2007 BMW MOTORRAD K 1200 GT reset

Instrument cluster1Speedometer
2 Telltale lights ( 22)
3 Multifunction display
( 22)
4 Rev. counter
5 Telltale light, anti-theft alarm
(OE)
6 Set the clock ( 49)
Adjust the dimmer ( 51)
7 Select the odometer
( 49)
Reset the tripmeter ( 50)
8 Sensor for instrument light-
ing
The instrument-cluster
lighting has automatic day
and night switchover.
218zGeneral views

The display starts with the cur-
rent value and each time the but-
ton is pressed it moves one step
through the following sequence:Tripmeter 1 (
Trip I
)
Tripmeter 2 (
Trip II
)
Residual range (once fuel level
is down to reserve)
Tyre pressures (OE)
The total distance appears in the
DIST
line of the display.
Resetting tripmeterSwitch on the ignition.
Select the desired tripmeter. Press and hold down button
1.
The tripmeter is reset to zero.
Residual rangeResidual-range reading 1appears
below the word
RANGE
and in-
dicates how far you can ride with the fuel remaining in the tank.
This reading is not displayed until
fuel level has dropped to reserve.
This distance is calculated on the
basis of fuel level and average
consumption.
When you refuel, the increase in
fuel level is not registered unless
several litres are added to the
fuel already in the tank.
When refuelling after running on
reserve, make sure that you top
up the tank to a level above re-
serve, as otherwise the sensor
will not be able to register the
new level. If the sensor cannot
register the new level neither
the fuel-level reading nor the
residual-range readout can be
updated.
The calculated range is an
approximate value. Con-
sequently, BMW Motorrad re-
commends that you should not
try to use the full residual range
before refuelling.
450zOperation

Average speedAverage speed1is calculated
on the basis of the time elapsed
since the last reset. Times
during which the engine was
stopped are excluded from the
calculation.Resetting average speedSwitch on the ignition.
Select average speed. Press and hold down button
1.
Average speed is reset to zero.
Average consumptionAverage consumption 1is cal-
culated by dividing the distance
covered since the last reset by the corresponding amount of fuel
used.
Resetting average
consumptionSwitch on the ignition.
Select average consumption.
Press and hold down button
1.
Average consumption is reset
to zero.
453zOperation

I
IgnitionSwitching off, 47
Switching on, 47
Immobiliser, 48 Warning, 27
Instrument cluster Overview, 18
Sensor for lighting, 18
J
Jump starting, 131
K
Keys, 47
L
Laying up, 140
Lights Headlight flasher, 56
High-beam headlight, 56
Low-beam headlight, 56
Parking light, 56
Side light, 55
Luggage Correct loading, 99 M
Maintenance
General instructions, 106
Mirrors Adjusting, 68
Motorcycle Restoring to use, 140
Multifunction display, 18 Adjust the dimmer, 51
Overview, 22
O
Odometer and tripmeters Resetting, 50
Selecting readings, 49
On-board computer, 17 Ambient temperature, 52
Average consumption, 53
Average speed, 53
Oil level, 54
Range, 52
Reset the average
consumption, 53
Resetting average speed, 53 Selecting readings, 51
Warnings, 30
P
Parking, 85
Power socket, 11, 98
Pre-ride check, 81
R
Rear-wheel drive Technical data, 148
Refuelling, 87 Filler neck, 13
Reserve Warning, 27
Residual range, 50
Restoring to use, 140
Rev. counter, 18
Rider's Manual, 15
Running gear Technical data, 148
Running in, 83
S
Safety instructions, 77
12167zIndex