DIFFERENTIAL – REAR DIFFERENTIAL CARRIER ASSEMBLYDF–45
DF
(d) Slowly raise the transmission jack, fix the nuts in
place and install the 3 bolts.
Torque: 86 N*m (877 kgf*cm, 63 ft.*lbf) for bolt A
140 N*m (1,428 kgf*cm, 103 ft.*lbf) for
bolt B
NOTICE:
Tighten the bolts, not the nuts.
(e) Connect the connector.
(f) Install the breather tube.
(g) Connect the harness clamp.
4. INSTALL REAR SUSPENSION MEMBER BRACE LH
(a) Install the member brace to the suspension member
with the 2 bolts.
Torque: 60 N*m (612 kgf*cm, 44 ft.*lbf)
5. INSTALL REAR SUSPENSION MEMBER BRACE RH
HINT:
Use the same procedures described for the LH side.
6. TEMPORARILY INSTALL PROPELLER WITH
CENTER BEARING SHAFT ASSEMBLY (See page
PR-5)
7. TIGHTEN PROPELLER WITH CENTER BEARING
SHAFT ASSEMBLY (See page PR-6)
8. INSPECT JOINT ANGLE (See page PR-4)
9. INSTALL CENTER EXHAUST PIPE ASSEMBLY (See
page EX-5)
10. INSTALL TAILPIPE ASSEMBLY (See page EX-6)
11 . I N S TA L L R E A R WH E E L
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
12. ADD DIFFERENTIAL OIL
(a) Add differential oil (see page DF-3).
13. CHECK FOR DIFFERENTIAL OIL LEAKAGE
14. CHECK FOR EXHAUST GAS LEAKAGE
If gas is leaking, tighten the areas necessary to stop the
leak. Replace damaged parts as necessary.
C129479E01
C127575
