2007 CADILLAC SRX remote control

Programming Universal Home
Remote — Rolling Code
Rolling code garage door openers are used for
garage doors produced after 1996 and are
code protected. Rolling code means the coded
signal is changed every time your remote control
garage door opener is used.
Programming a rolling code garage door opener
involves time-sensitive actions, so read the
entire procedure before you begin. If you do not
follow these actions, the device will time out
and you will have to repeat the procedure.
Follow these steps to program up to
three channels:
1. Press the two outside buttons at the same
time for one to two seconds, and immediately
release them.2. Go to the garage. Locate the garage door
motor head and press and release the
“learn” button.
After pressing the “learn” button, you have
10 to 30 seconds to complete Step 4
depending on your garage control unit. If you
cannot locate the “learn” button, refer to
the owners guide for your garage door opener.
148

3. Press and hold the button you would like to
use to control the garage door until the
garage door moves. The indicator light, above
the selected button, should slowly blink.
You may need to hold the button from
ve to 20 seconds.
4. Immediately release the button when the
garage door moves. The indicator light will
blink rapidly until programming is complete.
5. Press and release the button again. The
garage door should move, conrming that
programming is successful and complete.
To program another device such as an additional
garage door opener, a security device, or
home lighting, repeat Steps 1–5, choosing a
different function button in Step 3 than what you
used for the garage door opener.
Using Universal Home Remote
Press and hold the appropriate button for at least
half of a second. The indicator light will come
on while the signal is being transmitted.
Reprogramming Universal Home
Remote Buttons
You can reprogram any of the three buttons by
repeating the instructions.
Erasing Universal Home Remote
Buttons
You should erase the programmed buttons when
you sell the vehicle or terminate your lease.
To erase either rolling code or xed code on the
Universal Home Remote device, do the following:
1. Press and hold the two outside buttons at
the same time for approximately 20 seconds,
until the indicator lights, located directly
above the buttons, begin to blink rapidly.
2. Once the indicator lights begin to blink,
release both buttons. The codes from all
buttons will be erased.
For additional information on Universal Home
Remote, seeCustomer Assistance Offices
on page 491.
149

Entry Lighting
The entry lighting system turns on the reading and
dome lamps and the backlighting to the exterior
lamp control when a door is opened or if the
Remote Keyless Entry (RKE) transmitter unlock
button is pressed. If activated by the (RKE),
the lighting will remain active for about 25 seconds.
The entry lighting system uses the light sensor
on the instrument panel; so it must be dark outside
in order for the lamps to turn on. The lamps turn
off about 25 seconds after the last door is
closed. They will dim to off if the ignition key is
turned to ON, or immediately turn off if the power
locks are used.
Parade Dimming
This feature prohibits dimming of the instrument
panel displays and backlighting during daylight
hours when the key is in the ignition and the
headlamps are on. This feature operates with the
light sensor and is fully automatic. When the light
sensor reads darkness outside and the parking
lamps are active, the instrument panel displays can
be adjusted by sliding the instrument panel
brightness lever toward the symbol to brighten or
away from the symbol to dim the lighting.
Reading Lamps
The reading lamps are located on the overhead
console. These lamps come on automatically when
any door is opened.
For manual operation, press the button next to
each lamp to turn it on or off.
If the reading lamps are left on, they automatically
shut off 10 minutes after the ignition has been
turned off.
182

REMOTE KEY LEARNING ACTIVE
This message displays while you are matching a
Remote Keyless Entry (RKE) transmitter to
your vehicle. See “Matching Transmitter(s) to Your
Vehicle” underRemote Keyless Entry (RKE)
System Operation on page 96andDIC Controls
and Displays on page 215for more information.
REPLACE BATTERY IN REMOTE KEY
This message displays when the battery in
your Remote Keyless Entry (RKE) transmitter
needs to be replaced. To replace the battery, see
“Battery Replacement” underRemote Keyless
Entry (RKE) System Operation on page 96.
RIGHT REAR DOOR OPEN
This message displays when the passenger’s side
rear door is not closed completely. Make sure
that the door is closed completely.
SERVICE AIR BAG
This message displays when there is a problem
with the airbag system. Have your vehicle serviced
by your dealer immediately. SeeAirbag Readiness
Light on page 201for more information.
SERVICE A/C SYSTEM
This message displays when the air delivery mode
door or the electronic sensors that control the
air conditioning and heating systems are no longer
working. Have the climate control system
serviced by your dealer if you notice a drop in
heating and air conditioning efficiency.
SERVICE BATTERY CHARGING
SYSTEM
This message displays when there is a problem
with the generator and battery charging systems.
Driving with this problem could drain the battery.
Turn off all unnecessary accessories. Stop
and turn off the vehicle as soon as it is safe to do
so. Have the electrical system checked by your
dealer. Under certain conditions, the charging
system light may also turn on in the instrument
panel cluster. SeeCharging System Light on
page 204for more information.
225

Rear Underseat Fuse Block
(Left Side)
The left side rear fuse block is located under the
rear seat on the left side of the vehicle. The carpet
must be lifted up to access the rear fuse block.
To access the fuse block, push in the two tabs
located at each end of the fuse block cover.
Then lift the cover off.
Relays Usage
STOP RELAY
MININot Used
ELC RELAY
MINIElectronic Level Control (ELC)
Compressor Motor
PRK LAMP
RELAY MICROLicense Lamps
REAR FOG
LAMP RLY
MICRONot Used
SPARE Spare
R POSITION
RELAY MICRONot Used
LH POS PRK
LAMP RELAY
MICROFront & Rear Park Lamps
SPARE Not Used
Mini Fuses Usage
SWC Steering Wheel Controls
RSA/RSERear Seat Entertainment, Rear Seat
Audio
ONSTAR
TV/XMOnStar
®Module, XM Radio
3RD ROW
SW/RFAFlip Fold Seat Switches, Remote
Keyless Entry System Module
AMP Audio Amplier
460

Tires (cont.)
Tire Terminology and Denitions............... 404
Uniform Tire Quality Grading.................... 419
Wheel Alignment and Tire Balance........... 420
Wheel Replacement................................. 421
When It Is Time for New Tires................. 416
Winter Tires............................................. 400
Tow/Haul Mode........................................... 126
Tow/Haul Mode Light................................... 213
Towing
Recreational Vehicle................................. 328
Towing a Trailer....................................... 331
Your Vehicle............................................. 328
Traction
Control System (TCS).............................. 281
Control System Warning Light.................. 206
Limited-Slip Rear Axle.............................. 283
Magnetic Ride Control.............................. 283
StabiliTrak
®System................................. 283
Transmission
Fluid, Automatic....................................... 367
Transmission Operation, Automatic.............. 122
Turn and Lane-Change Signals................... 168
Turn Signal/Multifunction Lever.................... 167
U
Ultrasonic Rear Parking Assist (URPA)........ 184
Understanding Radio Reception................... 270
Uniform Tire Quality Grading....................... 419
Universal Home Remote System................. 143
Operation........................................144, 150
V
Vehicle
Control..................................................... 278
Damage Warnings....................................... 5
Loading.................................................... 322
Symbols...................................................... 5
Vehicle Customization, DIC......................... 231
Vehicle Data Collection and Event
Data Recorders........................................ 498
Vehicle Identication
Number (VIN).......................................... 453
Service Parts Identication Label.............. 453
Ventilation Adjustment.................................. 194
Visors.......................................................... 112
521