2007 BUICK RANDEZVOUS remove seats

Head Restraints
Adjust the head restraint so that the top of the
restraint is at the same height as the top of
the occupant’s head. This position reduces the
chance of a neck injury in a crash.
Pull the head restraint up or push it down to
adjust it.
Rear Seats
Rear Seat Operation
The rear seats in your vehicle have seat operating
features to adjust, fold, remove and reinstall the
seats. By using the seat operating procedures, in
the correct order, you can easily remove the
seats from your vehicle.
When you put the seats back in the vehicle, be
sure to follow the label on the back of the seat for
proper location.
Split Bench Seats
If your vehicle has the split bench seat, the
seatbacks can be folded forward or reclined
individually and the sections can be ipped forward
or removed individually.
15

The seatback will lock into place when you push it
back to the upright position. After raising a
seatback to an upright position, push and pull on
the seatback to make sure that it is locked in
place.
Removing the Split Bench Seat
Each section of the split bench seat can be ipped
forward or removed individually.
1. Unlatch the shoulder belt from the lap-belt.
2. Make sure that the seatback is in the upright
position.Notice:Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
3. Lift up or push forward on the seatback
recliner lever to fold the seatback forward.
4. For base-level split bench seats, pull the lever
at the base of the seat on the outboard side
to release the rear latches from the oor
pins and ip the seat forward.
Base-Level
17

For up-level split bench
seats, continue pushing
forward on the recliner
lever to release the
rear latches from
the oor pins and ip
the seat forward.
5. To release the front latches, squeeze the
angled latch release bar toward the straight
crossbar.
6. Remove the seat by rocking it slightly toward
the rear of the vehicle and then pulling it out.
Repeat these steps for the other section of the split
bench seat.
18

Rear Window Defogger
The rear window defogger uses a warming grid to
remove fog from the rear window.
window defogger on or off. An indicator light in the
button will come on to let you know that the
rear window defogger is activated.
The rear window defogger will turn off
approximately 10 minutes after the button is
pressed. If turned on again, the defogger will only
run for approximately ve minutes before
turning off. The defogger can also be turned off by
pressing the button again or by turning off the
engine.
If your vehicle has heated outside rearview
mirrors, the mirrors will heat to help clear fog or
frost from the surface of the mirror when the
rear window defog button is pressed.
Notice:Do not use anything sharp on the
inside of the rear window. If you do, you could
cut or damage the warming grid, and the repairs
would not be covered by your warranty. Do not
attach a temporary vehicle license, tape, a decal
or anything similar to the defogger grid.
Outlet Adjustment
Use the louvers located on the air outlets to
change the direction of the airow.
Operation Tips

Clear away any ice, snow, or leaves from the
air inlets at the base of the vehicle that may
block the ow of air into your vehicle.
Do not use any non-GM approved hood
deectors that could adversely affect the
performance of the system.
Keep the path under the front seats clear of
objects to help circulate the air inside of
your vehicle more effectively.
210