Page 288 of 402
8-39 1. Differential gear oil filler bolt
1. Boulon de l’orifice de remplissage de l’huile de différentiel
1. Perno de relleno de aceite de engranajes del diferencial
1. Differential gear oil drain bolt
1. Boulon de vidange de l’huile de différentiel
1. Perno de drenaje de aceite de engranajes del diferencial
EBU12411
Differential gear oil replacement
1. Place the ATV on a level surface.
2. Place a container under the differential gear
case to collect the used oil.
3. Remove the oil filler bolt and oil drain bolt to
drain the oil.
4. Install the oil drain bolt, and then tighten it to
the specified torque.
Tightening torque: 
Differential gear oil drain bolt: 
10 Nm (1.0 m·kgf)
U5UH62.book  Page 39  Tuesday, April 5, 2005  6:57 PM 
     
        
        Page 290 of 402
8-41
5. Fill the differential gear case with the speci-
fied amount of the recommended oil.NOTE:_ 
Do not exceed the specified differential gear
oil quantity when filling. Overfilling will cause
the oil to seep out of the breather hose during
and after riding. 
The differential gear oil level cannot be
checked. The differential gear case capacity
is greater than the recommended oil quantity,
therefore the oil level cannot be accurately
checked from the oil filler cap hole. 
_
Recommended oil:
SAE 80 API GL-4 Hypoid gear oil
Oil quantity:
0.35 L
U5UH62.book  Page 41  Tuesday, April 5, 2005  6:57 PM 
     
        
        Page 292 of 402
8-43
CAUTION:_ Be sure no foreign material enters the differen-
tial gear case. _6. Install the oil filler bolt, and then tighten it to
the specified torque.
7. Check for oil leakage. If oil leakage is found,
check for the cause.  Tightening torque: 
Differential gear oil filler bolt: 
23 Nm (2.3 m·kgf)
U5UH62.book  Page 43  Tuesday, April 5, 2005  6:57 PM 
     
        
        Page 306 of 402
8-57
6. Squeeze the excess solvent out of the air fil-
ter element and let it dry.CAUTION:_ Do not twist the air filter element when squeez-
ing it. _7. Inspect the air filter element and replace it if
damaged.
8. Apply foam air filter oil to the air filter element.NOTE:_ The air filter element should be wet but not drip-
ping. _9. Pull the air filter element over its frame, and
then install the lock plate.
10. Install the air filter element assembly.
11. Install the air filter case cover by hooking the
fasteners onto the air filter case.
12. Install the seat.
U5UH62.book  Page 57  Tuesday, April 5, 2005  6:57 PM 
     
        
        Page 324 of 402
8-75
Refill with the same type of brake fluid. Mixing
fluids may result in a harmful chemical reaction
and lead to poor brake performance. 
Be careful that water does not enter the brake
fluid reservoir when refilling. Water will signifi-
cantly lower the boiling point of the fluid and
may result in vapor lock. 
Brake fluid may deteriorate painted surfaces or
plastic parts. Always clean up spilled fluid im-
mediately. 
Have a Yamaha dealer check the cause if the
brake fluid level goes down. 
U5UH62.book  Page 75  Tuesday, April 5, 2005  6:57 PM 
     
        
        Page 326 of 402
8-77
EBU01186
Brake fluid replacement 
Complete fluid replacement should be done only
by trained Yamaha service personnel. Have a
Yamaha dealer replace the following components
during periodic maintenance or when they are
damaged or leaking.
Replace the oil seals every two years. 
Replace the brake hoses every four years.
U5UH62.book  Page 77  Tuesday, April 5, 2005  6:57 PM 
     
        
        Page 338 of 402
8-89
EBU00570
Cable inspection and lubrication
WARNING
Inspect cables frequently and replace if dam-
aged. Corrosion can result when the outer cov-
ering of control cables becomes damaged.
Cables can also become frayed or kinked. Op-
eration of controls could be restricted, which
could cause an accident or injury.Lubricate the inner cables and the cable ends. If
the cables do not operate smoothly, ask a Yamaha
dealer to replace them.
Recommended lubricant:
Engine oil
U5UH62.book  Page 89  Tuesday, April 5, 2005  6:57 PM 
     
        
        Page 348 of 402
8-99
WARNING
Battery electrolyte is poisonous and danger-
ous, causing severe burns, etc. It contains sul-
furic acid. Avoid contact with skin, eyes or
clothing.
Antidote:
EXTERNAL: Flush with water.
lNTERNAL: Drink large quantities of water
or milk. Follow with milk of magnesia, beat-
en egg or vegetable oil. Call a physician
immediately.
EYES: Flush with water for 15 minutes and
get prompt medical attention. 
Batteries produce explosive gases. Keep
sparks, flame, cigarettes or other sources of
ignition away. Ventilate when charging or us-
ing in an enclosed space. Always shield your
eyes when working near batteries.
KEEP OUT OF REACH OF CHILDREN.
U5UH62.book  Page 99  Tuesday, April 5, 2005  6:57 PM