A.Air Outlets
B.Interior Lamps Control
C.Exterior Lamps Control/Fog Lamp
Control
D.Turn Signal/Multifunction Lever
ECruise Controls
F.Instrument Panel Cluster G.DIC Buttons (if equipped)/Hazard
Warning Flasher Button
H.Passenger Airbag Status Indicator
I.Audio System Controls
J.Hood Release
K.Parking Brake
L.Tilt Lever (if equipped)M.Horn
N.Audio Steering Wheel Controls
(if equipped)
O.Shift Lever
P.Accessory Power Outlet
Q.Climate Controls
R.Glove Box
Getting to Know YourLaCrosse2
Instrument Panel
See Section 3 of your Owner Manual.
DRIVER INFORMATION
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 2
Getting to Know YourLaCrosse12
CONVENIENCE
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine fromoutside the vehicle. (See the Driver
Information Center personalization menu
section to enable.) Automatic Climate
Control system vehicles will regulate the
inside temperature.
To remote start the vehicle:
1. Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.If the lights are not visible, hold theRemote Start button for four secondsand release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present bypressing the Lock and Remote Start but
tons again. Pressing only the Remote
Start button again will turn off the igni tion. Maximum run time is 20 minutes.
After two remote starts have been pro
vided, the Remote Vehicle Start featurewill not operate.
See Section 2 of your Owner Manual.
Finding a Category Station
(if equipped)
Category (CAT) stations are available on
XM1 or XM2 bands only. To find a CATstation:
1. Press the CAT button to activate
Program Type (PTY) Select mode.
2. A category is displayed.
3. Rotate the Tune knob. When the
preferred category appears, press theSeek button to go to the first categorystation (pressing Seek for more thantwo seconds will activate CategoryScan).
4. To go to another station, press the
CAT button. The previously storedcategory will be displayed.
5. Press the up or down Seek button.
6. Press the CAT button to exit Program
Type Select mode.
Audio Steering Wheel Controls
(if equipped)
See Audio Systems for full details about
the functions of the following buttons:
•
(Seek)
•BAND
•1–6 (Preset Stations)
•(OnStar®/Mute):Press to silence
audio, and again to play. In OnStar
equipped vehicles, press to interactwith the OnStar system.
•
(VOLUME):Press up/down
arrow to increase/decrease volume.
See Section 3 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 12
