2007 DODGE RAM 1500 GAS seat adjustment

▫Reclining Seats
(1500 Standard And Quad Cab Models).....150
▫Reclining Seats
(2500/3500/Mega Cab Models)...........151
▫Adjustable Head Restraints..............151
▫Manual Rotary Lumbar Support Adjustment —
If Equipped.........................152
▫Power Seats (1500 Standard And Quad Cab
Models) — If Equipped.................153
▫Power Seats (2500/3500/Mega Cab Models) —
If Equipped.........................154
▫Rear Seat Features — Mega Cab Models.....156
▫Heated Seats — If Equipped.............161

To Open And Close The Hood.............163

Lights...............................164▫Interior Lights.......................165
▫Battery Saver........................166
▫Headlamp Delay......................166
▫Headlights, Parking Lights, Panel Lights.....166
▫Daytime Running Lights
(Canada Only And Fleet Vehicles)..........167
▫Lights-On Reminder...................168
▫Fog Lights — If Equipped...............168
▫Cargo Light — If Equipped..............168
▫Multifunction Control Lever..............169

Windshield Wipers And Washers............171
▫Windshield Wipers....................171
▫Windshield Washers...................172
116 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

40-20-40 Front Seat
As the name implies, the seat is divided into 3 segments.
The outboard seat portions are each 40% of the total
width of the seat. The back of the center portion (20%)
easily folds down to provide an armrest/center storage
compartment (if equipped).Each outboard seat is independently adjustable forward
or rearward and is equipped with a back recliner. The
manual forward or rearward seat adjustment handle is
found at the front edge of each seat cushion. Pull up on
the handle and slide the seat to get the most comfortable
position.
WARNING!
Adjusting a seat while the vehicle is moving is
dangerous. The sudden movement of the seat could
cause you to lose control. The seat belt might not be
properly adjusted and you could be injured. Adjust
any seat only while the vehicle is parked.
Manual Seat Adjuster
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149
3

To lower the head restraint, push in the button and then
push down on the head restraint.Manual Rotary Lumbar Support Adjustment — If
Equipped
Rotating the lumbar control knob on the left side of the
driver’s seatback and on the right side of the passenger’s
seatback increases or decreases the lumbar (lower back)
support.
Head Restraints
Manual Lumbar Adjustment
152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

The power seat controls are on the outboard side of the
front seat cushions. Three switches control the seat move-
ment. The four-way switch in the center can be moved
forward or backwards to get the most comfortable posi-
tion. The same switch can be moved up and down to
control seat height. Change the seat angle by using the
two toggle switches, tilting it up or down.Rear Seat Features — Mega Cab Models
Reclining Rear Seats — Mega Cab Models
The recliner handle is on the outside of the seat cushion.
Pull up on the handle, as shown, to release the seat back
and adjust for comfort.
Tilt Adjustment
Rear Seat Recliner Handle
156 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

DRIVER ADJUSTABLE PEDALS — IF EQUIPPED
The power adjustable accelerator and brake pedals allow
the driver to establish a comfortable position relative to
the steering wheel and pedals.
Adjustment
1. Position the driver seat so that you are at least 10
inches (254 mm) away from the airbag located in the
center of the steering wheel.
2. Fasten and adjust the seatbelts.
3. Move the adjustable pedal switch, located to the left of
the steering column near the parking brake release, in the
direction you desire to move the pedals.
4. The pedalscannotbe adjusted when the vehicle is in
R (Reverse) or when the Speed Control is SET.
Adjustable Pedals Switch
174 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

quality filters should be used to assure most efficient
service. Mopar Engine Oil Filters are a high quality oil
filter and are recommended.
Drive Belts — Check Condition and Tension
Belt tension is controlled by means of an automatic
tensioner. No belt tension adjustments are required.
However, belt and belt tensioner condition should be
inspected at the specified intervals and replaced if re-
quired. See your authorized dealer for service.
At the mileage indicated in the maintenance schedule, all
belts and tensioner should be checked for condition.
Improper belt tension can cause belt slippage and failure.
Belts should be inspected for evidence of cuts, cracks,
glazing or frayed cords and replaced if there is indication
of damage which could result in belt failure. Low gen-
erator belt tension can cause battery failure.Also check belt routing to make sure there is no interfer-
ence between the belts and other engine components.
Spark Plugs
Spark plugs must fire properly to assure engine perfor-
mance and emission control. New plugs should be in-
stalled at the specified mileage. The entire set should be
replaced if there is any malfunction due to a faulty spark
plug, malfunctioning spark plugs can damage the cata-
lytic converter. For proper type of replacement spark
plugs, refer to the “Vehicle Emission Control Informa-
tion” label in the engine compartment.
Spark Plug Wires
The spark plug wires should be kept clean and properly
connected. Terminals should be fully seated. Cracked,
damaged, or faulty wires should be replaced.
458 MAINTAINING YOUR VEHICLE

Brake System
Power Disc Brakes (front and rear)
Disc brakes do not require adjustment; however, several
hard stops during the break-in period are recommended
to seat the linings and wear off any foreign material.
Brake And Power Steering Hoses
When the vehicle is serviced for scheduled maintenance,
inspect surface of hoses and nylon tubing for evidence of
heat and mechanical damage. Hard and brittle rubber,
cracking, tears, cuts, abrasion, and excessive swelling
indicate deterioration of the rubber. Particular attention
should be made to examining those hose surfaces nearest
to high heat sources, such as the exhaust manifold.
Insure nylon tubing in these areas has not melted or
collapsed.Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
NOTE:Often, fluid such as oil, power steering fluid,
and brake fluid are used during assembly plant opera-
tions to facilitate the assembly of hoses to couplings.
Therefore, oil wetness at the hose-coupling area is not
necessarily an indication of leakage. Actual dripping of
hot fluid when systems are under pressure (during
vehicle operation), should be noted before hose is re-
placed based on leakage.
NOTE:Inspection of brake hoses should be performed
whenever the brake system is serviced and every engine
oil change. Inspect hydraulic brake hoses for surface
cracking, scuffing, or worn spots. If there is any evidence
of cracking, scuffing, or worn spots, the hose should be
replaced immediately! Eventual deterioration of the hose
can take place resulting in a possibility of a burst failure.
MAINTAINING YOUR VEHICLE 475
7

Remote Keyless Entry (RKE)................. 20
Remote Sound System (Radio) Controls........ 280
Remote Starting System.................... 24
Replacement Tires....................... 373
Reporting Safety Defects................... 545
Restraint, Head......................... 151
Restraints, Child..................60,67,99,106
Rotation, Tires.......................... 377
Safety Checks Inside Vehicle................ 219
Safety Checks Outside Vehicle............... 219
Safety Defects, Reporting.................. 545
Safety Information, Tire................... 358
Safety Tips............................ 217
Satellite Radio.......................... 275
Satellite Radio Antenna................... 279
Schedule, Maintenance.................... 518
Seat Belt Maintenance.................... 491
Seat Belt Reminder.....................44,84Seat Belts.....................33,34,72,73,219
Adjustable Upper Shoulder Anchorage......42,81
And Pregnant Women.................46,85
Child Restraint..................60,72,99,111
Extender...........................46,85
Front Seat..........................34,73
Pretensioners........................44,83
Reminder............................ 228
Seats..............................148,149
Adjustment.......................... 148
Child.............................72,111
Folding Floor......................... 210
Heated............................. 161
Lumbar Support....................... 152
Power...........................153,154
Rear Folding.......................157,158
Reclining.........................150,151
Reclining Rear........................ 156
Security Alarm (Theft Alarm).............18,230
562 INDEX