2007.5 Peugeot 307 change time

43
COMFORT
VENTILATION

1. Windscreen de-icing or demisting
vents.

2. Front window de-icing or demist-
ing vents.
Advice on operation

 If, when the vehicle has been
parked in the sun for a long time,
the interior temperature remains
very high, do not hesitate to ven-
tilate the passenger compartment
for a few minutes.
Place the air l ow control at a level sufi cient to ensure a good
renewal of air in the passenger
compartment.
When the air l ow control is in posi- tion 0 (deactivation of the system),
temperature related comfort is no
longer guaranteed but a slight l ow
of air, due to the movement of the
vehicle, can still be felt.

 For even air distribution, take care
not to obstruct the exterior air in-
take grille at the base of the wind-
screen, the vents, the air outlets
under the front seats and the air
extractor located behind the l aps
in the boot.
Check that the passenger com- partment i lter is in good condi-
tion. Have the i lters replaced
regularly. If you drive in a dusty
environment, change them twice
as often.
Switch off the rear screen
and exterior mirrors demist-
ing as soon as you consider
this necessary as reducing
the current consumption re-
duces the fuel consumption.

3. Side vents.

4. Centre vents.

5. Air outlet to front footwells.

6. Air outlet to rear footwells.

ACCESS
66
ALARM
This provides two types of protection:
-

exterior protection: it sounds if a door,
the boot or the bonnet is opened.
- interior protection: it sounds if
the volume inside the passenger
compartment changes (breaking
of a window or a movement in-
side the vehicle).
 In the next ten seconds, press
button A until the indicator light is
on continuously,

 Get out of the vehicle,

 Set the alarm by locking or dead-
locking using the remote control
(button A indicator light l ashes
once a second).
In order for the alarm to be set in
this mode, these operations must be
carried out each time the ignition is
switched off.
Setting the alarm

 Switch off the ignition and get out
of the vehicle.

 Set the alarm, by locking or dead-
locking using the remote control
(button A indicator light l ashes
once per second).

Note: if you wish to lock your vehi-
cle without setting the alarm, use the
door lock.
When the alarm is triggered, the si-
ren sounds and the direction indicator
lights l ash for thirty seconds.
After triggering, the alarm remains set.
Disarming
Unlock the vehicle with the remote
control key (button A indicator light
goes out).

Note: if the alarm has been triggered
while you were away from your vehicle,
the rapid l ashing of the indicator light will
stop when you switch on the ignition.
Failure of the remote control

 Unlock the doors with the key and
open the door. The alarm is trig-
gered.

 Switch on the ignition. The alarm
is disarmed.
Incorrect operation
When the ignition is switched on, if
button A lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
If the alarm has been trig-
gered ten times in succes-
sion, on the eleventh time it
becomes inactive.
If button A indicator light l ashes rap-
idly, the alarm has been triggered while
you were away from your vehicle.
45 seconds following pressing of the
locking button on the remote control,
the alarm is set, regardless of the
status of the doors or boot.
When washing your vehicle, to pre-
vent triggering of the alarm:
- lock the doors using the key,
or
- set the exterior alarm only
To set the alarm with exterior
protection only
If, while you are away from the vehi-
cle, you wish to leave a window par-
tially open or a pet inside the vehicle,
you should choose exterior protection
only.

 Switch off the ignition,
Automatic activation *
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot
is opened, it is essential to i rst press
the unlocking button on the remote
control.
* According to country.

DRIVING
99
Moving off
With the engine running, to move off
from position P :

 it is essential to press the brake
pedal,

 release the handbrake,

 select position R , D or M , then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
You can also move off from position N .
When the engine is at idle,
brakes not applied, if position

R , D or M is selected the
vehicle moves even without
the accelerator being pressed.
For this reason, do not leave
children unsupervised inside the
vehicle, with the engine running .
If the lever is not in position P , an
audible signal is heard and a message
appears when the driver’s door is
opened or approximately 45 seconds
after the ignition is switched off. Move
the lever to P . The audible signal
stops and the message disappears. When maintenance opera-
tions need to be carried out
with the engine running, ap-
ply the handbrake and select
position
P . Never select position
N when
the vehicle is moving.
Never select positions P
or R unless the vehicle is
stationary.
Never change between positions
to optimise braking on a slippery
surface.
Sport and snow programmes
In addition to the auto-adaptive
programme, there are two special
programmes.
The programme is displayed on the
instrument panel screen.
Automatic operation

Automatic changing of the four or
six gears:

 select position D in the gate.
The gearbox automatically adapts the
gear in relation to the style of driving,
the road proi le and the vehicle load.
The gearbox is then operating in
auto-adaptive mode, without any
action on your part.
For immediate maximum acceleration
without touching the gear lever, press
the accelerator pedal down as far as
it will go (kick down). The gearbox
will automatically change down or
maintain the gear selected until
maximum engine speed is reached.
When braking, the gearbox will
automatically change down in order
to provide efi cient engine braking.
If you take your foot off the accelerator
suddenly, the gearbox will not
change to a higher gear for reasons
of safety. Sport programme

 Press button S once the engine
has been started.
The gearbox automatically favours
sporty driving and more dynamic
acceleration.
Snow programme
This programme improves starting
and drive when traction is poor.

 Press button  once the engine
has been started.
The gearbox adapts to driving on
slippery roads.

Note: you can return to the auto-
adaptive programme at any time.

 Press button S or  again to
switch off the programme you are
in.

DRIVING
100
Manual operation

Manual changing of the four or six
gears:

 select position M in the gate,

 push the lever to the + sign to
change to a higher gear,

 pull the lever to the - sign to
change to a lower gear.
You can change from position D
(driving in automatic mode) to
position M (driving in manual mode)
at any time.
Invalid value during manual
operation Notes
It is only possible to change from
one gear to another if the vehicle
speed and engine speed permit. If
they do not, the vehicle will operate
temporarily in automatic mode.
In the event of under-revving or over-
revving, the gear selected l ashes for
a few seconds, then the actual gear
engaged is displayed.
When the vehicle is stationary or
moving very slowly, the gearbox
automatically selects gear
M1 .
Programme S (sport) and  (snow)
do not operate in manual mode.
Operating abnormality
Any operating abnormality
is indicated by the
displaying of this warning
light, an audible signal and
a message on the multi-
function display.
In this situation the gearbox operates in
downgrade mode (locked in 3rd gear).
You may feel a substantial knock when
changing from P to R and from N to R
(this will not cause any damage to the
gearbox).
Do not exceed 60 mph (100 km/h),
keeping within the limit of local speed
restrictions.
Contact a PEUGEOT dealer as soon
as possible.
If the battery is l at and the
lever is in position P , it will
be impossible to change to
another position.
Above all, do not force the lever
as there is a risk of damage to the
automatic gearbox.
This is displayed if a gear
is not engaged correctly
(selector between two
positions).

DRIVING
107
VISUAL AND AUDIBLE REAR
PARKING ASSISTANCE
This system consists of four proximity
sensors, located in the rear bumper.
This detects any obstacle (person,
vehicle, tree, gate, etc.) behind the
vehicle. Nevertheless, it cannot
detect obstacles located just below
the bumper.
An object, such as a stake, a
roadworks cone or any other similar
object may be detected at the
beginning of the manoeuvre, but
may no longer be detected when the
vehicle comes close to it.

Note: this function will be disarmed
automatically when the vehicle is
towing a trailer or when a bicycle
carrier is i tted (vehicle i tted with
towing attachment or bicycle carrier
recommended by PEUGEOT).
In bad or wintry weather, ensure that
the sensors are not covered with
mud, frost or snow. When reverse
gear is engaged, an audible signal
(long bleep) indicates that the
sensors may be dirty. The proximity information is given
by:
- an audible signal, which becomes
more rapid as the vehicle
approaches the obstacle,
- a graphic on the multifunction display, with blocks which become
progressively closer to the vehicle.
Depending on the multifunction
display, the audible signal is
transmitted by a buzzer or by the rear
speakers which transmit:
- on the right if an obstacle is detected on the right,
- on the left if an obstacle is detected on the left,
- on the right and on the left if an obstacle is detected in the centre.
When the distance between the
rear of the vehicle and the obstacle
is less than approximately thirty
centimetres, the audible signal
becomes continuous and the
"Danger" symbol appears depending
on the multifunction display.
 Change to neutral, the system is
again inactive.
If there is an operating
fault, when reverse gear is
engaged, the service warning
light comes on, accompanied
by an audible signal (short bleep)
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
Activation/Deactivation
Activation
The system is activated as soon as
reverse gear is engaged.
This is accompanied by an audible
signal and displaying of the vehicle,
depending on the multifunction
display. The system can be activated
or deactivated from the
multifunction display
coni guration menu.
The activation and deacti-
vation of the system are memorised
when the engine is switched off.
Switching the system off

160
ESCLIST
MENU
ESC
MENU LIST
ESC
MENU LIST
ESC
MENU LIST
ESC
MENU LIST
MENU1
2
3
4 5
6
7
8
ESC
MENU LIST
ESC
MENU LIST
ESC
MENU LIST
03
GUIDANCE OPTIONS GPS
The route chosen by the RT4 GPS audio/telephone depends directly on the guidance options.
Changing these options may completely change the ro ute.
Press the MENU button.
Turn the dial and select the
NAVIGATION GUIDANCE function.
Press the dial to conirm the selection.
Turn the dial and select the
GUIDANCE OPTIONS function. Turn the dial and select the DEFINE
CALCULATION CRITERIA function.
Press the dial to conirm the selection.
Press the dial to conirm the selection.
GUIDANCE OPTIONSDISTANCE/TIME
DEFINE CALCULATION CRITERIA
Turn the dial and select, for example,
the DISTANCE/TIME function.

173
1
SOURCE
2
S
O S SOURCE
MODE BAND T
PTA YDARK
SOURCE
2abc5jkl8tuv
3def6mno9wxyz
1 4
ghi7pqrs
0 #
2abc5jkl8tuv
3def6mno9wxyz
1 4ghir7pq s0 #
S
O S SOURCE
MODE BAND T
PTA YDARK
SOURCESOURCE
ESC
MENU LIST
1
3
2Press the MENU button then select the CONFIGURATION
function,
then SOUNDS, then ACTIVATE AUXILIARY SOURCE to acti vate
the auxiliary input of the RT4 GPS audio/telephone.
Connect the portable equipment (MP3
player…) to the audio sockets (white and
red, RCA type) located in the glove box
using a JACK/RCA audio cable.
Press the SOURCE button several
times in succession and select AUX. Insert one or more CDs in the
changer.
Press the SOURCE button several
times in succession and select CD
CHANGER.
Press one of the buttons on the
alphanumeric keypad to select the
corresponding CD.
Press one of the buttons to select a
track on the CD.
The displaying and management of the commands takes place via
the portable equipment.
It is not possible to copy the iles onto the hard d isc from the auxiliary
input. It is not possible to copy the iles onto the hard d
isc from the
CD changer.
USING THE AUXILIARY INPUT (AUX)
JACK/RCA AUDIO CABLE NOT SUPPLIED
CD CHANGER
PLAYING A CD (NOT MP3 COMPATIBLE)

188
1
2
3
12
Insert the CDs in the changer one by
one.
Press the SOURCE button several
times in succession and select CD
CHANGER.
Press one of the buttons on the
numeric keypad to select the
corresponding CD.
Press one of the buttons to select a
track on the CD.
Press and hold one of the buttons for
fast forwards or backwards play. Insert circular compact discs only.
Some anti-pirating systems, on original discs or CD
s
copied using a personal recorder, may cause faults
which are no relection on the quality of the origin al
player.
Without pressing the EJECT button, insert a CD in t he
player, play begins automatically.
To play a disc which has already been
inserted, press the SOURCE button
several times in succession and select
CD. Press one of the buttons to select a
track on the CD.
Press the LIST REFRESH button to
display the list of tracks on the CD.
CD CHANGER
PLAYING A CD (NOT MP3 COMPATIBLE)
CD
PLAYING A CD