2007 CHRYSLER PT CRUISER battery replacement

NTo Unlock The Doors And Liftgate..........24
NTo Lock The Doors And Liftgate
(If Equipped With Power Options)..........25
NUsing The Panic Alarm..................25
NTo Turn Off ªFlash Lights With Lockº........26
NProgramming Additional Transmitters........26
NGeneral Information....................28
NBattery Replacement....................28
mRemote Keyless Entry (Convertible)...........30
NTo Unlock The Doors...................30
NTo Lock The Doors.....................31
NTo Unlatch The Deck Lid.................32
NPanic Alarm..........................32NUsing The Panic Alarm..................32
NTo Turn Off ªFlash Lights With Lockº........32
NTo Program Additional Transmitters.........33
NGeneral Information....................34
NTransmitter Battery Service...............34
mSecurity Alarm System Ð If Equipped.........35
NTo Set The Alarm......................36
NTo Disarm The System...................36
NSecurity System Manual Override...........37
mLiftgate (Sedan).........................37
mDeck Lid (Convertible)....................39
NPower Deck Lid Release (Convertible)........40
mEmergency Seat Back Release (Sedan).........40
10 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

14. Your vehicle will remain in program mode up to 60
seconds from when the original chime was heard. After
60 seconds, all programmed fobs function normally.
NOTE:If you do not have a programmed transmitter,
contact your dealer for details.
General Information
This device complies with part 15 of FCC rules and with
RS-210 of Industry Canada. Operation is subject to the
following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be
received including interference that may cause undesired
operation.
NOTE:Changes or modifications not expressly ap-
proved by the party responsible for compliance could
void the user's authority to operate the equipment.If your Remote Lock Control fails to operate from a
normal distance, check for these two conditions.
1. Weak batteries in transmitter. The expected life of
batteries is five years.
2. Closeness to a radio transmitter such as a radio station
tower, airport transmitter, military base, and some mobile
or CB radios.
Battery Replacement
NOTE:Perchlorate Material ± special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate.º
The recommended replacement battery is CR2032.
1. If the key fob is equipped with a screw, remove the
screw. With the transmitter buttons facing down, use a
28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

3.Program Each Transmitter:All transmitters to be used
with your vehicle must be programmed as follows:
Press and release the9Lock9and9Unlock9buttons simul-
taneously, followed by a press and release of ANY button
on each transmitter to be programmed. You will hear a
chime when a transmitter has been successfully pro-
grammed.
General Information
This transmitter complies with FCC rules part 15 and
with RSS-210 of Industry Canada. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be
received, including interference that may cause undes-
ired operation.If your Remote Keyless Entry fails to operate from a
normal distance, check for these two conditions:
1. Weak batteries in transmitter. The expected life of
batteries is from one to two years
2. Closeness to a radio transmitter such as a radio station
tower, airport transmitter, and some mobile or CB radios.
Transmitter Battery Service
NOTE:Perchlorate Material ± special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate.º
The recommended replacement battery is the Panasonic
CR2032 or equivalent.
1. Pry the transmitter halves apart with a dime or similar
object. Make sure not to damage the rubber gasket
material during removal.
34 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

NMaintenance-Free Battery................375
NAir Conditioner Maintenance.............377
NPower Steering Ð Fluid Check............378
NFront Suspension Ball Joints..............379
NBody Lubrication.....................379
NWindshield Wiper Blades................380
NWindshield Washer Reservoir.............380
NExhaust System......................380
NCooling System.......................381
NHoses And Vacuum/Vapor Harnesses.......386
NFuel System Connections................387
NBrake System........................387
NAutomatic Transaxle...................390NManual Transaxle.....................393
NAppearance Care And Protection From
Corrosion...........................393
mConvertible Top Care....................398
NWashing............................399
NGeneral Cleaning.....................399
NCloth Top Additional Cleaning Procedure....400
NCloth Top Protection...................400
NWeather Strip Care....................400
mIntegrated Power Module (IPM)............400
mVehicle Storage........................404
mReplacement Bulbs......................405
mBulb Replacement......................406
360 MAINTAINING YOUR VEHICLE

a9clicking9sound is heard. This is an indication that the
gas cap is properly tightened. Press the odometer reset
button to turn the message off. If the problem persists,
the message will appear the next time the vehicle is
started. This might indicate a damaged cap. If the prob-
lem is detected twice in a row, the system will turn on the
Malfunction Indicator Light (MIL). Resolving the prob-
lem will turn the MIL light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle's emissions control system.
Failure to pass could prevent vehicle registration.
For states, which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Light)is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test,
which you can use prior to going to the test station. To
check if your vehicle's OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
MAINTAINING YOUR VEHICLE 365
7

4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off the
ignition key or start the engine. This means that your
vehicle's OBD system isnot readyand you shouldnot
proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or start
the engine. This means that your vehicle's OBD system
isreadyand you can proceed to the I/M station.
If your OBD system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
Regardless of whether your vehicle's OBD system is
ready or not ready, if the MIL symbol is illuminated
during normal vehicle operation, you should have your
vehicle serviced before going to the I/M station. The I/M
station can fail your vehicle because the MIL symbol is on
with the engine running.
REPLACEMENT PARTS
Use of genuine Mopartparts for normal/scheduled
maintenance and repairs is highly recommended to in-
sure the designed performance. Damage or failures
caused by the use of non-Mopartparts for maintenance
and repairs will not be covered by the manufacturer's
warranty.
366 MAINTAINING YOUR VEHICLE

Special Additives...................... 392
Autostick............................. 288
Back-Up Lights......................... 408
Ball Joints............................. 379
Battery............................... 375
Keyless Transmitter Replacement (RKE).....28,34
Belts, Drive............................ 372
Belts, Engine........................... 374
Body Mechanism Lubrication............... 379
Boot, Convertible Top..................124,128
B-Pillar Location........................ 306
Brake Fluid............................ 412
Brake, Parking.......................... 294
Brake System........................295,387
Anti-Lock (ABS)....................... 296
Hoses.............................. 387
Master Cylinder....................... 388
Parking............................. 294Warning Light........................ 227
Brakes.............................295,387
Brake/Transmission Interlock............... 284
Break-In Recommendations, New Vehicle....... 112
Bulb Replacement.....................405,406
Bulbs, Light............................ 405
Calibration, Compass..................... 239
Capacities, Antifreeze (Engine Coolant)........ 410
Capacities, Fluid........................ 410
Caps, Filler
Fuel................................ 325
Oil (Engine)....................362,363,370
Car Washes............................ 394
Carbon Monoxide Warning................. 325
Cargo Compartment
Luggage Carrier....................... 213
Carrier, Luggage........................ 213
Catalytic Converter...................... 372
INDEX 451
10

Dimmer Switch, Headlight............... 181
Engine Temperature Warning.............. 228
Fog ..........................183,229,407
Front Replacement..................... 406
Headlight Switch...................... 182
Headlights........................... 182
High Beam Indicator.................... 230
Instrument Cluster..................... 182
Lights On Reminder.................... 183
Low Fuel............................ 229
Malfunction Indicator (Check Engine)........ 226
Map Reading......................180,181
Oil Pressure.......................... 229
Rear Servicing........................ 407
Seat Belt Reminder..................... 228
Security Alarm (Theft Alarm).............. 36
Service.............................. 406
Theft Alarm (Security Alarm).............. 228
Traction Control....................... 301Turn Signal..................181,184,226,407
Voltage............................. 228
Warning (Instrument Cluster Description)..... 224
Loading Vehicle......................... 328
Tires ............................... 306
Locks
Child Protection........................ 22
Door................................ 18
Power Door........................... 20
Steering Wheel......................... 18
Lubrication, Body....................... 379
Luggage Rack (Roof Rack)................. 213
Lumbar Support........................ 162
Maintenance Free Battery.................. 375
Maintenance, General..................... 367
Maintenance Procedures................... 367
Maintenance Schedule
Schedule ªAº-Non Turbo................. 428
458 INDEX