Page 92 of 456
The following functions may be available if your
vehicle has the remote keyless entry system:
/(Remote Vehicle Start):If your vehicle has
this feature, it may be started from outside
the vehicle using the remote keyless entry
transmitter. See “Remote Vehicle Start” following
for more detailed information.
Q(Lock):Press the lock button to lock all the
doors. If enabled through the Driver Information
Center (DIC), the parking lamps will ash once
to indicate locking has occurred. If enabled through
the DIC, the horn will chirp when the lock button
is pressed again within ve seconds of the
previous press of the lock button. SeeDIC Vehicle
Customization on page 203for additional
information. Pressing the lock button may arm the
content theft-deterrent system. SeeContent
Theft-Deterrent on page 105.
"(Unlock):Press the unlock button to unlock
the driver’s door. If the button is pressed again
within ve seconds, all remaining doors will unlock.
The interior lamps will come on and stay on for
20 seconds or until the ignition is turned on. If
enabled through the DIC, the parking lamps will
ash once to indicate unlocking has occurred. See
DIC Vehicle Customization on page 203. Pressing
the unlock button on the remote keyless entry
transmitter will disarm the content theft-deterrent
system. SeeContent Theft-Deterrent on page 105.Remote Keyless Entry
with Remote StartRemote Keyless Entry
without Remote Start
92
Page 93 of 456
V(Remote Trunk Release):Press and hold
this button for about one second to release the
trunk lid. The transaxle must be in PARK (P) for
this feature to operate.
L(Vehicle Locator/Panic Alarm):Press and
release this button to locate your vehicle. The turn
signal lamps will ash and the horn will sound
three times. Press and hold this button for more
than two seconds to activate the panic alarm.
The turn signal lamps will ash and the horn will
sound repeatedly for 30 seconds. The alarm
will turn off when the ignition is turned to RUN or
the alarm button is pressed again. The ignition
must be in OFF for the panic alarm to work.
Matching Transmitter(s) to Your
Vehicle
Each remote keyless entry transmitter is coded
to prevent another transmitter from unlocking
your vehicle. If a transmitter is lost or stolen, a
replacement can be purchased through your
GM dealer. Remember to bring any additional
transmitters so they can also be re-coded to
match the new transmitter. Once your dealer has
coded the new transmitter, the lost transmitter
will not unlock your vehicle. The vehicle can have
a maximum of eight transmitters matched to it.
See Remote Key underDIC Operation and
Displays on page 187.
93
Page 94 of 456
Battery Replacement
Under normal use, the battery in your remote
keyless entry transmitter should last about
four years.
You can tell the battery is weak if the transmitter
will not work at the normal range in any location.
If you have to get close to your vehicle before
the transmitter works, it is probably time to change
the battery.
The REPLACE BATTERY IN REMOTE KEY
message in the vehicle’s DIC will display if the
remote keyless entry transmitter battery is
low. See “REPLACE BATTERY IN REMOTE KEY”
underDIC Warnings and Messages on page 195
for additional information.
Notice:When replacing the battery, use care
not to touch any of the circuitry. Static
from your body transferred to these surfaces
may damage the transmitter.To replace the battery in the remote keyless entry
transmitter do the following:
1. Use a at object with a thin edge into the
notch, located below the trunk release
button, and separate the bottom half from the
top half of the transmitter.
2. Remove the old battery, but do not use a
metal object to do this.
94
Page 95 of 456
3. Slide the new battery into the transmitter with
the positive side of the battery facing down.
Use a type CR2032 battery, or equivalent
type. Make sure the cover is on tightly,
so water will not get in.
4. Snap the front and the back of the transmitter
together.
5. Test the operation of the transmitter with the
vehicle.
Remote Vehicle Start
Your vehicle may have a remote starting feature.
This feature allows you to start the engine
from outside of the vehicle.
If your vehicle has an outside temperature display,
during remote start this feature allows the
climate control system to default to a heating
mode during colder outside temperatures and a
cooling mode during warmer outside temperatures.
If your vehicle does not have an outside
temperature display, during remote start the
climate control system will turn on at the setting
the vehicle was set to when the vehicle was
last turned off.Laws in some communities may restrict the use of
remote starters. For example, requiring a person
using remote start to have the vehicle in view
when doing so. Check local regulations for
any requirements on remote starting of vehicles.
Do not use the remote start feature if your vehicle
is low on fuel. Your vehicle may run out of fuel.
Your remote keyless entry transmitter, with
the remote start button, provides an increased
range of operation. However, the range may
be less while the vehicle is running. As a result,
you may need to be closer to your vehicle to turn it
off, than you were to turn it on.
There are other conditions which can affect the
performance of the transmitter, seeRemote
Keyless Entry (RKE) System on page 90for
additional information.
/(Remote Start):Press and release the lock
button and then press and hold this button to use
the remote start feature.
95
Page 96 of 456
To start the vehicle using the remote start feature,
do the following:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter’s lock
button, then immediately press and hold
the transmitter’s remote start button until the
turn signal lights ash or if the vehicle’s
lights are not visible, press and hold the
remote start button for at least four seconds.
The vehicle’s doors will lock. Pressing the
remote start button again after the vehicle has
started will turn off the ignition.
3. When the vehicle starts, the parking lamps
will turn on and remain on while the vehicle
is running.
4. If it is your rst remote start since last driving,
repeat these steps while the engine is still
running for a 10 minute time extension.
When you enter the vehicle during a remote
start, and the engine is still running, turn the
key to the RUN position to drive the vehicle.If the vehicle is left running it will automatically
shut off after 10 minutes unless a time extension
has been done.
To manually shut off a remote start, do any of the
following:
Aim the remote keyless entry transmitter at
the vehicle and press the remote start
button until the parking lamps turn off.
Turn on the hazards warning ashers.
Turn the ignition switch on and then off.
The remote vehicle start feature provides
two separate starts, each with 10 minutes of engine
running, or it provides one start with 10 minutes
of engine running that may be extended with
10 more minutes. If you press and release the
transmitter lock button and then press and
hold the remote start button, on the remote
keyless entry transmitter, again before the rst
10 minutes of engine running time has expired,
10 minutes are added to the remaining minutes.
96
Page 97 of 456
For example, if the lock button and then the remote
start buttons are pressed again after ve minutes
of the engine run time, 10 minutes are added and
you now have 15 minutes of engine running. The
added ten minutes are considered a second remote
vehicle start. Once two remote starts or a single
start with a time extension have been provided, the
vehicle must be started normally with the ignition
key to get more remote vehicle starts.
The remote vehicle start feature will not operate if
the key is in the ignition, the hood is not closed or if
there is an emission control system malfunction.
Also, the engine will turn off during a remote
vehicle start if the coolant temperature gets too
high or if the oil pressure gets low.
Vehicles equipped with the remote vehicle start
feature are shipped from the factory with the
remote vehicle start system enabled. The system
may be enabled or disabled through the DIC.
See “REMOTE START” underDIC Vehicle
Customization on page 203for additional
information.Remote Start Ready
If your vehicle does not have the remote vehicle
start feature, it may have the remote start
ready feature. This feature allows your dealer
to add the manufacturer’s remote vehicle
start feature.
If your vehicle has the remote start ready feature,
your remote keyless entry transmitter will have
extended range that will allow you to lock or unlock
your vehicle from about 195 feet (60 m) away.
See your dealer if you would like to add the
manufacturer’s remote vehicle start feature to
your vehicle.
97
Page 99 of 456
From the outside, use your key in the driver’s
door or the remote keyless entry transmitter,
if equipped. SeeRemote Keyless Entry (RKE)
System Operation on page 91. From the inside,
use the manual or power door locks.
To manually unlock the driver’s door from the
outside, insert the key and turn it toward the front
of the vehicle.
To manually lock the driver’s door from the
outside, insert the key and turn it toward the
rear of the vehicle.
To lock a door from the
inside, push the manual
lock lever forward.
To unlock a door, push
the lever rearward.Power Door Locks
A power door lock
switch is located on
each door above
the armrest.
Press the top of the switch to unlock both
doors, or press the bottom of the switch to lock
both doors.
If your vehicle has the optional content
theft-deterrent system and it is armed, the power
door lock switches will be disabled. You must
use your remote keyless entry transmitter,
if equipped, or your key to unlock the doors
while the system is armed.
99
Page 100 of 456
Automatic Door Lock
The doors will automatically lock when the shift
lever is moved out of PARK (P). The automatic
door locking feature cannot be disabled.
Programmable Automatic
Door Unlock
Your vehicle is programmed so that when the
shift lever is moved into PARK (P) all doors will
unlock.
With the vehicle stopped and the engine running,
door unlocking can be programmed through
prompts displayed on the Driver Information
Center (DIC). These prompts allow the driver to
choose various unlock settings. For programming
information, seeDIC Vehicle Customization
on page 203.
Lockout Protection
To protect you from locking your key in the
vehicle, this feature stops the power door locks
from locking while the key is in the ignition and
a door is open.
If a power lock switch is pressed while a door is
open and the key is in the ignition, both doors
will lock and then the driver’s door will unlock.
A chime will sound continuously until both doors
are closed.
100
