2006 SAAB 9-2X headlight bulb

10

Illustrated index
Exterior
1324 5
11 12 10 78 96
000170
1) Engine hood (page 11-4)
2) Headlight switch (page 3-15)
3) Replacing bulbs (page 11-44)
4) Wiper switch (page 3-21)
5) Moonroof (page 2-21)
6) Door locks (page 2-4)
7) Tire pressure (page 11-31)
8) Flat tires (page 9-4)
9) Tire chains (page 8-9)
10) Front fog light button (page 3-19)
11) Tie-down hooks (page 9-10)
12) Towing hooks (page 9-10)
A1910BE-A-GSAAB.book Page 10 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com

3-14
Instruments and controls
Always make sure this light is out before
you start to drive.
All-Wheel Drive warn-
ing light (AWD AT vehi-
cles)The All-Wheel Drive warning light comes
on when the ignition switch is turned to the
“ON” position and goes out after the en-
gine has started.
This light comes on when All-Wheel Drive
is disengaged and the drive mechanism is
switched to Front Wheel Drive for mainte-
nance or similar purposes (Non-turbo ve-
hicles).
It flashes if the vehicle is driven with tires
of differing diameters fitted on the wheels
or with an excessively low air pressure in
any of the tires.

Selector lever position indi-
cator (AT vehicles)This indicator shows the position of the
selector lever.
Turn signal indicator
lightsThese lights show the operation of the
turn signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be
burned out. Replace the bulb as soon as
possible. Refer to the “Replacing bulbs”
section in chapter 11.

High beam indicator
lightThis light shows that the headlights are in
the high beam mode.
This indicator light also comes on when
the headlight flasher is operated.
Cruise control indica-
tor lightThe cruise control indicator light comes on
when the ignition switch is turned to the
“ON” position and goes out after approxi-
mately three seconds.
This light comes on when the “CRUISE”
main switch is pressed.
If it flashes during driving, deactivate the
cruise control system and contact your
Saab dealer for an inspection. Refer to
“Cruise control” in chapter 7 for the deac-
tivation procedure of the cruise control
system.NOTEIf you move the cruise control lever or
press the main switch button while
turning the ignition switch “ON”, the
cruise control function is deactivated
and the “CRUISE” indicator light flash-
es. To reactivate the cruise control
function, turn the ignition switch back Continuing to drive with the AWD
warning light flashing can damage
the powertrain. If the AWD warning
light starts to flash, promptly park in
a safe place and check whether the
tires have differing diameters and
whether any of the tires has an ex-
cessively low inflation pressure.
P
R
2
1 D N
3
300630
A1910BE-A-GSAAB.book Page 14 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com

Maintenance and serviceTires and wheels ................................................ 11-30
Types of tires .......................................................... 11-30
Tire inspection ........................................................ 11-30
Tire pressures and wear ........................................ 11-31
Wheel balance ........................................................ 11-32
Wear indicators ....................................................... 11-33
Tire rotation ............................................................. 11-33
Tire replacement ..................................................... 11-33
Wheel replacement ................................................. 11-34
Aluminum wheels ............................................... 11-35
Windshield washer fluid .................................... 11-35
Replacement of wiper blades ............................ 11-36
Windshield wiper blades assembly ...................... 11-36
Windshield wiper blade rubber ............................. 11-37
Rear window wiper blade assembly ..................... 11-38
Rear window wiper blade rubber .......................... 11-38
Battery ................................................................. 11-40
Fuses ................................................................... 11-41
Main fuse ............................................................. 11-42
Installation of accessories ................................ 11-43
Replacing bulbs .................................................. 11-44
HID headlight bulbs 3 ............................................ 11-46
Halogen headlight bulbs 3 .................................... 11-46
Parking light ............................................................ 11-48
Front turn signal light and front side marker light
bulbs ..................................................................... 11-49
Rear combination lights ......................................... 11-50License plate light .................................................. 11-52
Dome light, map light and cargo area light .......... 11-52
3 Asterisk means: equipment not fitted in all cars (can depend
on model variant, engine variant, market specification, options
or accessories)
.
A1910BE-A-GSAAB.book Page 2 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com

11 - 4 6
Maintenance and service

HID headlight bulbs
3

Halogen headlight bulbs
3
NOTE
If headlight aiming is required, con-
sult your Saab dealer for proper adjust-
ment of the headlight aim.

It may be difficult to replace the
bulbs. Have your Saab dealer replace
the bulbs if necessary.
Right-hand low beam light bulb
Non-turbo model
1) Air intake duct
Turbo model
High-intensity-discharge (HID) bulbs
are used for the low beams of the
headlights. These HID bulbs use an
extremely high voltage. To avoid the
risk of an electric shock and result-
ing serious injury, you should not
attempt to replace them. Neither
should you attempt to replace the
high-beam bulbs, remove/refit the
headlight assemblies, or remove
any headlight-assembly compo-
nents. For replacement of the head-
light bulbs (low-beam and high-
beam), removal and installation of
the headlight assemblies, and re-
moval of headlight-assembly com-
ponents, contact your Saab dealer.
Ask your Saab dealer to check
whether your vehicle is equipped
with HID headlights.
Halogen headlight bulbs become
very hot while in use. If you touch
the bulb surface with bare hands or
greasy gloves, finger prints or
grease on the bulb surface will de-
velop into hot spots and cause the
bulb to break. If there are finger
prints or grease on the bulb surface,
wipe them away with a soft cloth
moistened with alcohol.
Ask your Saab dealer to check
whether your vehicle is equipped
with halogen headlights.
B00483
1
B00484
A1910BE-A-GSAAB.book Page 46 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com

Maintenance and service
11 - 4 7
11
– CONTINUED –
1. Remove the air intake duct mounting
bolt, then remove the air intake duct.
2. Remove the bulb cover by turning it
counterclockwise.3. Push the retainer spring in the direction
of the arrow to remove it from the hook.
4. Pull the bulb out of the electrical con-
nector. Replace the bulb with a new one.
5. Set the retainer spring securely.
6. Reconnect the electrical connector.7. Install the bulb cover.

Left-hand low beam light bulb

High beam light bulbs
0
1. Remove the bulb from the headlight
assembly by turning it counterclockwise.
B00485B00486
700092B00488
Replacement of the left-hand low
beam light bulb requires removal of
the battery and is thus dangerous. It
must be performed by a Saab deal-
er.
B00489
A1910BE-A-GSAAB.book Page 47 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com

11 - 4 8
Maintenance and service
2. Remove the electrical connector from
the bulb.
3. Replace the bulb with a new one.
4. Reconnect the electrical connector. At
this time, be careful not to touch the bulb
surface.
5. Install the bulb in the headlight assem-
bly by turning it clockwise until it clicks.

Parking light
Right-hand sideNon-turbo model
1) Air intake ductTurbo model
1. Remove the air intake duct mounting
bolt, then remove the air intake duct.
2. Remove the bulb cover by turning it
counterclockwise.
700093
B00483
1
B00484B00485
A1910BE-A-GSAAB.book Page 48 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com

Maintenance and service
11 - 4 9
11
– CONTINUED –
3. Hold the end of the parking light and re-
move the parking light.
4. Pull the bulb out of the socket. Install a
new bulb.5. Fit the bulb socket into the headlight
assembly.
6. Install the bulb cover.

Left-hand side

Front turn signal light and
front side marker light bulbs
Right-hand side
It may be difficult to replace the bulbs.
Have your Saab dealer replace the bulbs
if necessary.

Left-hand side
1. Turn the steering wheel fully to the left.2. Undo the three clips at the bottom of
the undercover beside the front-left wheel.
3. Undo the hook at the top of the under-
cover beside the front-left wheel.
B00490B00491
Replacement of the left-hand park-
ing light bulb requires removal of
the battery and is thus dangerous. It
must be performed by a Saab deal-
er.
B00492B00493
A1910BE-A-GSAAB.book Page 49 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com

Specifications
12-9
12
Bulb chartDescription Wattage Bulb type
Headlight
Premium Package
vehicles
Low beam 12V-35W D2R
High beam 12V-60W 9005 (HB3)
Except Premium
Package vehicles
Low beam 12V-55W H1
High beam 12V-60W 9005 (HB3)
Front fog light 12V-51W 9006 (HB4)
Front turn signal light 12V-21W (Amber) WY21W (7440A)
Front side marker light 12V-5W W5W
Parking light 12V-5W W5W
Rear combination light
Brake/tail light 12V-21/5W W21/5W (7443)
Turn signal light 12V-21W (Amber) WY21W (7440A)
Back-up light 12V-16W W16W (921)
High mount stop light 12V-1.3W LED
License plate light 12V-5W W5W
Cargo area light 12V-5W —
Front ashtray light 12V-1.4W —
Dome light 12V-8W —
Map light 12V-8W —
A1910BE-A-GSAAB.book Page 9 Tuesday, September 6, 2005 8:37 AM
ProCarManuals.com