2007.5 Peugeot 207 Dag spare wheel
[x] Cancel search: spare wheelPage 64 of 223
i
61
Hooks Hooked onto the stowing rings, this ena-
bles you to secure your luggage, either
to the bottom of the boot or to the back
of the rear seats.
Rear shelf (Saloon)
To remove the shelf:
unhook the two cords,
raise the shelf slightly, then remove it. The hooks permit the securing of shop-
ping bags. Luggage retaining net
When changing a wheel
The hooks permit easy access to
the spare wheel by retaining the
boot carpet by means of its cord.
You have two storage options:
- either upright behind the front seats,
- or upright behind the rear seats.
Page 112 of 223
!
i
i
i
SAFETY
100
TYRE UNDER-INFLATION
DETECTION
System which automatically checks the
pressure of the tyres while driving. All repairs and changing of tyres
o n a w h e e l i t t e d w i t h t h i s s y s t e m
must be carried out by a PEUGEOT
dealer.
If, when changing a tyre, you ins-
tall a wheel which is not detected
b y y o u r v e h i c l e ( e x a m p l e : i t t i n g
of snow tyres), you must have the
system reinitialised by a PEUGEOT
dealer.
This system does not eliminate
the need to have the tyre pres-
sure checked regularly (refer to the
" I d e n t i i c a t i o n f e a t u r e s " p a r a g r a p h )
to ensure that the optimum dynamic
performance of the vehicle is main-
tained and prevent premature wear
of the tyres, particularly in arduous
driving conditions (heavy load, high
speed).
The tyre pressures must be checked
cold, at least once a month. Re-
member to check the pressure of
the spare wheel.
T h e t y r e u n d e r - i n l a t i o n d e t e c t i o n
system may experience temporary
interference due to radioelectric
emissions on a frequency close to
that used by the system.
S e n s o r s i t t e d i n e a c h v a l v e t r i g g e r a
warning in the event of malfunction
(speed above 12 mph (20 km/h).
A message appears on the multifunc-
tion display, accompanied by an audible
signal, to locate the wheel concerned.
Check the tyre pressures as soon
as possible.
This check must be carried out when
the tyres are cold.
Flat tyre
This warning light and the
STOP
warning light come on on the ins-
trument panel, accompanied by
an audible signal and a mes-
sage on the multifunction display
locating the wheel concerned.
Stop immediately, avoiding any sud-
den movement of the steering wheel
and the brakes.
Change the damaged wheel (punc-
t u r e d o r v e r y d e l a t e d t y r e ) , a n d
have the tyre pressure checked as
soon as possible.
Puncture
T h e t y r e u n d e r - i n l a t i o n d e t e c t i o n
system is an aid to driving which does
not replace the need for the driver to
be vigilant or to drive responsibly. Sensor(s) not detected or
faulty
A message appears on the multifunc-
tion display, accompanied by an audi-
ble signal, to locate the wheel or wheels
which are not detected or to indicate a
fault in the system.
Contact a PEUGEOT dealer to replace
the faulty sensor(s).
This message is also displayed
when one of the wheels is away
from the vehicle (being repaired) or
when one or more wheels without a
s e n s o r a r e i t t e d .
T h e s p a r e w h e e l i s n o t i t t e d w i t h
a sensor.
Page 139 of 223
i
127
CHANGING A WHEEL
Procedure for changing a faulty wheel
for the spare wheel using the tools pro-
vided with the vehicle.
The tools are installed in the boot under
t h e l o o r .
To gain access to them:
open the boot,
r a i s e t h e l o o r ,
secure it by hooking the cord(s) on
the hook(s) on the rear shelf sup-
port,
remove the box containing the
tools.
1. Wheelbrace.
Permits removal of the wheel trim and removal of the wheel
i x i n g b o l t s .
2. Jack with integral handle.
Permits raising of the vehicle.
3. "Bolt cover" tool.
Permits removal of the bolt protectors (covers) on alloy
wheels.
4. Socket for the anti-theft bolts
(located in the glove box).
Permits adaptation of the wheelbrace to the special
"anti-theft" bolts.
List of tools Other accessories
5. Removable towing eye.
Refer to the paragraph "Towing the vehicle".
Access to the tools
Wheel with trim
When removing the wheel , detach
t h e t r i m i r s t u s i n g t h e w h e e l b r a c e 1
pulling at the valve passage hole.
W h e n r e i t t i n g t h e w h e e l , r e i t t h e
trim starting by placing its notch fac-
ing the valve and press around its
edge with the palm of your hand.
Page 140 of 223
i
i
128
Fixing the steel or "space-
saving" type spare wheel
I f y o u r v e h i c l e i s i t t e d w i t h a l -
loy wheels, it is normal to notice,
w h e n t i g h t e n i n g t h e b o l t s o n i t t i n g ,
that the washers do not come into
contact with the steel or "space-
saving" type spare wheel. The
wheel is secured by the conical
contact of each bolt.
Access to the spare wheel
(Saloon)
The spare wheel is installed in the boot
u n d e r t h e l o o r .
According to model, the spare wheel may
be steel or of the "space saving" type.
To gain access to it, refer to the para-
graph "Access to the tools" on the pre-
vious page. Taking out the wheel
Unscrew the yellow central bolt.
Raise the spare wheel towards you
from the rear.
Take the wheel out of the boot.
Putting the wheel back in place
Put the wheel back in its housing.
Unscrew the yellow central bolt by a
few turns then put it in place in the
centre of the wheel.
Tighten fully until the central bolt
clicks to retain the wheel correctly.
Put the box back in place in the cen-
tre of the wheel.
P u t t h e b o o t l o o r b a c k i n p l a c e .
T y r e u n d e r - i n l a t i o n d e t e c t i o n
T h e s p a r e w h e e l i s n o t i t t e d w i t h
a sensor. The punctured wheel
must be repaired by a PEUGEOT
dealer.
Page 141 of 223
i
i
129
Fixing the steel or "space-
saving" type spare wheel
I f y o u r v e h i c l e i s i t t e d w i t h a l -
loy wheels, it is normal to notice,
w h e n t i g h t e n i n g t h e b o l t s o n i t t i n g ,
that the washers do not come into
contact with the steel or "space-
saving" type spare wheel. The
wheel is secured by the conical
contact of each bolt.
Access to the spare wheel (SW)
The spare wheel is installed in the boot
u n d e r t h e l o o r .
According to model, the spare wheel
may be steel or of the "space saving"
type.
To gain access to it, refer to the para-
graph "Access to the tools". Taking out the wheel
Unscrew the yellow central bolt.
Raise the spare wheel towards you
from the rear.
Take the wheel out of the boot.
Putting the wheel back in place
Put the wheel back in its housing.
Unscrew the yellow central bolt by a
few turns then put it in place in the
centre of the wheel.
Tighten fully until the central bolt
clicks to retain the wheel correctly.
Put the box back in place in the cen-
tre of the wheel.
P u t t h e b o o t l o o r b a c k i n p l a c e .
T y r e u n d e r - i n l a t i o n d e t e c t i o n
T h e s p a r e w h e e l i s n o t i t t e d w i t h
a sensor. The punctured wheel
must be repaired by a PEUGEOT
dealer.
Page 142 of 223
i
130
Parking the vehicle
Immobilise the vehicle where it does
n o t b l o c k t r a f i c : i f p o s s i b l e , p a r k t h e
vehicle on level, stable and non-
slippery ground.
Apply the handbrake, switch off the
i g n i t i o n a n d e n g a g e i r s t g e a r * t o
lock the wheels.
If necessary, place a chock under
the wheel diagonally opposite the
wheel to be changed.
Never go underneath a vehicle raised
using a jack; use an axle stand.
Removing the wheel
List of operations
Remove the chromed bolt cover from
each of the bolts using the tool 3 .
Fit the anti-theft socket 4 on the
wheelbrace 1 to unlock the anti-theft
bolt.
Unlock the other bolts using the
wheelbrace 1 only.
Place the jack 2 in contact with one
of the two front A or rear B locations
provided on the underframe, which-
ever is closest to the wheel to be
changed.
Extend the jack 2 until its base plate
is in contact with the ground. Ensure
that the centreline of the jack base
plate is directly below the location A
or B used.
Raise the vehicle until there is suf-
i c i e n t s p a c e b e t w e e n t h e w h e e l a n d
the ground to admit the spare (not
punctured) wheel easily.
Remove the bolts and store them in
a clean place.
Remove the wheel.
Page 143 of 223
i
131
After changing a wheel
To store the punctured wheel in the
b o o t c o r r e c t l y , i r s t r e m o v e t h e c e n -
tral cover.
When using the "space-saving" type
spare wheel, do not exceed 50 mph
(80 km/h).
Have the tightening of the bolts and
the pressure of the spare wheel
checked by a PEUGEOT dealer with-
out delay.
Have the punctured wheel repaired
and replace it on the vehicle as
soon as possible.
Fitting the wheel
List of operations
Put the wheel in place on the hub.
Screw in the bolts by hand to the
stop.
Pre-tighten the anti-theft bolt using
the wheelbrace 1 i t t e d w i t h t h e a n t i -
theft socket 4 .
Pre-tighten the other bolts using the
wheelbrace 1 only.
Lower the vehicle fully.
Fold the jack 2 and detach it.
Lock the anti-theft bolt using the
wheelbrace 1 i t t e d w i t h t h e a n t i -
theft socket 4 .
Lock the other bolts using the wheel-
brace 1 only.
R e i t t h e c h r o m e d b o l t c o v e r s o n
each of the bolts.
Store the tools in the box.
Page 162 of 223
!
i
149
T h e i t t i n g o f e l e c t r i c a l e q u i p m e n t
or accessories which are not re-
commended by PEUGEOT may
result in a failure of your vehicle's
electronic system.
P l e a s e n o t e t h i s s p e c i i c w a r n i n g .
You are advised to contact a rep-
resentative of the Marque to be
shown the range of recommended
equipment and accessories.
ACCESSORIES
You can obtain a wide range of accesso-
ries and original parts from the PEUGEOT
network.
These accessories and parts have been
tested and approved for reliability and
safety.
They are all adapted to your vehicle and
b e n e i t f r o m P E U G E O T ' s r e c o m m e n d a -
tion and warranty.
The product range offered by PEUGEOT
Accessories is structured around 5 cate-
gories: PROTECTION - TOURING -IN-CAR
TECHNOLOGY - STYLING - UNIVERSAL.
"Protection": "Touring":
"In-car technology":
"Styling":
"Universal":
You can obtain "Van" conversion kits to
transform a private vehicle into a van.
* T o a v o i d a n y r i s k o f j a m m i n g o f t h e pedals:
- ensure that the mat is positioned and secured correctly,
- n e v e r i t o n e m a t o n t o p o f a n o t h e r . Depending on the country in which
the vehicle is sold, it is compulsory
to have a safety jacket, warning tri-
angle and spare bulbs available in
the vehicle.
anti-theft alarm, window en-
g r a v i n g , w h e e l l o c k s , i r s t a i d
kit, warning triangle, safety
jacket, stolen vehicle tracking
system, snow chains.
m a t s * , b o o t t r a y , l u g g a g e n e t ,
i x e d c o a t h o o k o n h e a d r e s t r a i n t ,
aluminium or PVC door sills.
For leisure pursuits: roof bars,
bicycle carrier on towbar, bi-
cycle carrier on roof bars, ski
carrier, roof box, booster seats
and child seats, side blinds
and rear blind, front centre armrest, CD
storage, under shelf storage.
T r a i l e r t o w b a r w h i c h m u s t b e i t t e d b y
the PEUGEOT network.
audio systems, telephone, am-
p l i i e r s , s a t e l l i t e n a v i g a t i o n s y s -
tems, hands-free kit, CD changer,
speakers, DVD player, connection
kit for MP3 player or portable CD
player, rear parking assistance.
seat covers compatible with
side air bags, aluminium gear
lever knob, fog lamps, door de-
l e c t o r s , s p o i l e r , s t y l i n g s t r i p s ,
alloy wheels, trims, sport ex-
haust, chromed mirror shells. screenwash, interior and exte-
rior maintenance and cleaning
products.