Page 16 of 424

Idle speed adjustment ...................... 8-65
Valve clearance adjustment ............. 8-67
Throttle lever adjustment .................. 8-69
Front and rear brake pad
inspection ....................................... 8-71
Brake fluid level inspection ............... 8-73
Brake fluid replacement .................... 8-77
Front brake lever free play ............... 8-79
Brake pedal height adjustment ......... 8-81
Parking brake adjustment ................. 8-83
Adjusting the rear brake light switch . 8-87
Clutch lever free play adjustment ..... 8-89
Drive chain slack check .................... 8-91
Adjusting the drive chain slack ......... 8-93
Lubricating the drive chain ............... 8-97
Cable inspection and lubrication .... 8-101
Brake and shift pedal/brake and
clutch lever lubrication .................. 8-103
Front upper and lower arm pivot
lubrication ..................................... 8-105
Rear arm pivot lubrication .............. 8-107Wheel removal ............................... 8-111
Wheel installation ........................... 8-113
Battery ............................................ 8-115
Battery maintenance ...................... 8-119
Fuse replacement ........................... 8-121
Replacing a headlight bulb ............. 8-125
Headlight beam adjustment ............ 8-131
Tail/brake light ................................ 8-131
Troubleshooting .............................. 8-133
Troubleshooting chart ..................... 8-137
CLEANING AND STORAGE ................ 9-1
A. CLEANING ..................................... 9-1
B. STORAGE ..................................... 9-7
SPECIFICATIONS .............................. 10-1
Conversion table ................................. 11-1
9
10
11
1S3-9-60 1-3 4/27/05 3:11 PM Page 14
Page 66 of 424
4-9
1
2
3
1. Light switch “LIGHTS”
2. Engine stop switch “ENG. STOP”
3. Start switch “START”
1. Contacteur d’éclairage “LIGHTS”
2. Coupe-circuit du moteur “ENG. STOP”
3. Contacteur du démarreur “START”
1. Interruptor de luces “LIGHTS”
2. Interruptor de paro del motor “ENG. STOP”
3. Interruptor de arranque “START”
EBU00530
Handlebar switches
EBU11560
Light switch “LIGHTS”
Set the switch to the “LO” position to turn on the
low beam and the taillight.
Set the switch to the “HI” position to turn on the
high beam and the taillight.
Set the switch to the “OFF” position to turn off all
of the lights.
cC
Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and
recharge it.
1S3-9-60 4 6/7/05 9:37 AM Page 4-9
Page 380 of 424
8-131
EBU14050
Headlight beam adjustment
cC
It is advisable to have a Yamaha dealer make
this adjustment.
To raise the beam, turn the adjusting bolt in
direction a.
To lower the beam, turn the adjusting bolt in
direction b.
EBU15852
Tail/brake light
This model is equipped with an LED type of
tail/brake light.
If the tail/brake light does not come on, have a
Yamaha dealer check it.
1
a
b
1. Adjusting screw1. Vis de réglage1. Tornillo de ajuste
1S3-9-60 9-11 4/27/05 2:13 PM Page 8-131