2007.5 Peugeot 307 brake light

DRIVING
98
HANDBRAKE
Applying
Pull the handbrake to immobilise
your vehicle. When the vehicle is being
driven, illumination of
this warning light and
of the STOP warning
light, accompanied by an
audible signal and a message on the
multifunction etdisplay, indicates that
the handbrake is still on or has not
been properly released.
When parking on a slope,
direct your wheels towards
the pavement and pull the
handbrake.
Releasing
Pull on the handle and press the
button to release the handbrake.
The four or six speed automatic
gearbox offers a choice between
the comfort of integral automatic
operation , enhanced by a sport and
a snow programme, or manual gear
changing .
P ark: to immobilise the vehicle or

start the engine , with the handbrake
on or off.

R everse: to reverse (select this
position with the vehicle stationary,
engine at idle).

N eutral: to start the engine and to

park , with the handbrake on.

Note: if position N is engaged
inadvertently while driving, allow
the engine to return to idle before
engaging position D to accelerate.

D rive: for driving in automatic
mode.

M anual: to select the gears.

S : sport programme.

 : snow programme.
Gear selection gate

 Move the lever in the gate to
select a position.
The indicator light for the selection is displayed on the instrument
panel display.
Starting the engine

 with the handbrake applied,
select position P or N in the gate,

 turn the ignition key to the

Starting position.
Otherwise, you are warned by an
audible signal and a message on the
multifunction display.
"PORSCHE TIPTRONIC
SYSTEM" AUTOMATIC
GEARBOX

CHECKS
115
CHECKING THE LEVELS
There are two marks on
the dipstick:

A = maximum
Never i ll past this mark.

B = minimum
Oil change
According to the information given in
the servicing booklet.
Viscosity selection
In all cases, the oil selected must
meet the manufacturer’s require-
ments.
Note: the coolant does not need to
be changed.
Dipstick
Cooling system
Use the l uid recommended by the
manufacturer.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. This fan can oper-
ate with the ignition off.

In the case of vehicles i tted with
a particle emission i lter, the fan
can operate after the vehicle has
stopped, even when the engine is
cold.
In addition, as the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
top up the level.
Windscreen and headlamp
wash level
Diesel additive level (Diesel
with particle emission filter)
If the service warning light comes on,
accompanied by a message and an
audible signal, this indicates a low
diesel additive level.
This additive must be topped up.
Contact a PEUGEOT dealer as soon
as possible.
Brake fluid level
* According to engine.
Oil level
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited.
The level should always be
above the MIN mark and
close to the MAX mark.
Power steering reservoir
Remove the style trim * (see §
"Changing a bulb - Front lights").
Open the reservoir, with the engine
at ambient temperature. The level
should always be above the MIN.
mark and close to the MAX. mark.
For best quality cleaning and
for your safety, we would ad-
vise that you use products
recommended by PEUGEOT.


Check the level regularly and
top up between changes. The
maximum consumption is 0.5 l
per 600 miles (1 000 km).

Check the level with the ve-
hicle level, engine cold, using the oil
level gauge on the instrument panel
or the dipstick. Replacement must be car-
ried out according to the
manufacturer’s servicing
schedule.
Use l uids recommended by
the manufacturer, which fuli l DOT4
standards.

10PRACTICAL INFORMATION
126

1. Direction indicators (P 21 W).

2. Reversing lights (P 21 W),
left-hand side.
Fog lamp (P 21 W), right-hand
side.

3. Brake lights (P 21 W).

4. Side lights (x 2) (R 5 W).
 Using a 10 mm box spanner,
unscrew the 2 i xing nuts 1 .

 Release the lamp unit by pushing
it outwards.

 Squeeze the two tabs 2 to release
the bulb holder.

 Change the faulty bulb.

 When rei tting, ensure that the
lamp unit seal has been put back
in place correctly.
These 6 bulbs are changed from
inside the boot:

 Move aside the boot trim to
access the bulb holder,

 Press the two tabs and remove
the bulb holder,

 Change the faulty bulb.
When rei tting, take care to pass the
trim under the seal.
Rear lights (saloon) Third brake light (saloon)
(4 W 5 W bulbs)

10PRACTICAL INFORMATION
127

 Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direction
of engagement.

 Insert a screwdriver into the two
outer holes B to press on the two
tabs C .

 Push the light unit outwards while
maintaining the pressure on the
tabs.

 Pull the light unit outwards while
tilting it.

 Change the faulty bulb.

 When rei tting, ensure that the
light unit tabs are engaged
correctly and that the tailgate
upper trim has been put back in
place correctly.

1. Brake lights (P 21 W).

2. Side lights (x 2) (R 5 W).

3. Direction indicators (P 21 W).

4. Reversing light (P 21 W),
left-hand side.
Fog lamp (P 21 W), right-hand
side.
These 6 bulbs are changed by
removing the light:

 Remove the corresponding boot
side trim to access the light,

 Remove the light i xing nut inside
the boot,

 Remove the light i xing nut out-
side the boot,

 Remove the light,

 Unclip the harness,
 Remove the bulb holder pressing
on the tabs A ,

 Change the faulty bulb.

Note: if necessary, use the wheel-
brace to remove the nuts.
When rei tting, take care to position
the bulb holder and the light
correctly.
Number plate lights
(W 5 W)

 Insert a thin screwdriver into one
of the external holes of the lens.

 Push it outwards to unclip it.

 Remove the lens.

 Change the faulty bulb.
Rear lights (estate) Third brake light (estate)
(4 W 5 W bulbs)

11TECHNICAL DATA
147
SALOON WEIGHTS AND TOWING LOADS (in kg)
* The weight of the braked trailer can be increased, within the GTW, if the GVW of the towing vehicle is reduced b y an equal amount; warning, towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.

Petrol engines
2 litre 16V 143 bhp

Gearbox
Manual Auto.

Model codes:
3C… 3A…
RFJC RFJF

11TECHNICAL DATA
148
SALOON WEIGHTS AND TOWING LOADS (in kg)
* The weight of the braked trailer can be increased, within the GTW, if the GVW of the towing vehicle is reduced b y an equal amount; warning, towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.

Diesel engines
1.6 litre Turbo HDI 16V
90 bhp
1.6 litre Turbo HDI 16V
110 bhp
2 litre Turbo HDI 16V

Gearbox
Manual Manual Manual Auto.

Model codes:
3C… 3A…
9HXC 9HVC 9HZC
9HYB

9HYC
RHRH RHRJ

11TECHNICAL DATA
149
VAN WEIGHTS AND TOWING LOADS (in kg)
* The weight of the braked trailer can be increased, within the GTW, if the GVW of the towing vehicle is reduced b y an equal amount; warning, towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.

Engines
1.4 litre 16V
1.6 litre Turbo HDI 16V
90 bhp
1.6 litre Turbo HDI 16V

110 bhp

Gearboxes Manual Manual Manual

Model codes:

3G... 3X...
KFUC 9HXC 9HZC
9HYB

9HYC

11TECHNICAL DATA
150
ESTATE WEIGHTS AND TOWING LOADS (in kg)
* The weight of the braked trailer can be increased, within the GTW, if the GVW of the towing vehicle is reduced b y an equal amount; warning, towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.

Petrol engines
1.4 litre 16V
1.6 litre 16V

1.6 l. 16V BioFlex

Gearbox
Manual Manual Auto.

Model codes: 3E…
KFUC
NFUC

NFUC/FF
NFUF