Page 66 of 138

NotesThe Maintenance chapter de-
scribes straightforward proced-
ures for checking and replacing
certain wear parts.
Special tightening torques are lis-
ted as applicable. The tightening
torques for the threaded fasten-
ers on your motorcycle are listed
in the section entitled "Technical
data".
You will find information on more
extensive maintenance and re-
pair work in the Repair Manual
on DVD/CD-ROM (RepROM) for
your motorcycle, which is avail-
able from your authorised BMW
Motorrad dealer.
Some of the work calls for spe-
cial tools and a thorough know-
ledge of motorcycles. If you
are in doubt consult a specialist
workshop, preferably your author-
ised BMW Motorrad dealer.
ToolkitStandard on-board toolkit1 Fuse puller
Replacing fuses
2 Open-ended spanner, w/f
8/10
Adjusting chain tension
3 Open-ended spanner, w/f
19
Adjusting mirror arm
4 Open-ended spanner, w/f
19
Adjusting mirror arm5 Screwdriver handle
Holder for screwdriver blade9
6 3 mm Allen key
Replacing headlight bulb
7 4 mm Allen key
Removing and installing body
panels
8 6 mm Allen key
Adjusting headlight beam throw
9 Screwdriver blade
Star-head and flat-tip blade
Adjusting rear suspension
damping
864zMaintenance
Page 88 of 138

BulbsNotes
A defective bulb places
your safety at risk because
it is easier for other users to
oversee the motorcycle.
Replace defective bulbs as
soon as possible; always carry a
complete set of spare bulbs if
possible.
The bulb is pressurised and
can cause injury if dam-
aged.
Wear protective goggles and
gloves when changing bulbs.
The types of bulb fitted to
your motorcycle are listed
in the section entitled "Technical
data".
Do not touch the glass of
new bulbs with your fingers.
Use a clean, dry cloth to hold
the bulbs when handling them.
Dirt deposits, in particular oil andgrease, interfere with heat radi-
ation from the bulb. This leads
to overheating and shortens the
bulb's operating life.
Removing headlight
housing
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Always make sure that the
motorcycle is stable and firmly
supported.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.Remove two screws1.
Ease the headlight housing for-
ward and up to remove.
Replacing low-beam and
high-beam headlight bulbSwitch off the ignition.
Remove the headlight housing
( 86)
886zMaintenance
Page 89 of 138
Disconnect plug1.
Remove rubber cap2.Disengage spring clip3from
the latches and swing it up.
Remove bulb4.
Replace the defective bulb.Bulb for low-beam and
high-beam headlight
H4 / 12 V / 55...60 W
Install bulb4.
887zMaintenance
Page 91 of 138
Replacing parking-light
bulb
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Always make sure that the
motorcycle is stable and firmly
supported.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove the headlight housing
( 86)Pull bulb socket1out of the
headlight housing.
Pull bulb2out of socket3.
Replace the defective bulb.Bulb for parking light
W5W / 12 V / 5 W
Insert bulb2into socket3.
889zMaintenance
Page 92 of 138
Insert bulb socket1into the
headlight housing.
Install the headlight housing
( 88)Replacing turn indicator
bulbs, front and rear
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Always make sure that the
motorcycle is stable and firmly
supported.Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screw1.Pull the glass out of the reflect-
or housing at the threaded-
fastener side.
Turn bulb2counter-clockwise
and remove it from the bulb
housing.
890zMaintenance
Page 120 of 138
Lighting
Bulb for low-beam and high-beam headlight H4 / 12 V / 55...60 W
Bulb for parking light W5W / 12 V / 5 W
Bulbs for flashing turn indicators, front RY10W / 12 V / 10 W
Bulbs for flashing turn indicators, rear RY10W / 12 V / 10 W
Bulb for number-plate light W5W / 12 V / 5 WFrameFrame type Bridge-type steel frame, load-bearing drive unit
and bolt-on rear frame
Type plate location Front frame, right
VIN location Front frame, right
10118zTechnical data
Page 133 of 138

A
Abbreviations and symbols, 6
ABS
Engineering details, 55
Fuses, 13, 85
Self-diagnosis, 48
Switching off and on, 15, 33
Warnings, 23
Accessories
Notes, 60
Power socket, 60
Air Damping System, 34
Adjusting air pressure, 34, 35
Air pressure and
temperature, 35
Fore-and-aft tilt indicator, 11,
35
Periods of disuse, 36
Air filter, 14
Replacing, 92
Auxiliary stand, 81
B
Battery
Charging, 97
Maintenance instructions, 96Removing and installing, 98
Technical data, 117
Voltmeter, 20, 30
BMW Motorrad service, 122
BMW Motorrad Service
Card, 122
Brake fluid
Checking level, 69
Reservoir, front, 13
Reservoir, rear, 13
Brake pads
Running in, 49
Test, 68
Brakes
Notes, 50
Technical data, 114
Test, 67
Bulbs
Notes on replacement, 86
Replacing low-beam headlight
bulb, 86
Replacing number-plate light
bulbs, 91
Replacing rear light, 91
Replacing side-light bulb, 89Replacing turn indicator
bulb, 90
Technical data, 118
C
Care, 103
Chain
Adjusting tension, 74
Checking tension, 74
Checking wear, 75
Lubricating, 73
Checklist, 46
Clock, 20
Adjusting, 17, 29
Clutch
Adjusting play, 73
Checking play, 72
Technical data, 112
Confirmation of maintenance
work, 124
Coolant
Checking level, 71
Fore-and-aft tilt indicator, 11
Topping up, 72
12131zIndex
Page 134 of 138

Coolant temperature
Warning, 22
D
Damping
Adjusting, 11, 13
Dimensions, 119
Display, 28
Overview, 20
Selecting readings, 17, 28
E
Electrics
Technical data, 117
Emergency off switch (kill
switch), 16, 32
Engine
Starting, 16, 46
Technical data, 110
Engine oil
Checking level, 65
Filler neck, 14
Oil dipstick, 14
Technical data, 111
Topping up, 67Engine oil pressure
Warning, 22
Equipment, 7
F
Frame
Technical data, 118
Front-wheel stand, 82
Fuel
Filler neck, 13
Refuelling, 52
Technical data, 4, 111
Warning, 22
Fuses, 14, 84
ABS, 85
G
General views
Display, 20
Headlight, 18
Instrument cluster, 17
Left handlebar fitting, 15
Left side, 11
Right handlebar fitting, 16
Right side, 13
Status indicators, 20Telltale lights, 20
Underneath the seat, 14
Warnings, 20
H
Handlebar fitting, left
Overview, 15
Handlebar fitting, right
Overview, 16
Headlight
Beam throw, 41
Driving on right/driving on
left, 41
General views, 18
Replacing low-beam headlight
bulb, 86
Replacing side-light bulb, 89
Headlight flasher, 15, 31
High-beam headlight, 18
Switch, 15
Telltale light, 20
Horn, 15
I
Idle
Telltale light, 20
12132zIndex