2006 SKODA ROOMSTER technical data

Fuses and light bulbs257
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Parking light at the front
– Open the bonnet.
– Remove the protective cap ⇒page 255, fig. 183 .
– Grasp the light bulb holder and pull it out of the headlight.
– Replace the light bulb in the light bulb holder and re-insert into the headlight.
Fog lights
– Remove the grille next to the fog light (for turning light) or the grille around the round fog light (for fog light) ⇒page 246.
– Release the screws ⇒fig. 186 and remove the fog light. – Turn the connector with the light bulb up to the stop towards
the left and remove.
– Change the light bulb, put the connector back into the head- light and secure by turning to the right.
– Put the fog light in place with the catch on the side opposite the grille and then press in the opposite part. Applies to turning
light, for round fog light screw in the 3 screws.
– Screw in the screws ⇒fig. 186 and re-insert the grille
⇒ page 246.
– We recommend that you have the headlight setting checked by a Skoda Service Partner after replacing the light bulb.
Storage compartment lighting*
AB
Fig. 186 Structure of
the light bulb of the fog
light
Fig. 187 Remove
lighting in storage
compartment on front
passenger side
NKO 20 A05.book Page 257 Wednesday, June 21, 2006 1:42 PM

Fuses and light bulbs259
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
– Re-insert the light glass. Press the light glass in up to the stop
- check for correct seating of the sealing rubber.
– Screw on the light glass but not too tightly.
Rear light unit
– Open the tailgate.
– Unscrew the rear light unit ⇒fig. 190 .
– Grasp the rear light unit at the top and bottom part and pull it to the rear.
– Disconnect the plug connector. ⇒fig. 191 .
Fig. 190 Remove the
rear light unit
Fig. 191 Disconnect
plug connection
NKO 20 A05.book Page 259 Wednesday, June 21, 2006 1:42 PM

Fuses and light bulbs261
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Luggage compartment light
– Open the tailgate.
– Insert a screwdriver into the slot below the light ⇒fig. 194 .
Lever out the light carefully.
– Disconnect the plug connector.
– Replace the defective light bulb.
– Recreate the plug connection.
– Insert the light from the rear and press it forwards up to the stop.
Fig. 194 Remove the
luggage compartment
light
NKO 20 A05.book Page 261 Wednesday, June 21, 2006 1:42 PM

General263
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Technical Data
General
Identification data
Vehicle data sticker
The vehicle data sticker ⇒fig. 195 is located on the floor of the luggage
compartment and is also stated in the Service schedule.
The vehicle data sticker contains the following data:
Vehicle identification number (VIN)
Vehicle type
Gearbox code, paint number, interior equipment number, engine
output, engine code
Partial description of the vehicle Vehicle identification number (VIN)
The vehicle identification number - VIN (vehicle body number) is stamped
into the engine compartment on the right hand shock absorber dome. This
number is also located on a sign on the lower left hand edge below the
windscreen (together with a VIN bar code).
Engine number
The engine number is stamped into the engine block.
Type plate (production plate)
The type plate is located in the engine compartment at the front on the left
hand shock absorber dome.
Homologation sign
The homologation sign is located on the lock carrier. Vehicles for certain
countries do not have an homologation sign.
Sticker on inside of fuel filler flap
The sticker is affixed to the inside of the fuel filler flap. The sticker contains
the following data:
•The prescribed types of fuel,
•Tyre size,
•Tyre pressure.
Note
•You will find the technical data of your vehicle in the separate brochure
"Technical Data".
Fig. 195 Vehicle data
sticker
A1
A2
A3
A4
NKO 20 A05.book Page 263 Wednesday, June 21, 2006 1:42 PM