Page 336 of 436

▫Air Conditioner Maintenance.............351
▫Power Steering Fluid Check..............352
▫Driveline And Steering Component
Lubrication..........................353
▫Body Lubrication.....................353
▫Windshield Wiper Blades................354
▫Windshield Washers...................354
▫Exhaust System......................355
▫Cooling System.......................355
▫Hoses And Vacuum/Vapor Harnesses.......360
▫Brake System........................361
▫Automatic Transmission................363
▫Hydraulic Clutch Fluid — Manual
Transmission........................364▫Manual Transmission..................364
▫Transfer Case........................365
▫Front/Rear Axle Fluid..................366
▫Appearance Care And Protection
From
Corrosion...........................366
Fuses (Integrated Power Module)...........371
Replacement Light Bulbs.................378
Bulb Replacement......................379
▫Head Light..........................379
▫Left Front Turn Signal..................379
▫Right Front Turn Signal.................379
▫Front Side Marker.....................380
▫Front Fog Light (Front Fascia Mounted).....380
336 MAINTAINING YOUR VEHICLE
Page 342 of 436

4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off the
ignition key or start the engine. This means that your
vehicle’s OBD system isnot readyand you shouldnot
proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or start
the engine. This means that your vehicle’s OBD system
isreadyand you can proceed to the I/M station.
If your OBD system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
Regardless of whether your vehicle’s OBD system is
ready or not ready, if the MIL symbol is illuminated
during normal vehicle operation, you should have your
vehicle serviced before going to the I/M station. The I/M
station can fail your vehicle because the MIL symbol is on
with the engine running.
REPLACEMENT PARTS
Use of genuine Moparparts for normal/scheduled
maintenance and repairs is highly recommended to in-
sure the designed performance. Damage or failures
caused by the use of non-Moparparts for maintenance
and repairs will not be covered by the manufacturer’s
warranty.
342 MAINTAINING YOUR VEHICLE
Page 378 of 436

CAUTION!
•When installing the Integrated Power Module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the Integrated Power
Module, and possibly result in a electrical system
failure.
•When replacing a blown fuse, it is important to
use only a fuse having the correct amperage
rating. The use of a fuse with a rating other than
indicated may result in a dangerous electrical
system overload. If a properly rated fuse contin-
ues to blow, it indicates a problem in the circuit
that must be corrected.
REPLACEMENT LIGHT BULBS
LIGHT BULBS — Interior Bulb No.
Dome Light........................ WL212–2
Liftgate Lamp........................... 567
Overhead Console Lights............. PLW214–2A
Reading Light....................... WL212–2
LIGHT BULBS — Outside Bulb No.
Headlight..........................9008 H13
Front Park/Turn......................3157AK
Front Sidemarker......................... 168
Back-Up.............................4057K
Center High Mounted Stoplight.............. 921
Fog Lamp.......................... H109145
License Plate Light....................... 168
Rear Tail, Stop, Turn Signal................4057K
378 MAINTAINING YOUR VEHICLE
Page 379 of 436

BULB REPLACEMENT
Head Light
1. Open the hood.
2. Reach behind the headlamp unit in the engine com-
partment to access the headlamp bulb lock ring.
3. Firmly grasp the lock ring on the back of the headlamp
unit housing.
4. Rotate the lock ring on the back of the headlamp
housing counter-clockwise to unlock it.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean
the bulb with rubbing alcohol.
5. Disconnect the electrical connector and replace the
bulb.
Left Front Turn Signal
1. Turn the steering wheel all the way to the right (full
right lock).
2. Remove the door in the left wheel liner by twisting
counter clockwise. Access to the bulb can be gained
through the wheel liner hole.
3. Disconnect the electrical connector.
4. Twist the bulb counter clockwise to remove.
Right Front Turn Signal
1. Open the hood.
2. Reach behind the headlamp unit in the engine com-
partment to access the turn signal bulb.
3. Twist the bulb counter clockwise to remove.
MAINTAINING YOUR VEHICLE 379
7
Page 380 of 436

4. Disconnect the electrical connector and replace the
bulb.
Front Side Marker
1. Open the hood.
2. Remove the grille assembly, as follows:
a. Remove eight fasteners.
b. Remove two screws from each headlamp.
c. Remove two scrivets from the center of the grille.
d. Remove one push pin from the top of each fender.
e. Pull the grille assembly toward you to disconnect
the grille clips to the fender and the headlamp ball-
studs to the front end module.
3. Disconnect electrical connector.
4. Turn the bulb counterclockwise to remove.
Front Fog Light (Front Fascia Mounted)
1. Reach between the front fascia and wheel liner from
under the vehicle.
2. Turn the front fog light bulb 1/4 turn counter clock-
wise to remove from housing.
3. Disconnect the electrical connector and replace bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean
the bulb with rubbing alcohol.
380 MAINTAINING YOUR VEHICLE
Page 381 of 436
Rear Tail, Stop, Turn Signal, and Back-Up Lights
1. Open the lift gate.
2. Remove the two push pins.
3. Pull lamp straight back and disconnect electrical con-
nection.
4. Remove the two screws attaching the backplate to the
lamp assembly.
5. Pull the backplate straight back from the lamp hous-
ing.
6. Disconnect the electrical connector.
7. Remove the bulb from the backplate.
Center High Mounted Stop Light (CHMSL)
1. Remove the two screws securing the CHMSL.
2. Disconnect the electrical connector and washer hose (if
equipped) from CHMSL.
3. Replace the CHMSL.
MAINTAINING YOUR VEHICLE 381
7
Page 421 of 436

Autostick............................. 256
Auxiliary Electrical Outlet (Power Outlet)...... 144
Auxiliary Power Outlet................... 144
AxleFluid ............................. 384
Battery............................... 351
Charging............................ 332
Emergency Starting..................... 332
Gas Caution.......................... 332
Keyless Transmitter Replacement (RKE)....... 24
Belts,Drive ............................ 347
Belts, Seat.............................. 38
Body Mechanism Lubrication............... 353
B-Pillar Location........................ 274
Brake Assist System...................... 129
Brake Control System, Electronic............. 128
Brake Fluid............................ 384
Brake System........................... 361
Anti-Lock (ABS)....................128,265Hoses.............................. 361
Master Cylinder....................... 362
Parking............................. 263
Warning Light.....................167,169
Brake/Transmission Interlock............... 249
Break-In Recommendations, New Vehicle........ 74
Bulb Replacement....................... 379
Bulbs,Light ............................ 378
Calibration, Compass..................178,184
Capacities, Fluid........................ 382
Caps, Filler
Fuel................................ 300
Power Steering........................ 352
Car Washes............................ 367
Carbon Monoxide Warning............... 74,299
Cargo Area Features...................... 150
Cargo Compartment...................... 150
Light ............................... 150
INDEX 421
10
Page 426 of 436

Gauges
Coolant Temperature.................... 164
Fuel................................ 164
Odometer........................... 172
Speedometer......................... 166
Tachometer.......................... 170
Gear Ranges......................245,249,255
General Information.................... 19,295
Glass Cleaning.......................... 370
Gross Axle Weight Rating.................. 307
Gross Vehicle Weight Rating................ 306
GVWR ............................... 303
Hands-Free Phone (UConnect™).............. 84
Hazard Warning Flasher................... 324
Head Restraints......................... 113
Head Rests............................ 113
Headlights
Bulb Replacement...................... 379Dimmer Switch....................... 120
Replacing............................ 379
Switch .............................. 120
Heated Seats........................... 113
Heater, Engine Block..................... 243
High Beam Indicator..................... 166
Hitches
TrailerTowing ........................ 310
Holder,Cup ........................... 147
HomeLink(Garage Door Opener) Transmitter . . . 134
Hood Release.......................... 117
Hoses.............................360,361
Hydraulic Clutch Fluid.................... 364
Ignition............................... 14
Key ................................. 14
Ignition Key Removal..................... 14
Illuminated Entry........................ 20
Infant Restraint........................ 64,65
426 INDEX