Page 67 of 211
59 Programming the driver’s seat memory
(option)*
?
8
8
%
< *
-
(
*
3 (
4
%
7
> ,
1
*
9
7H7,1
-
47H7
%
?
&
(
"
"
4"(
9
%
(
N
C
Front seats
Manually adjusted front seats
%
@
> #
*
"
$
,1#
-
"
$
#
/
G
#
F
<
#
>
0
5
,
F&
1
4("BL
•Do not adjust the seat while driving. The
seat should be adjusted so that the brake
pedal can be depressed fully. In addition,
position the seat as far rearward as comfort
and control allow.
•Check that the seat is securely locked into
position after adjusting.8505040m
Page 71 of 211
63
8503126m
Front storage compartments, Coat hanger
Coat hanger
=
>
Storage in the glove
compartment
Cup holders in the center
console—V70 (option)
To remove the cup holders:
•9
,%1
,*1
•7
,-1
•(
,/1
Return the cup holder to the storage space in
the reverse order.
Cup holders in the center
console XC70 (option)
To remove the cup holders:
•B
•9?
Return the cup holder to the storage space in
the reverse order.
NOTE: Avoid pinching the parking brake
gaiter.
Page 95 of 211
87
Chapter 6 - Starting and driving
Fuel requirements 88
Refueling 90
Starting the engine 91
Manual transmission 93
Automatic transmission (AW5) 94
Automatic transmission (Geartronic) 96
All Wheel Drive 98
Four-C active chassis system (option) 99
Front/rear park assist (option/accessory) 100
Driving economy, Handling 101
Points to remember 102
Roof racks/load carriers 103
Emergency towing 105
Vehicle towing information 106
Towing a trailer 107
Detachable trailer hitch 108
Jump starting 109
Winter driving 110
Long distance trips 111
Three-way catalytic converter 112
Brake system 113
Anti-lock brake system 114
STC/DSTC 115
Page 100 of 211

92
Starting the engine
CAUTION:
•The engine should be idling when you
move the gear selector. Never accelerate
until after you feel the transmission
engage! Accelerating immediately after
selecting a gear will cause harsh engage-
ment and premature transmission wear.
•Selecting P or N when idling at a standstill
for prolonged periods of time will help
prevent overheating of the automatic
transmission fluid.
•Do not race a cold engine immediately
after starting. Oil flow may not reach
some lubrication points fast enough to
prevent engine damage.WARNING!
•Always place the gear selector in Park or
in reverse on models with a manual
transmission, and apply the parking brake
before leaving the vehicle. Never leave the
car unattended with the engine running.
•Always open garage doors fully before
starting the engine inside a garage to
ensure adequate ventilation. The exhaust
gases contain carbon monoxide, which is
invisible and odorless but very
poisonous.
•An extra mat on the driver's floor can
cause the accelerator pedal and the clutch
to catch. Check that the movement of the
accelerator pedal and clutch is not
impeded. Not more than one protective
floor covering may be used at one time.
Page 113 of 211

105
Emergency towing
Front towing eyelet Rear towing eyelet
Emergency towing
The towing eyelet is located in the tool bag,
under the floor of the cargo area, with the
spare tire. This eyelet must be screwed into the
positions provided on the right sides of either
the front or rear bumper (see illustration). To
attach the towing eyelet:
•=
,(1
•)
,<1
After the car has been towed, the eyelet should
be removed and returned to the tool bag. Press
the cover back into position.
Precautions when the car is
in tow
•
•
•7
8 #F2,&2$1
•7
8
#F2 ,&21
•4
•5
CAUTION:
•Please check with state and local authori-
ties before attempting this type of towing,
as vehicles being towed are subject to
regulations regarding maximum towing
speed, length and type of towing device,
lighting, etc.
•If the car’s battery is dead, do not attempt
to start the vehicle by pushing or pulling it
as this will damage the three-way catalytic
converter(s). The engine must be jump
started using an auxiliary battery (see page
109).
•If the car is being towed on a flat bed
truck, the towing eyelets must not be used
to secure the car on the flat bed. Consult
the tow truck operator.
WARNING!
•Remember that the power brakes and
power steering will not function when
engine is not running. The braking and
steering systems will function but the
brake pedal pressure required is 3 - 4
times above normal and greater steering
effort must be exerted.
•The towing eyelets must not be used for
pulling another vehicle out of a ditch or
for any similar purpose involving severe
strain.
•Do not use the towing eyelets to pull the
car up onto a flat bed tow truck.
A
B
C
8600422M
Page 115 of 211

107
Towing a trailer
•"
•6
WARNING!
•Bumper-attached trailer hitches must not be used on Volvo’s, nor
should safety chains be attached to the bumper.
•Trailer hitches attaching to the vehicle rear axle must not be used.•Never connect a trailer’s hydraulic brake system directly to the
vehicle brake system, nor a trailer’s lighting system directly to the
vehicle lighting system. Consult your nearest authorized Volvo
retailer for correct installation.
•When towing a trailer, the trailer’s safety wire must be correctly
fastened to the hole or hook provided in the trailer hitch on the car.
The safety wire should never be fastened to or wound around the
drawbar ball.
NOTE:
•When parking the car with a trailer on a hill, apply the parking
brake before putting the gear selector in (P)ark or reverse on
models with a manual transmission. Always follow the trailer
manufacturer's recommendations for wheel chocking.
•When starting on a hill, put the gear selector in (D)rive before
releasing the parking brake.
•If you use the manual (Geartronic) shift positions while towing a
trailer, make sure the gear you select does not put too much strain
on the engine (using too high a gear).
•The drawbar assembly/trailer hitch may be certified for trailers that
are heavier than the car is designed to tow. Please adhere to Volvo’s
recommended trailer weights.
* When driving for prolonged periods at temperatures above 86° F
(30° C), the maximum recommended weight is 2000 lbs (900 kg).
When preparing for trailer towing, observe
the following:
Volvo recommends the use of Volvo trailer hitches which are specially
designed for the car.
•7
8
6 #
"
$%0F2 ,.F21
"
$--22 N,%F221
+
$
•(6
#
•
) ;4
;
•4
0*2 ,%2221
•"
#
"*0F2 ,%*221 %%2 ,F21
&*0F2 ,%*221 %0F ,.F1
•7
8
#F2,&2$1
•H
>
=
•
8
•(
•
•
,
$
1
•'
C
C
•7
Page 121 of 211

113
Brake system
8
8
Water on brake discs and brake pads affects
braking
Driving in rain and slush or passing through an automatic car wash can
cause water to collect on the brake discs and pads. This will cause a
delay in braking effect when the pedal is depressed. To avoid such a
delay when the brakes are needed, depress the pedal occasionally when
driving through rain, slush etc. This will remove the water from the
brakes. Check that brake application feels normal. This should also be
done after washing or starting in very damp or cold weather.
Severe strain on the brake system
The brakes will be subject to severe strain when driving in mountains or
hilly areas or towing. Vehicle speed is usually slower, which means that
the cooling of the brakes is less efficient than when driving on level
roads. To reduce the strain on the brakes, shift into a lower gear and let
the engine help with the braking. Do not forget that, if you are towing a
trailer, the brakes will be subjected to a greater than normal load.
BRAKEBrake circuit malfunction
(
9
S
WARNING!
7
#'++
'"6H
6
NOTE: When the car is at a standstill and the engine is idling, e.g. at a
traffic light and the brake pedal is depressed, the pedal may go down
slightly. This is normal and is caused by an built-in function in the
power brake system.
Power brakes function only when the engine
is running
A
Page 122 of 211

114
Anti-lock Brake System (ABS)
If the warning lamp lights up there is a malfunction of the ABS
system (the standard braking system will however function) and the
vehicle should be driven cautiously to a Volvo retailer for inspection.
The Anti-lock Braking System (ABS) helps to improve vehicle control
(stopping and steering) during severe braking conditions by limiting
brake lockup. When the system "senses" impending lockup, braking
pressure is automatically modulated in order to help prevent lockup,
which could lead to a skid.
The system performs a self-diagnostic test when the engine is started
and when the vehicle first reaches a speed of approximately 12 mph
(20 km/h). The brake pedal will pulsate several times and a sound may
be audible from the ABS control module. This is normal.
To obtain optimal effect from the ABS system, constant pressure
should be kept on the brake pedal. Do not pump the brake pedal.
The switching of the ABS modulator will be audible and the brake pedal
will pulsate during braking. Please be aware that ABS does not increase
the absolute braking potential of the vehicle. While control will be
enhanced, ABS will not shorten stopping distances on slippery surfaces.
ABS with EBD (Electronic Brake Force Distribution)
EBD is an integrated part of the ABS system. EBD regulates the
hydraulic pressure to the rear brakes to help provide optimal braking
capacity. The brake pedal will pulsate during braking, which is normal.
If the BRAKE and ABS warning lights come on at the same
time, this could indicate a fault in the brake system.
•)
•"
•
•
,
%F&
1
Anti-lock Brake System (ABS)
WARNING!
7
'++
'"6H
A6
•
7
A6
Emergency Brake Assistance (EBA)
H<(
4H<(
8
A
H<(
4