2006 YAMAHA MAJESTY 180 wheel

EAU26090
Care
While the open design of a scooter
reveals the attractiveness of the tech-
nology, it also makes it more vulnera-
ble. Rust and corrosion can develop
even if high-quality components are
used. A rusty exhaust pipe may go
unnoticed on a car, however, it
detracts from the overall appearance
of a scooter. Frequent and proper
care does not only comply with the
terms of the warranty, but it will also
keep your scooter looking good,
extend its life and optimize its perfor-
mance.
Before cleaning
1. Cover the muffler outlet with a
plastic bag after the engine has
cooled down.
2. Make sure that all caps and
covers as well as all electrical
couplers and connectors, inclu-
ding the spark plug cap, are
tightly installed.
3. Remove extremely stubborn dirt,
like oil burnt onto the crankcase,
with a degreasing agent and a
brush, but never apply such pro-ducts onto seals, gaskets and
wheel axles. Always rinse the dirt
and degreaser off with water.
Cleaning
ECA10780
CAUTION
Avoid using strong acidic whe-
el cleaners, especially on spo-
ked wheels. If such products
are used on hard-to-remove
dirt, do not leave the cleaner on
the affected area any longer
than instructed. Also, tho-
roughly rinse the area off with
water, immediately dry it, and
then apply a corrosion protec-
tion spray.
Improper cleaning can damage
windshields, cowlings, panels
and other plastic parts. Use
only a soft, clean cloth or spon-
ge with mild detergent and
water to clean plastic.
Do not use any harsh chemical
products on plastic parts. Be
sure to avoid using cloths or
sponges which have been in
contact with strong or abrasive
cleaning products, solvent orthinner, fuel (gasoline), rust
removers or inhibitors, brake
fluid, antifreeze or electrolyte.
Do not use high-pressure was-
hers or steam-jet cleaners sin-
ce they cause water seepage
and deterioration in the follo-
wing areas: seals (of wheel and
swingarm bearings, fork and
brakes), electric components
(couplers, connectors, instru-
ments, switches and lights),
breather hoses and vents.
For scooters equipped with a
windshield: Do not use strong
cleaners or hard sponges as
they will cause dulling or scrat-
ching. Some cleaning com-
pounds for plastic may leave
scratches on the windshield.
Test the product on a small hid-
den part of the windshield to
make sure that it does not lea-
ve any marks. If the windshield
is scratched, use a quality
plastic polishing compound
after washing.
7
SCOOTER CARE AND STORAGE
7-1
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 54

NOTE:
Consult a Yamaha dealer for advice
on what products to use.
EAU26300
Storage
Short-term
Always store your scooter in a cool,
dry place and, if necessary, protect it
against dust with a porous cover.
ECA10820
CAUTION
Storing the scooter in a poorly
ventilated room or covering it
with a tarp, while it is still wet,
will allow water and humidity to
seep in and cause rust.
To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chemi-
cals are stored.
Long-term
Before storing your scooter for seve-
ral months:
1. Follow all the instructions in the
“Care” section of this chapter.2. Drain the carburetor float cham-
ber by loosening the drain bolt;
this will prevent fuel deposits
from building up. Pour the drai-
ned fuel into the fuel tank.
3. Fill up the fuel tank and add fuel
stabilizer (if available) to prevent
the fuel tank from rusting and the
fuel from deteriorating.
4. Perform the following steps to
protect the cylinder, piston rings,
etc. from corrosion.
a. Remove the spark plug cap and
spark plug.
b. Pour a teaspoonful of engine oil
into the spark plug bore.
c. Install the spark plug cap onto
the spark plug, and then place
the spark plug on the cylinder
head so that the electrodes are
grounded. (This will limit sparking
during the next step.)
d. Turn the engine over several
times with the starter. (This will
coat the cylinder wall with oil.)
e. Remove the spark plug cap from
the spark plug, and then install
the spark plug and the spark plug
cap.
EWA10950
s s
WARNING
To prevent damage or injury from
sparking, make sure to ground the
spark plug electrodes while turning
the engine over.
5. Lubricate all control cables and
the pivoting points of all levers
and pedals as well as of the
sidestand/centerstand.
6. Check and, if necessary, correct
the tire air pressure, and then lift
the scooter so that both of its
wheels are off the ground. Alter-
natively, turn the wheels a little
every month in order to prevent
the tires from becoming degra-
ded in one spot.
7. Cover the muffler outlet with a
plastic bag to prevent moisture
from entering it.
8. Remove the battery and fully
charge it. Store it in a cool, dry
place and charge it once a
month. Do not store the battery in
an excessively cold or warm pla-
ce [less than 0 °C (30 °F) or more
than 30 °C (90 °F)]. For more
7
SCOOTER CARE AND STORAGE
7-3
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 56

DimensionsOverall length
2030 m
Overall width
745 mm
Overall height
1285 mm
Seat height
774 mm
Wheelbase
1480 mm
Ground clearance
102 mm
Minimum turning radius
102 mm
WeightWith oil and fuel
142 kg
EngineEngine type
Liquid cooled 4-stroke, SOHC
Cylinder arrangement
Forward-inclined single cylinder
Displacement
124.1 cm
3
175.6 cm3
Bore x stroke
53.7 x 54.8 mm
62.2 x 57.8 mm
Compression ratio
11 : 1
11 : 1
Starting system
Electric starterLubrication system
Wet sump
Engine oilType
SAE10W30 or SAE10W40 SE type
Engine oil quantityPeriodic oil change
1.30 L
Transmission oilType
YAMALUBE 4 (10W30) or SAE10W30
type SE motor oil
Cooling systemCoolant reservoir capacity (up to the maxi-
mum level mark)
0.60 L
Air filterAir filter element
Dry element
FuelRecommended fuel
Regular unleaded gasoline only
Fuel tank capacity
10.5 L
CarburetorManufacturer
TEIKEI
Type x quantity
TK28 x 1
TK28 x 1
Spark plug (s)Manufacturer/model
NGK/CR8ESpark plug gap
0.7-0.8 mm
ClutchClutch type
Dry, centrifugal automatic
TransmissionPrimary reduction system
Helical gear
Primary reduction ratio
40/15 (2.666)
Secondary reduction system
Helical gear
Secondary reduction ratio
44/12 (3.666)
Transmission type
V-belt automatic
ChassisFrame type
Steel tube underbone
Caster angle
28.00 degree
Trail
104.0 mm
Front tireType
Tubeless
Size
120/70-12 47L
Manufacturer/model
MICHELIN
CHENG SHIN
PIRELLI
8
SPECIFICATIONS
8-1
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 58

Rear tireType
Tubeless
Size
130/70-12 51L
Manufacturer/model
MICHELIN
GHENG SING
PIRELLI
LoadingMaximum load
183 kg
183 kg
Tire air pressure (measured on cold
tires)
Front
190 kPa
Rear
220 kPa
Front wheelWheel type
Cast wheel
Rim size
12 x MT3.50
Rear wheelWheel type
Cast wheel
Rim size
12 x MT3.50
Front brakeType
Single disc brake
Operation
Right hand operationRecommended fluid
DOT 4
Rear brakeType
Single disc brake
Operation
Left hand operation
Recommended fluid
DOT 4
Front suspensionType
Telescopic fork
Spring/shock absorber type
Coil spring/oil damper
Wheel travel
90.0 mm
Rear suspensionType
Unit swing
Spring/shock absorber type
Coil spring/oil damper
Wheel travel
90 mm
Electrical systemIgnition system
CDI
Charging system
AC magneto
BatteryModel
CB7L-B2
Voltage, capacity
12 V, 8 Ah
Bulb voltage, wattage x quantityHeadlight
12 V, 35 W / 35 W x 2
Tail/brake light
12 V, 21 W / 5 W x 2
Front turn signal light
12 V, 21 W x 2
Rear turn signal light
12 V, 10 W x 2
Meter lighting
12 V, 1.2 W x 2
High beam indicator light
12 V, 1.2 W x 1
Oil level warning light
LED
Fuel level warning light
NONE
FusesMain fuse
20 A
Radiator fan fuse
4 A
Reserve fuse
20 A
Reserve fuse
4 A
8
SPECIFICATIONS
8-2
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 59

AAcceleration and deceleration ...................5-2
Adjusting the brake lever free play ..........6-15
Adjusting the carburetor ..........................6-12
Adjusting the rear shock absorber
assemblies ...............................................3-8
Air filter and V-belt case air filter
elements ................................................6-11
BBattery......................................................6-18
Battery voltage/fuel gauge .........................3-3
Braking .......................................................5-2
CCare............................................................7-1
Clock ..........................................................3-4
Controls and Instruments ..........................2-3
Coolant.....................................................6-10
Changing the brake fluid..........................6-16
Checking and lubricating the cables .......6-16
Checking and lubricating the centerstand
and sidestand ........................................6-17
Checking the brake fluid level .................6-15
Checking the front and rear brake pads..6-15
Checking the front fork ............................6-17
Checking the spark plug ............................6-6
Checking the steering ..............................6-17
Checking the throttle cable free play.......6-12
Checking the wheel bearings ..................6-18
EEngine oil ...................................................6-7
FFinal gear oil...............................................6-9
Front brake lever ........................................3-5
Front storage compartment .......................3-7Fuel ............................................................3-6
Fuel tank cap .............................................3-6
HHandlebar switches ...................................3-4
IIdentification numbers ...............................9-1
Indicator lights ...........................................3-1
LLeft view .....................................................2-1
MMain switch ................................................3-1
Model label ................................................9-2
OOwner’s tool kit ..........................................6-1
PParking .......................................................5-3
Periodic maintenance and lubrication
chart .........................................................6-2
Pre-operation check list .............................4-2
RRear brake lever .........................................3-6
Removing and installing cowlings and
panels ......................................................6-5
Replacing a front turn signal light bulb....6-21
Replacing the fuse ...................................6-20
Replacing the headlight bulb or a front
turn signal light bulb ..............................6-20
Replacing the license plate light bulb......6-21
Replacing the tail/brake light bulb or a
rear turn signal light bulb.......................6-22
Right view ..................................................2-2
SSeat ............................................................3-7
Sidestand ...................................................3-8Sidestand switch operation check ............3-9
Speedometer unit ......................................3-3
Starting a cold engine ................................5-1
Starting off .................................................5-2
Storage.......................................................7-3
Storage compartment ................................3-7
TTires .........................................................6-13
Troubleshooting .......................................6-23
Troubleshooting chart ..............................6-24
INDEX
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 62