2007 CHEVROLET AVEO hood open

8. Release the spring that retains the bulb by
loosing the screw.
9. Remove the old bulb.
10. Install the new bulb.
11. Install the bulb retaining spring.
12. Reverse Steps 1 through 8 to install the
headlamp assembly.
Headlamps (Sedan)
To replace a headlamp bulb, do the following:
1. Open the hood. SeeHood Release on
page 274for more information.
2. Remove the three bolts from the
headlamp assembly.
3. Remove the headlamp assembly.
4. Disconnect the wiring harness connector from
the rear of the bulb.
5. Remove the headlamp cap.
311

3. Pull the front turn signal bulb socket out of the
lamp housing.
4. Press the bulb inward and turn it
counterclockwise to remove it from the
bulb socket.
5. Install the new bulb into the socket by
pressing it in and turning it clockwise.
6. Install the socket into the lamp housing by
turning it clockwise.
7. Reverse Steps 1 through 4 to install the
assembly.
Front Turn Signal and Parking
Lamps (Sedan)
To replace a front turn signal or parking lamp
bulb, do the following:
1. Open the hood. SeeHood Release on
page 274for more information.
2. Remove the headlamp assembly. See Steps 2
through 4 underHeadlamps (Hatchback) on
page 310orHeadlamps (Sedan) on page 311
for instructions on how to remove the
headlamp assembly.3. Turn the front turn signal bulb socket
counterclockwise.
4. Pull the front turn signal bulb socket out of the
lamp housing.
5. Press the bulb inward and turn it
counterclockwise to remove it from the
bulb socket.
313

6. Install the new bulb into the socket by
pressing it in and turning it clockwise.
7. Install the socket into the lamp housing by
turning it clockwise.
8. Reverse Steps 1 through 2 underHeadlamps
(Hatchback) on page 310orHeadlamps
(Sedan) on page 311to install the assembly.
Turn Signal Lamps (Side)
To replace a side turn signal bulb, do the following:
1. Open the hood. SeeHood Release on
page 274for more information.
2. See Steps 2 through 5 underHeadlamps
(Hatchback) on page 310orHeadlamps
(Sedan) on page 311to access the side turn
signal lamps.
3. Remove the side turn signal lamp assembly
by pulling it forward.
4. Turn the bulb socket counterclockwise.5. Remove the bulb from the lamp housing by
pulling the bulb straight out of the socket.
6. Install the new bulb into the bulb socket by
pushing it in and rotating the bulb socket
clockwise.
7. Push the side turn signal lamp assembly back
into its original position.
314

Part B: Owner Checks and Services
Listed in this part are owner checks and services
which should be performed at the intervals
specified to help ensure the safety, dependability
and emission control performance of your vehicle.
Be sure any necessary repairs are completed at
once. Whenever any fluids or lubricants are added
to your vehicle, make sure they are the proper
ones, as shown in Part D.
At Each Fuel Fill
It is important for you or a service station attendant
to perform these underhood checks at each fuel fill.
Engine Oil Level Check
Check the engine oil level and add the proper oil
if necessary. SeeEngine Oil on page 277for
further details.
Engine Coolant Level Check
Check the engine coolant level and add the proper
coolant mixture if necessary. SeeEngine Coolant
on page 287for further details.
Windshield Washer Fluid Level Check
Check the windshield washer fluid level in the
windshield washer fluid reservoir and add the
proper fluid if necessary. SeeWindshield Washer
Fluid on page 298for further details.
At Least Once a Month
Tire Ination Check
Inspect the tires and make sure the tires are inflated
to the correct pressures. Do not forget to check the
spare tire. SeeInflation - Tire Pressure on page 326.
At Least Twice a Year
Restraint System Check
Make sure the safety belt reminder light and all
your belts, buckles, latch plates, retractors
and anchorages are working properly. Look for
any other loose or damaged safety belt system
parts. If you see anything that might keep a safety
belt system from doing its job, have it repaired.
Have any torn or frayed safety belts replaced.
Also look for any opened or broken airbag
coverings, and have them repaired or replaced.
(The airbag system does not need regular
maintenance.)
389