Page 41 of 231
44
II
1
2
10
9
3
4
5
6
7
8
F I X E D C E N T R E D C O N T R O L S S T E E R I N G
W H E E L
1
Rotate- Scroll through the different information screens on instrument panel- Move through the different instrument panel menus- Increase/reduction of values
Shor t press- Open the instrument panel menu (only when vehicle s tationar y)- Select and validate information
Long pressReset the trip computer (if the trip computer page is displayed)
2Shor t press- Cancel the current operation- Return to the previous instrument panel display
Long pressReturn to the original instrument panel display
3Shor t pressIncrease speed in steps of 1 km/h/memorisation of sp eed
Press and holdIncrease speed in steps of 5 km/h
4Shor t pressReduce speed in steps of 1 km/h/memorisation of spee d
Press and holdReduce speed in steps of 5 km/h
5Shor t pressSuspend or restar t cruise control/speed limiter (depending on mode selected)
6Shor t pressSelect cruise control or speed limiter (the cycle on this button always star ts with the speed limiter selector)
7Shor t pressDeactivation
8Shor t press
- Pick up an incoming call- Hang up during a call- Open the contextual telephone menu- Validate in the telephone list or menu
Long pressRefuse an incoming call
9S h o r t p r e s s / Long pressHorn
10Shor t pressActivation/deactivation of Black Panel mode (night d riving)
Page 45 of 231
48
IIAB
F o r v e h i c l e s fi t t e d w i t h r e a r foglamps:1st turn forwards: lighting of rear foglamps.1st turn rearwards: extinction of rear foglamps.
F o r v e h i c l e s fi t t e d w i t h f r o n t and rear foglamps:1st turn forwards: lighting of front foglamps.2nd turn forwards: lighting of rear foglamps.1st turn rearwards: extinction of rear foglamps.2nd turn rearwards: extinction of front foglamps.Note: the foglamps should be used only in fog or in other conditions of poor visibility.
-
-
-
-
-
-
FRONT AND REAR FOGLAMPS (RING B)
These operate in conjunction with the sidelamps, the dipped beams or the main beams.
S I G N A L L I N G
GUIDE-ME-HOME LIGHTING
With the ignition off, this function temporarily switches on your head-lamps to give you exterior lighting when leaving your vehicle.
This function is activated:Manually by pulling the lighting stalk towards you, ignition off.Automatically in the following conditions:
automatic headlamp lighting is activated,guide-me-home lighting is activated.brightness conditions are low.using button A on the remote control.
You can modify the length of time guide-me-home lighting stays on for (around 60, 30 or 15 seconds) using the “Main Menu” of the instru-ment panel screen.
See “Instrument panel screen”.
Page 47 of 231
50
II
With dipped beams or main beams, the Directional headlamps function turns the headlamps in the direction the road ahead is taking. Your vision on bends is considerably enhanced.
This function is activated once your vehicle speed reaches 10 km/h (6 mph) and stops when your speed decreases to 5 km/h (3 mph).Note: An automatic correction of the beam height enables you not to dazzle other drivers.
X E N O N D U A L F U N C T I O N D I R E C T I O N A L
H E A D L A M P S - A N G L E D L I G H T I N G
Function activatedFunction deactivated
Activation/Deactivation
Activated by default, this function can be activated/deactivated in the “Main Menu” of the instrument panel screen. To do so, select “Vehicle parameters / Lighting / Directional headlamps”.
The activated/deactivated status is retained when you switch off the engine.Note: This function is not active when the vehicle is stationary, moving at very low speed, or in reverse gear.
I f t h e r e i s a m a l f u n c t i o n , t h e “ D i p p e d b e a m s ” w a r n i n g l a m p fl a s h e s , a c c o m p a n i e d b y a m e s s a g e on the instrument panel. Contact a CITROËN dealer. I f t h e r e i s a m a l f u n c t i o n , t h e “ D i p p e d b e a m s ” w a r n i n g l a m p fl a s h e s , a c c o m p a n i e d b y a m e s s a g e I f t h e r e i s a m a l f u n c t i o n , t h e “ D i p p e d b e a m s ” w a r n i n g l a m p fl a s h e s , a c c o m p a n i e d b y a m e s s a g e
This device is linked with the Angular lighting which lights up the inside of a bend when the vehicle speed is lower than 40 km/h (25 mph). This maximises the lighting at intersectio ns and when parking, for example.
The angular lighting is deployed:When the direction indicators are activated,
and/orfrom a certain angle of rotation of the steering wheel.
Note: The angular lighting is deactivated when the directional headlamps are deactivated.
Page 54 of 231
57
II
CBDA
F R O N T S E A T S
E L E C T R I C A L A D J U S T M E N T S
The Welcome function
When the driver's door is opened and the ignition is off, the seat moves to ease accessing or leav-ing the vehicle.
You may activate or deactivate this function using the “Main Menu” on the instrument panel screen. To do so, select “Vehicle parameters / Comfort / Driver welcome”.
Head restraint height and angle adjustments on elec-tric seats
To adjust the angle of the head restraint, push back or pull forward section C of the head restraint until you reach the desired position.
To raise it, pull upwards.
To lower it, press on the control Dto unlock it, and simultaneously on the head restraint itself.
To raise it, press control D to unlock it, then pull it upwards.
0: Off.
1: Gentle.
2: Medium.
3: Strong.
Controls for the heated seats
The front seats can be heated indi-vidually. With the engine running, use control A, located beside the seats to choose between three heating levels:
Massage function
This function provides the driver with a back massage.
To activate the massage, with the engine runnuing, press on but-ton B. The warning lamp comes on and the massage function is acti-vated for a period of 1 hour. During this time, massage is performed in cycles of 6 minutes (4 minutes of massage followed by 2 minutes break). In total, the system will per-form 10 cycles.
After 1 hour, the function is deacti-vated. The warning lamp goes out.
You can deactivate the massage function at any time by pressing on button B.
Page 61 of 231
65
II
3
5
4
2
1
A
This driving assistance function allows you to drive at the speed of your choice without the need to action the accelerator. It is active over speeds of around 40 km/h (25 mph).
Remark: For the function to be active, the gearbox must be in at least:4th gear for manual gearboxes.2nd gear for automatic gear-boxes.
The cruise control controls are located on the left-hand side of the steering wheel and cruise control information is displayed in zone Aof the instrument panel.
Page 63 of 231
67
II
3
5
4
2
1
A
S P E E D L I M I T E R
This driving aid allows you to choose a maximum speed that you do not wish to exceed. This has to be over 30 km/h (19 mph).
The speed limiter controls are located on the steering wheel.Note: The speed limiter informa-tion is displayed in zone A of the instrument panel.
To select the function
Press on button 4 to select speed limiter mode “LIMIT”.
T h e s e l e c t i o n i s c o n fi r m e d b y t h e display of the function in zone A of the instrument panel.
To adjust the maximum speed
With the engine running, you can adjust the memorised maximum speed, displayed in zone A, by pressing on:Button 1 to increase the memo-rised maximum speed.
Button 2 to decrease the mem-orised maximum speed.
Remark: Successive presses will modify the cruise speed in steps of 1 km/h and a continuous press in steps of 5 km/h (3 mph).
Page 65 of 231
69
II
A
D e fl a t i o n d e t e c t i o n
T h i s f u n c t i o n w a r n s y o u o f t y r e s t h a t a r e d e fl a t e d o r p u n c t u r e d .
Automatic detection
Sensors monitor the tyre pressures while driving. In the event of a n anom-aly, a message will appear on the instrument panel screen.
Driver request detection
You can check the tyre pressures at any given moment. To do so, press on button A (CHECK) ; the information will be displayed on the instrument panel screen.
Display of tyres in good condition
Automatic detection:
A m e s s a g e i n d i c a t e s t o y o u w h i c h t y r e i s d e fl a t e d .
Driver request detection:
T h e v e h i c l e o u t l i n e i n d i c a t e s t h e d e fl a t e d t y r e ( s ) .
T Y R E D E F L A T I O N D E T E C T I O N
T y r e d e fl a t i o n a l e r t
T h e s y s t e m i n d i c a t e s t o y o u t h a t t h e t y r e s a r e c o r r e c t l y i n fl a t e d .
This information is only available on the request of the driver.
Press on Check
Press on CheckAutomatic detection
The message is accompanied by the SERVICE warning lamp lighting up and a beep.
Check the tyre pressures as soon as possible.
Page 69 of 231
73
II
A U T O M A T I C G E A R B O X
The engine can only be started when the lever is at position P or N.
A safety device ensures that starting is impossible in the other positions.
Once the engine has been started, with the gear lever at P, press on the brake pedal then place the lever at:D for automatic mode.
R for reverse gear.M to change to manual mode.
The change from position D (driving in automatic mode) to position M (driv-ing in sequential mode) or vice versa can be made at any time.
The gear selected is displayed on the instrument panel.
