2006 TOYOTA RAV4 wiper fluid

WIPER AND WASHER – FRONT WIPER MOTOR AND LINKWW–13
WW
(c) Install the arm and blade with the nut. Make sure
that the arm and blade comes to the position shown
in the illustration.
Torque: 21 N*m (214 kgf*cm, 23 ft.*lbf)
HINT:
Hold down the arm hinge with your hand while
tightening the nut.
(d) Operate the front wipers while spraying water or
washer fluid on the windshield. Ensure that there is
no interference between the blades and pillar.
8. INSTALL FRONT WIPER ARM HEAD CAP
(a) Install the 2 caps.
9. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
B133594E01

WIPER AND WASHER – WASHER MOTORWW–33
WW
INSPECTION
1. INSPECT WINDSHIELD WASHER MOTOR AND
PUMP ASSEMBLY
HINT:
This check should be performed with the windshield
washer motor and pump installed to the washer jar.
(a) Fill the washer jar with washer fluid.
(b) Connect the battery's positive (+) lead to terminal 1
of the washer motor and pump, and the negative (-)
lead to terminal 2.
(c) Check that washer fluid flows from the washer jar.
OK:
Washer fluid flows from the washer jar.
If the result is not as specified, replace the washer
motor and pump assembly.
2. INSPECT REAR WASHER MOTOR AND PUMP
ASSEMBLY
(a) Fill the washer jar with washer fluid.
(b) Connect the battery's positive (+) lead to terminal 1
of the washer motor and pump, and the negative (-)
lead to terminal 2.
(c) Check that washer fluid flows from the washer jar.
OK:
Washer fluid flows from the washer jar.
If the result is not as specified, replace the washer
motor and pump assembly.
INSTALLATION
1. INSTALL REAR WASHER MOTOR AND PUMP
ASSEMBLY
(a) Install the windshield washer motor and pump to the
packing of the washer jar.
2. INSTALL WINDSHIELD WASHER MOTOR AND PUMP
ASSEMBLY
(a) Install the windshield washer motor and pump to the
packing of the washer jar.
E114464
E114465
B133126E01
B133127E01

WW–34WIPER AND WASHER – WASHER MOTOR
WW
3. INSTALL WINDSHIELD WASHER JAR ASSEMBLY
(a) Install the windshield washer jar and pump with the
3 bolts.
(b) Connect the connectors.
4. FILL UP WASHER JAR AND PUMP ASSEMBLY WITH
WASHER FLUID
(a) Connect the washer hoses to the washer motor and
pump, and fill the washer jar with washer fluid.
5. INSTALL FRONT BUMPER COVER (See page ET-11)
6. INSTALL RADIATOR SUPPORT OPENING COVER
(See page ET-12)
7. INSTALL FRONT FENDER LINER LH (See page ET-
12)
8. INSTALL FRONT FENDER LINER RH (See page ET-
12)
9. INSTALL WASHER INLET SUB-ASSEMBLY
(a) Install the washer inlet of the washer jar and pump
to the windshield washer jar and pump.
(b) Install the washer inlet of the washer jar and pump
with the clip.
10. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
B133945
B133129
B133130