately
after refueling because air may remain in
the fuel system.
After refueling:
\1Switch on the ignition for approximate-
ly 10 seconds.
\1Start the engine repeatedly for no more
than 60 seconds until it runs smoothly.If the engine does not start:
\1Wait approximately 2 minutes.
\1Then start the engine repeatedly again
for no more than 60 seconds until it
runs smoothly.
If this attempt also fails, do not continue to
start the engine. Consult an authorized
Sprinter Dealer.Environmental note
H
Have the drained liquid disposed of at an
authorized Sprinter Dealer.!
CAUTION
If the / indicator lamp remains lit
even after draining for the second time,
have the cause checked immediately at
an authorized Sprinter Dealer.
Bleeding the fuel systemiToo many attempts to start the engine
could drain the battery.

335 Practical hints
Battery
5
\3 BatteryYour vehicle may be equipped with two
batteries, depending on the equipment
version:
\4Starter battery in the battery recess in
the driver’s footwell
\4Auxiliary battery* in the engine com-
partmentHave the batteries removed at an autho-
rized Sprinter Dealer which has the neces-
sary specialist knowledge and tools to
carry out the work required.
The manufacturer recommends that you
use an authorized Sprinter Dealer for this
purpose.
\1Switch off all electrical consumers.
iThe auxiliary battery* in the engine
compartment is not suitable for jump-
starting operations. Only use the jump-
starting connection in the engine com-
partment if you require jump-starting
assistance or wish to provide jump-
starting assistance (\2page 340).Warning
G
Observe the safety notes in the “Operation”
section (\2page 195).
Do not place any metal objects on the bat-
tery. Doing so can cause a short circuit.
Use only impact-resistant batteries with a
central gas release cover to prevent corro-
sion damage and to protect occupants from
caustic burns in the event of an accident.Disconnecting the batteryWarning
G
There is a risk of a short circuit if the positive
terminal of the connected battery comes
into contact with vehicle parts. The highly
explosive gas mixture could ignite as a re-
sult. You and others could be seriously in-
jured as a result.
\4Do not place any metal objects or tools
on the batteries.
\4When disconnecting the batteries, al-
ways disconnect the negative terminals
first and then the positive terminals.
\4When reconnecting the batteries, al-
ways reconnect the positive terminals
first and then the negative terminals.
\4Do not loosen or disconnect the termi-
nal clamps on the batteries while the en-
gine is running.!
CAUTION
Switch off the engine and take the key
out of the ignition lock before you loos-
en or disconnect the terminal clamps.
You may otherwise destroy electronic
components such as the alternator.
Always disconnect the starter battery
in the battery recess in the driver’s
footwell first.

336 Practical hintsBattery
5
Disconnecting the starter battery
The starter battery is in the battery recess
in the driver’s footwell.
Removing/installing the floor covering
in the driver's footwell
1Floor covering
2Trim
3Securing screws
\1To remove: undo screws3 and re-
move trim2.
\1Remove floor covering1.\1To install: place floor covering 1 into
the driver’s footwell.
\1Push floor covering1 under the plate
metal bracket of the accelerator pedal
and align it with the driver’s seat base
and the doorway
Make sure the floor covering does not
obstruct the accelerator’s range of
movement.
\1Position trim2 and screw screws3
back in.Removing the battery cover in the
driver’s footwell
1Cover
2Securing screws
\1Undo screws2 and slide cover1 in
the direction of the arrow.
The screws must protrude beyond the
recesses.
Warning
G
The movement of the pedals must not be ob-
structed. The vehicle’s operating and road
safety are otherwise jeopardized.
Make sure to push the floor covering under
the plate metal bracket of the accelerator
pedal. The floor covering may not slip bet-
ween the bracket and the accelerator pedal.
Otherwise, you may not be able to fully
depress the accelerator pedal, which will
restrict the vehicle’s acceleration capability,
for example when passing another vehicle.

337 Practical hints
Battery
5
\1Remove cover1 upward.Starter battery in the driver’s footwell\1Loosen the negative terminal of the
battery first and remove it so that the
negative terminal cannot come into
contact with the pole terminal.
\1Remove the cover from the positive ter-
minal.
\1Loosen the positive terminal and fold
the positive terminal and the prefuse
box up to the side.Disconnecting the auxiliary battery*
\1Open the hood (\2page 185).
Auxiliary battery in the engine compart-
ment\1Loosen the negative terminal of the
battery first and remove it so that the
negative terminal cannot come into
contact with the pole terminal.
\1Remove the cover from the positive ter-
minal.
\1Loosen the positive terminal and re-
move it.Starter battery
\1Disconnect the battery (\2page 337).
1Central gas release cover connection
2Vent hose with connection angle
\1Pull vent hose with connection angle
2 from connection1 of the gas re-
lease cover.
Removing the battery

338 Practical hintsBattery
5
3Retainer
\1Loosen the bolts of retainer3 pre-
venting the battery from moving
around.\1Pull retainer3 upward and slide the
battery out of its anchorage in the di-
rection of travel.
\1Fold the clip upward and remove the
battery from the battery recess.Auxiliary battery* in the engine com-
partment
\1Disconnect the battery (\2page 337).
\1Unscrew the bolts preventing the bat-
tery from moving around in the engine
compartment.
\1Remove the battery retainer and take
out the battery.