2007 CADILLAC XLR keyless

Two personalized exit positions can be set by rst
recalling the driving position (by pressing 1 or 2),
then positioning the steering wheel and seat in the
desired exit positions and then pressing and
holding the exit button until two beeps are heard.
The exit button is located between buttons 1 and 2.
With the vehicle in PARK (P), the exit position
for the previously set driver can be recalled
by pressing the exit button.
When you use the keyless access transmitter to
unlock your vehicle, automatic seat and steering
wheel movement to the exit position may
occur. The numbers on the back of the
transmitter, 1 and 2, corresponds to the numbers
on the memory buttons.
Further programming for automatic seat and mirror
movement can be done using the Driver
Information Center (DIC).
For programming information, seeDIC Vehicle
Personalization on page 220.Power Reclining Seatbacks
Your seats have power
reclining seatbacks.
Use the vertical power seat control located on the
outboard side of the seat to operate them.
To recline the seatback, press the control
toward the rear of the vehicle.
To raise the seatback, press the control
toward the front of the vehicle.
11

Keys.............................................................. 65
Keyless Access System.............................. 67
Keyless Access System Operation.............. 68
Doors and Locks.......................................... 73
Door Locks................................................. 73
Power Door Locks....................................... 75
Automatic Door Lock................................... 76
Programmable Automatic Door Unlock........ 76
Lockout Protection....................................... 77
Trunk.......................................................... 77
Windows....................................................... 81
Power Windows.......................................... 82
Sun Visors.................................................. 84
Theft-Deterrent Systems............................... 84
Theft-Deterrent System................................ 84
Valet Lockout Switch................................... 86
Starting and Operating Your Vehicle........... 87
New Vehicle Break-In.................................. 87
Ignition Positions......................................... 88
Retained Accessory Power (RAP)............... 89
Starting the Engine..................................... 89
Automatic Transmission Operation............... 92
Parking Brake............................................. 97Shifting Into Park (P)................................... 99
Shifting Out of Park (P)............................. 100
Parking Over Things That Burn................. 101
Engine Exhaust......................................... 102
Running the Engine While Parked............. 103
Mirrors......................................................... 104
Automatic Dimming Rearview Mirror with
OnStar
®................................................. 104
Outside Power Heated Mirrors................... 105
Outside Automatic Dimming Mirror............. 105
Outside Curb View Assist Mirror................ 106
Outside Convex Mirror............................... 106
OnStar
®System.......................................... 107
Universal Home Remote System................ 110
Universal Home Remote System
(With One Triangular LED)..................... 110
Universal Home Remote System
(With Three Round LED)....................... 111
Universal Home Remote System
Operation (With Three Round LED)....... 112
Universal Home Remote System Operation
(With One Triangular LED)...................... 118
Section 2 Features and Controls
63

Keys
{CAUTION:
Leaving children unattended in a vehicle
is dangerous, but it is even more
dangerous if the keyless access
transmitter is also left in the vehicle. A
child or others could be badly injured or
even killed.
They could operate the power windows or
other controls or even make the vehicle
move. If they started the engine and
moved the shift lever out of PARK (P),
that would release the parking brake.
Do not leave the keyless access
transmitter in a vehicle with children.
65

This key, located inside
the keyless access
transmitter, can be used
for the glove box and
the trunk, if vehicle
power is lost. SeeTrunk
on page 77for more
information.
To remove the key,
press the button (A)
near the bottom of the
keyless access
transmitter, and pull the
key out. Never pull
the key out without
pressing the button.Your vehicle has a keyless access system with
pushbutton start. SeeIgnition Positions on page 88
for information on starting the vehicle.
Notice:If you ever lose your transmitter(s)
and/or key, it could be difficult to get into your
vehicle. You may even have to damage your
vehicle to get in. Be sure you have a spare
transmitter and/or key.
In an emergency, contact Cadillac Roadside
Assistance. SeeRoadside Service on page 487.
66

Keyless Access System
Your vehicle has a Keyless Access System that
operates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
and with Industry Canada.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.This device complies with RSS-210 of Industry
Canada. Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation of the device.
Changes or modications to this system by other
than an authorized service facility could void
authorization to use this equipment.
67

If you ever notice a decrease in the keyless
access transmitter range, try doing one of the
following:
Check the distance. You may be too far from
your vehicle. You may need to stand closer
during rainy or snowy weather.
Check the location. Other vehicles or objects
may be blocking the signal. Take a few steps
to the left or right, hold the transmitter
higher, and try again.
Check to determine if battery replacement is
necessary. See “Battery Replacement”
underKeyless Access System Operation on
page 68.
Check to make sure that an electronic device
such as a cellular phone or lap top computer
is not causing interference.
If you are still having trouble, see your dealer
or a qualied technician for service.
Keyless Access System Operation
Your vehicle has a Keyless Access System
that allows you to lock and unlock your doors,
unlock your trunk lid and disarm or arm your
theft-deterrent system. The range distance is as
much as 100 feet (30 m) away.
Your vehicle comes with
two transmitters, and up
to four can be matched
to your vehicle. See
“Matching Transmitter(s)
to Your Vehicle” later
in this section.
Q(Lock):Press this button to lock the doors.
The indicator light on the door will ash once.
If this button is pressed twice, the doors will
lock, the light will ash once and the horn will
sound once.
68

K(Unlock):Press this button once to unlock the
driver’s door. The indicator light on the door
will ash twice. Press the button twice within
10 seconds to unlock both doors. If it is dark
enough outside, your interior lamps will come on.
Your memory settings may also be recalled when
you press the unlock button on the keyless access
transmitter. SeeMemory Seat, Mirrors and Steering
Wheel on page 10for more information.
G(Trunk):Press and hold this button for
about one second to open the trunk while
the engine is turned off or the shift lever is in
PARK (P).
Matching Transmitter(s) to Your
Vehicle
Each keyless access transmitter is coded to
prevent another transmitter from working with your
vehicle. If a transmitter is lost or stolen, a
replacement can be purchased through your
dealer. Remember to bring any remaining
transmitters with you when you go to your dealer.
Once your dealer has coded the new transmitter,
the lost transmitter will not work with your
vehicle. Each vehicle can have a maximum of four
transmitters matched to it.
To match a new transmitter to your vehicle when
you have a recognized transmitter, do the
following:
1. The vehicle must be off.
2. Have the recognized and new, unrecognized
transmitters on your person.
3. Go to the rear of the vehicle and insert the
vehicle key into the key cylinder located on
the lower rear fascia on the driver’s side of the
vehicle. SeeTrunk on page 77for more
information on the key cylinder.
4. Open the trunk.
69

Battery Replacement
Under normal use, the battery in your keyless
access transmitter should last about three years.
You can tell the battery is weak if the transmitter
will not work at the normal range in any location. If
you have to get close to your vehicle before the
transmitter works, it is probably time to change the
battery.
A weak battery may also cause the DIC to display
NO FOB DETECTED when you try to start the
vehicle. If this happens, place the transmitter in the
glove box transmitter pocket with the buttons facing
to the right. Then, with the vehicle in PARK (P) or
NEUTRAL (N), press the brake pedal and the
START button. Although this will start the vehicle, it
is recommended that you replace the transmitter
battery as soon as possible. The DIC may display
FOB BATTERY LOW.
Notice:When replacing the battery, use care
not to touch any of the circuitry. Static
from your body transferred to these surfaces
may damage the transmitter.1. Insert a at object with a thin edge into the
slot on the side of the transmitter and
separate the bottom half from the top half.
2. Gently pull the battery out of the transmitter.
3. Put the new battery in the transmitter,
positive (+) side up. Use a battery, type
CR2032, or equivalent.
4. Reassemble the transmitter. Make sure to put
it together so water will not get in.
5. Test the transmitter.
72