IN AN EMERGENCY
206
STARTING WITH AN
AUXILIARY BATTERYIf the battery is flat (for battery with op-
tical hydrometer: dark in colour with no
green area in the centre), the engine can be
started using another battery of the same
or a little higher capacity than the flat one.
This is what you should do fig. 1:
1)Remove the protecting cover on the
battery positive pole by pressing the related
side wings (front side), then connect the
positive terminals (plus sign +next to the
terminal) of the two batteries with a special
cable.
2)Connect a second cable to the negative
terminal (–) of the auxiliary battery with
an earth point
Eon the engine or the gear-
box of the car to be started.WARNINGDo not directly connect the
negative terminals of the two batteries: any
sparks may set fire to the gas that may be
released from the battery. If the auxiliary bat-
tery in installed on another car, no metal part
shall accidentally come into contact with this
car and the one with the flat battery.
3)Start the engine.
4)When the engine is running remove the
cables in reverse order.
If after a few attempts the engine does not
start, do not insist but contact Alfa Romeo
Authorized Services.
fig. 1
A0B0181m
Never use a quick battery
charger to start the engine
in an emergency as this
could damage the electronic sys-
tems of your vehicle, particularly
the control units which manage the
starting and supply functions.
The battery terminal con-
necting and disconnecting
operations generate cur-
rent that may cause problems to
the car’s electronic systems. There-
fore, this operation should be car-
ried out by skilled personnel.This starting procedure
must be carried out by
qualified personnel as incorrect op-
erations may provoke electrical
discharge of great intensity. The
liquid contained in the battery is
toxic and corrosive. Avoid contact
with skin and eyes. Keep naked
flame and lighted cigarettes away
from the battery. Do not cause
sparks.
WARNING
IN AN EMERGENCY
215
After about 10 minutes, stop and check
the tyre pressure once again; remember to
engage the handbrake.
fig. 15
A0B0336m
fig. 16
A0B0337m
If it is not possible to reach the prescribed
pressure, move the car forwards or back-
wards for about 10 metres, so that the seal-
er is distributed inside the tyre, then repeat
inflation.
If, in spite of the last operation, the pre-
scribed pressure is not achieved, do not
move the vehicle and contact Alfa Romeo
Authorized Services.
Once the correct tyre pressure has been
reached, start driving immediately so that
the sealer is distributed evenly inside the
tyre.
Place the sticker in a posi-
tion where it can be clear-
ly seen by the driver as a notice
that the tyre has been treated with
the quick repairing kit. Drive care-
fully especially in a bend. Do not
overcome 80 km/h. Avoid sudden
acceleration or braking.
WARNING
If the pressure is below
1,3 bars, do not drive any
further; FIX & GO cannot guaran-
tee proper hold because the tyre is
too much damaged. Contact Alfa
Romeo Authorized Services.
Conversely, if at least 1,3 bars are
detected, restore the correct pres-
sure (with the engine running and
the handbrake engaged) and start
driving the car with great care.
WARNING
