2007 BUICK RANDEZVOUS belt

3. The seat can then be lifted off the front
oor pins.
4. Remove the seat by rocking it slightly toward
the rear of the vehicle and then pulling it out.
Installing the Captain Chairs
{CAUTION:
A safety belt that is improperly routed, not
properly attached, or twisted will not
provide the protection needed in a crash.
The person wearing the belt could be
seriously injured. After installing the seat,
always check to be sure that the safety
belts are properly routed and attached,
and are not twisted.
24

Do not put the seats in so that they face rearward
because they will not latch that way. The captain
chairs have seat position labels, located on
the back of each seat, showing where that seat
must go. The seat must be placed in the
proper location for the legs to attach correctly.
1. Make sure that the seatback is in the folded
forward position and that the safety belts are
on the correct side of the seat.
2. Hook the front latches over the front oor pins.
25

Folding the Seatback
Notice:Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
To fold the seatback
forward, lift the lever
located on the back of
the seat. Push the
seatback down until it is
locked into place.
Push and pull on the seatback to make sure that it
is locked into place.To raise the seatback, do one of the following:From the rear of the vehicle, lift the lever
to release the seatback. Then pull the
strap, located on the right side of the seat, to
lift the seatback up. The seatback has a
pocket on the side to stow the strap.
From the passenger’s side door, lift the lever
to release the seatback. Lift the seatback
and push it until it locks in place.
Push and pull on the seatback to make sure that it
is locked into place.
27

Removing the Stowable Seat
1. Remove the convenience center, if it is in the
vehicle. SeeRear Convenience Center on
page 165.
2. Make sure all items are off the stowable seat.
3. From the front of the seat, remove the
two nuts, located on the oor on each side of
the seat.
Notice:Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
4. From behind the bench seat, fold the seatback
down. See “Folding the Seatback” previously.
5. Remove the rear nuts located on the oor on
each side of the seat.
6. Remove the seat by rocking it slightly toward
the rear of the vehicle and then pulling it out
the vehicle. This should be done in one
motion.
7. Put the nuts back onto the screws so the nuts
do not get misplaced.
Installing the Stowable Seat
{CAUTION:
A safety belt that is improperly routed, not
properly attached, or twisted will not
provide the protection needed in a crash.
The person wearing the belt could be
seriously injured. After installing the seat,
always check to be sure that the safety
belts are properly routed and attached,
and are not twisted.
Do not put the stowable seat in so that it faces
rearward. The stowable seat has to be installed
before the rear convenience center. SeeRear
Convenience Center on page 165for more
information.
28

The stowable seat has seat position labels,
located on the back of the seat, showing where
the seat must go. The seat must be placed in the
proper location for the legs to attach correctly.
Notice:Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
1. Make sure that the seatback is folded forward
before beginning this procedure. See “Folding
the Seatback” previously.
2. Remove the nuts from the screws.
3. Place the stowable seat on the vehicle oor
so that the seat brackets are placed over the
screws.
4. Reinstall the nuts onto the screws. Torque to
approximately 18 lb ft (25
Y).
{CAUTION:
A seat that is not locked into place
properly can move around in a collision or
sudden stop. People in the vehicle could
be injured. Be sure to lock the seat into
place properly when installing it.
5. Try to raise the seat to make sure that it is
locked into place.
{CAUTION:
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on the
seatback to be sure it is locked.
6. Raise the seatback to its upright position.
Push and pull on the seatback to make
sure that it is locked into place.
29

Safety Belts
Safety Belts: They Are for Everyone
This part of the manual tells you how to use
safety belts properly. It also tells you some things
you should not do with safety belts.
{CAUTION:
Do not let anyone ride where he or she
cannot wear a safety belt properly. If you
are in a crash and you are not wearing a
safety belt, your injuries can be much
worse. You can hit things inside the
vehicle or be ejected from it. You can be
seriously injured or killed. In the same
crash, you might not be, if you are
buckled up. Always fasten your safety
belt, and check that your passengers’
belts are fastened properly too.
{CAUTION:
It is extremely dangerous to ride in a
cargo area, inside or outside of a vehicle.
In a collision, people riding in these areas
are more likely to be seriously injured or
killed. Do not allow people to ride in any
area of your vehicle that is not equipped
with seats and safety belts. Be sure
everyone in your vehicle is in a seat and
using a safety belt properly.
Your vehicle has a light
that comes on as a
reminder to buckle up.
SeeSafety Belt
Reminder Light on
page 215.
In most states and in all Canadian provinces, the
law says to wear safety belts. Here is why:
They work.
30

You never know if you will be in a crash. If you do
have a crash, you do not know if it will be a
bad one.
A few crashes are mild, and some crashes can be
so serious that even buckled up, a person
would not survive. But most crashes are in
between. In many of them, people who buckle up
can survive and sometimes walk away. Without
belts they could have been badly hurt or killed.
After more than 40 years of safety belts in
vehicles, the facts are clear. In most crashes
buckling up does matter... a lot!Why Safety Belts Work
When you ride in or on anything, you go as fast
as it goes.
Take the simplest vehicle. Suppose it is just a
seat on wheels.
31

or the safety belts!
With safety belts, you slow down as the vehicle
does. You get more time to stop. You stop
over more distance, and your strongest bones
take the forces. That is why safety belts
make such good sense.
Questions and Answers About
Safety Belts
Q:Will I be trapped in the vehicle after an
accident if I am wearing a safety belt?
A:Youcouldbe — whether you are wearing a
safety belt or not. But you can unbuckle a
safety belt, even if you are upside down. And
your chance of being conscious during and
after an accident, so youcanunbuckle and get
out, ismuchgreater if you are belted.
Q:If my vehicle has airbags, why should I
have to wear safety belts?
A:Airbags are in many vehicles today and will be
in most of them in the future. But they are
supplemental systems only; so they workwith
safety belts — not instead of them. Every
airbag system ever offered for sale has
required the use of safety belts. Even if you
are in a vehicle that has airbags, you still have
to buckle up to get the most protection. That
is true not only in frontal collisions, but
especially in side and other collisions.
34