2007.5 Peugeot 307 key battery
[x] Cancel search: key batteryPage 67 of 212
ACCESS
64
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by any-
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
is recognised and starting is possi-
ble.
If the system does not function
correctly, the service warning light
comes on, accompanied by an audi-
ble signal and a message on the mul-
tifunction display.
In this case, your vehicle will not
start. Contact a PEUGEOT dealer as
soon as possible.
A heavy object attached to the key
(key ring, ...), weighing down on the
shaft of the key in the switch, may
cause a malfunction.
Battery ref.: CR1620/3 volts.
T h e i n f o r m a t i o n " b a t t e r y l a t " i s g i v e n
by displaying of the service warning
light, accompanied by an audible sig-
nal and a message on the multifunc-
tion display.
To replace the battery, unclip the cas-
ing using a coin at the notch.
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Key in ignition
A buzzer sounds on opening the driv-
er’s door, if the key has been left in
the ignition.
control battery or in the event of a re-
mote control malfunction, the remote
control must be reinitialised.
Switch off the ignition.
Switch the ignition on again.
Press the remote control locking
button immediately for a few sec-
onds.
Switch off the ignition and remove
the remote control key from the
ignition lock.
The remote control is now working
again.
Locating your vehicle
Using the key
Turn the key in the lock on the
driver’s door to lock the vehicle.
T u r n t h e k e y a g a i n w i t h i n i v e
seconds to deadlock the vehicle.
E a c h a c t i o n i s c o n i r m e d b y i x e d
lighting of the direction indicators for
approximately two seconds.
When the vehicle is locked,
if unlocking is activated inad-
vertently without a door being
opened within 30 seconds,
the vehicle will lock automatically.
The folding and unfolding of the ex-
terior mirrors can be deactivated by
a PEUGEOT dealer.
To locate your vehicle, if
you have locked it, in a
car park:
press button B , the courtesy lights
come on and the direction indica-
t o r s l a s h f o r a f e w s e c o n d s .
Changing the remote control
battery
Reprogramming the remote
control
Following disconnection of the vehi-
cle’s battery, replacement of the remote
Page 69 of 212
ACCESS
64
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by any-
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
is recognised and starting is possi-
ble.
If the system does not function
correctly, the service warning light
comes on, accompanied by an audi-
ble signal and a message on the mul-
tifunction display.
In this case, your vehicle will not
start. Contact a PEUGEOT dealer as
soon as possible.
A heavy object attached to the key
(key ring, ...), weighing down on the
shaft of the key in the switch, may
cause a malfunction.
Battery ref.: CR1620/3 volts.
T h e i n f o r m a t i o n " b a t t e r y l a t " i s g i v e n
by displaying of the service warning
light, accompanied by an audible sig-
nal and a message on the multifunc-
tion display.
To replace the battery, unclip the cas-
ing using a coin at the notch.
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Key in ignition
A buzzer sounds on opening the driv-
er’s door, if the key has been left in
the ignition.
control battery or in the event of a re-
mote control malfunction, the remote
control must be reinitialised.
Switch off the ignition.
Switch the ignition on again.
Press the remote control locking
button immediately for a few sec-
onds.
Switch off the ignition and remove
the remote control key from the
ignition lock.
The remote control is now working
again.
Locating your vehicle
Using the key
Turn the key in the lock on the
driver’s door to lock the vehicle.
T u r n t h e k e y a g a i n w i t h i n i v e
seconds to deadlock the vehicle.
E a c h a c t i o n i s c o n i r m e d b y i x e d
lighting of the direction indicators for
approximately two seconds.
When the vehicle is locked,
if unlocking is activated inad-
vertently without a door being
opened within 30 seconds,
the vehicle will lock automatically.
The folding and unfolding of the ex-
terior mirrors can be deactivated by
a PEUGEOT dealer.
To locate your vehicle, if
you have locked it, in a
car park:
press button B , the courtesy lights
come on and the direction indica-
t o r s l a s h f o r a f e w s e c o n d s .
Changing the remote control
battery
Reprogramming the remote
control
Following disconnection of the vehi-
cle’s battery, replacement of the remote
Page 73 of 212
ACCESS
67
1. Driver’s electric window
switch.
2. Passenger’s electric window
switch.
3. Rear right electric window
switch.
4. Rear left electric window
switch.
5. Disarming of the rear electric
window switches (child lock) .
You have two options: Automatic operation:
Press or pull the switch fully : the
window opens or closes completely
when the switch is released. Press-
ing the switch again stops the move-
ment of the window.
Note: approximately 45 seconds fol-
lowing removal of the ignition key,
none of the windows can be opened
or closed. The ignition must be
switched on again to open or close
the windows.
Always remove the key from
the ignition when leaving
the vehicle, even for a short
time.
In the event of contact during opera-
tion of the windows, you must reverse
the movement of the window. To do
this, press the switch concerned.
When the driver operates the pas-
senger electric window switches, he
must ensure that no one is prevent-
ing correct closing of the windows.
The driver must ensure that the pas-
sengers use the electric windows
correctly.
Be aware of children when operating
the windows.
Reinitialisation of the
windows
Following reconnection of the battery
or in the event of a malfunction:
- release the switch and pull it again until it closes completely,
- hold the switch for approximately one second after closing,
- press the switch to lower the win- dow automatically,
- when the window has reached the low position, press the switch again
for approximately one second.
The safety auto-reverse function is
not active during these operations.
Manual operation:
Press or pull the switch gently.
The window stops as soon as the
switch is released.
ELECTRIC WINDOWS
Safety auto-reverse
When the window rises and meets
an obstacle, it stops and partially
lowers again.
Disarming the rear window
controls
For the safety of your children, press
switch 5 to prevent operation of the
rear windows irrespective of their
position.
When the button is pressed down,
disarming is active. When the button
is raised, disarming is deactivated.
Note:
In the event of unwanted opening
of the window on closing (for exam-
ple in the presence of frost), press
the switch until it opens completely,
then pull it immediately until it clos-
es. Continue to hold the switch for
approximately one second after the
window has closed.
The safety auto-reverse function is
not active during these operations.
Page 79 of 212
ACCESS
71
Notes:
After reconnecting the battery, in the
event of a malfunction, you must
reinitialise the safety auto-reverse:
- place the control in the maxi-mum partial opening position (3rd
notch to the right),
- wait until the roof is in the maxi- mum partially open position,
- press the control for at least one second.
In the event of unwanted opening of
the roof on closing (for example, in
the presence of ice), and immediate-
ly after the roof stops:
- move the control to the "O" posi-
tion and press the control imme-
diately,
- continue to press the control until the roof is fully closed.
The safety auto-reverse function is
not active during these operations.
-
To partially open the roof: Turn
the switch to the right (three pos-
sible settings).
- To open the roof completely:
Turn the switch to the left (six
possible settings).
- To close it completely: Turn the
switch back to position "O" .
- Safety auto-reverse: When the
sunroof is closing and meets an
obstacle, it stops then partially
opens again.
The sunroof shutter is manual. Always remove the key from
the ignition when leaving
the vehicle, even for a short
time.
In the event of contact during opera-
tion of the roof, you must reverse
the movement of the roof. To do this,
press the switch concerned.
When the driver operates the roof
switch, he must ensure that no one
is preventing correct closing of the
roof.
The driver must ensure that the pas-
sengers use the sunroof correctly.
Be aware of children when operating
the roof.
SUNROOF
Page 148 of 212
10PRACTICAL INFORMATION
S p e c i a l f r o n t w i n d s c r e e n
wiper position
Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
C h a n g i n g a w i p e r b l a d e
Lift the wiper arm, then unclip the
blade and remove it.
Fit the new blade and push back
the arm.
Note: t h e s h o r t e s t b l a d e i s i t t e d o n
the vehicle’s right-hand windscreen
wiper arm.
T o r e t u r n t h e w i n d s c r e e n w i p e r s
t o t h e i r n o r m a l p o s i t i o n , s w i t c h o n
t h e i g n i t i o n a n d o p e r a t e t h e w i p e r
stalk.
BATTERY
T o c h a r g e t h e b a t t e r y u s i n g a
b a t t e r y c h a r g e r :
- Disconnect the battery starting
with the negative (-) terminal,
- Follow the instructions for use given by the battery charger
manufacturer,
- Check that the terminals and connectors are clean; if they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them,
- Reconnect the battery starting with the negative (-) terminal. Before disconnecting the
battery, you must wait for
2 minutes after switching off
the ignition.
Never disconnect a terminal when
the engine is running.
N e v e r c h a r g e a b a t t e r y w i t h o u t i r s t
disconnecting the terminals.
Close the windows and sunroof
before disconnecting the battery.
If they do not operate normally
following reconnection of the
battery, they must be reinitialised
(see sections "Reinitialisation of the
electric windows" and "Sunroof").
After every reconnection of the
battery, switch on the ignition and
wait 1 minute before starting to
allow the electronic systems to be
i n i t i a l i s e d . I f s l i g h t d i f i c u l t i e s a r e
experienced after this, please contact
a PEUGEOT dealer.
Following disconnection of the battery,
the remote control key and the GPS
satellite navigation system must
be reinitialised (see corresponding
section).
I t i s a d v i s a b l e t o d i s c o n n e c t t h e
b a t t e r y i f t h e v e h i c l e i s n o t t o b e
u s e d f o r a p e r i o d o f m o r e t h a n
one month.
T o s t a r t t h e v e h i c l e f r o m a n o t h e r
b a t t e r y :
- Connect the red cable to the positive (+) terminals of the two
batteries,
- Connect one end of the green or black cable to the negative (-)
terminal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables. The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance
with regulations and must never be
discarded with household waste.
Take used remote control and vehicle
batteries to an approved collection
point.
C H A N G I N G A W I N D S C R E E N
W I P E R B L A D E