*: Recommended to be finished by a YAMAHA specified maintenance station.
**: Use lithium grease.
Replace brake fluid:
1.Replace brake fluid when disassembling the main cylinder or cartridge style cylinder. Check the liquid level
in normal condition, re-fuel if necessary.
2.It's recommended that you should replace the oil seals in the main cylinder and cartridge style cylinder
every 2 years.
3.It's recommended to change brake tube every 4 years, or replace it when found crackles.Steering bearing*
Front fork*Rear shock absorber *V belt
Check the fastening degree of bearing assembly, modify and re-lubricate if necessary.**Check action/leakage, repair if necessary.
Check action/leakage, repair if necessary.
Check the wear and damages, replace if necessary.Check the accessories and fasteners in the chassis. Modify if necessary. Accessory/Fastener*
Center/side stand* Check action, repair if necessary.
Items
1,500km or 2 months
DescriptionRunning-in
500km
1,500km or 2 months
At the firstEvery
MAINTENANCECAUTION:
7-2
MAINTENANCE
■ ■■ ■
■Check front forkThe motorcycle shall be securely
supported when being checked, so
that it would not fall over.1.Visual examination
Check the inner tubes for scratches,
damages or oil leakage.
2.Action examination
Pull the motorcycle to a flat place.
a.Hold the handlebar and keep the
motorcycle upright, grasp the front and
rear brake lever to avoid slipping when
checking.
b.Actuate the handlebar up and right
for several times to check the action
of front fork.
CAUTION:
If you find any damage, oil leakage
or malfunction, ask your agency tocheck it.■ ■■ ■
■Check steering systemWorn or loose steering bearings may
cause danger. Place a stand under the
engine to raise the front wheel off
ground. Hold the lower ends of the
front fork and move them forward and
backward. If any free play can be felt,
ask your agency to check it.
WARNING
Make sure that the motorcycle
stands steadily when checking thesteering system to avoid hazard.Fuse specification: 15A
■ ■■ ■
■Replace fuse1.Remove the cover of accumulator.
2.Remove the negative terminal (-) and
positive terminal (+), then you can
take out the fuse.
3.Replace the blown fuse.CAUTION:
Do not use fuses of a higher amper-
age rating than recommended to
avoid extensive damages to the elec-
trical system, which may result infire.
WARNING
7-9
