2006 VOLVO XC70 engine

171
Fuel system, Electronic ignition system, Suspension
Fuel system
 
>  

Distributor ignition system
@ # % * / F -
H  # 
> 

)
  # 5
"5&99&,
1
)

# 2
2*& 2
2-*I ,2
. 2
& 1
 # %&
/

,*F1
WARNING!
  
 


)



  >
(
 
 #
•Replacing ignition components e.g. plugs, coil, etc.
•Do not touch any part of the ignition system while the engine is
running. This may result in a shock and bodily injury.
Front suspension
)    
 
  


 

9
 

 

)
 

 
 






 


Rear suspension


   
 
 

 



(
!

2 
 "

 (


#

193 5

 
During programming, your hand-held transmitter may automatically stop
transmitting. To successfully train HomeLink®, continue to hold the
HomeLink® button. At the same time, repeatedly press and hold your
hand-held transmitter’s button at two-second intervals until HomeLink®
has learned your transmitter’s code. The HomeLink® indicator light
will flash first slowly, and then rapidly to indicate that the button has
been successfully programmed.
Determining if your garage door uses a rolling code
Determine, in one of the following ways, if your garage door uses a
rolling code system and is manufactured after 1996:
•"

C 




•
 
 

 

GY
=

 
 











•9 

GY






GY




  


8
* 

To train a rolling code garage door opener, follow these instructions
after programming the desired transceiver button according to “Program-
ming the transceiver.” The help of a second person may make training
easier.
%
G




,$













C 


 
   % &22 -FF -F%F ,#

G
1

*
9 :
;



:
; 

-
9 



GY
9 




GY





)

 
 
$



GY=

 






 

 

  
 




The remaining two HomeLink® buttons can be programmed in the
same way. In the event of any problems in programming the
HomeLink® Universal Transceiver, call toll-free 1-800-355-3515
(Internet: www.HomeLink.com).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used
in place of your hand-held transmitters.
To operate, the key must be turned to the “accessory” position (II) or
the engine must be running. Press the programmed HomeLink® button
to activate the garage door, driveway gate, security lighting, home
security system, etc.
Your original hand-held transmitters may, of course, be used at any
time.
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed
buttons:
%
:
 ; ,1

*

  
GY=


 
*2  
GYC 

 


-
"


The HomeLink® buttons can be reprogrammed using the procedures
described on the previous page.
,
GY
 8
1
HomeLink® Universal Transceiver (option)