To be read with the diagnostic tool (Identification screen):
FAULT FINDING LOG
System: Tyre Pressure MonitorPage 2 / 2
●Computer identification and parts exchanged for the system
Part 1 part no.
Part 2 part no.
Part 3 part no.
Part 4 part no.
Part 5 part no.
Computer part no.
Supplier no.
Program no.
Software version
Calibration number
VDIAG
●
Faults read with diagnostic tool before operation
Fault no. Present Stored Fault name Specification
●
Conditions under which fault occurs
Status or parameter no. Parameter name Value Unit
●
System-specific information
Description:
●
Additional information
What other parts were replaced?
What factors led you to replace the part(s)?
For Laguna II, Vel Satis and Espace IV vehicles, has trigger
threshold command VP 017 been correctly executed?
What was the vehicle's mileage when the customer complaint
occurred?
What is the size of the wheel rims and the size of the tyres?
FIC No. (Customer Fault Sheet)
FD 23
Fault finding log
page to print or photocopy - page to print or photocopy - page to print or photocopy
TYRE PRESSURE MONITOR
Fault finding - Conformity check
35B
UCH
Program no.: 350 and higher
Vdiag No: 48-4C-4D-4F-50
NOTESOnly check conformity after a complete check using the diagnostic tool.
Test conditions: Engine switched off, after ignition feed on, tyres inflated to correct
pressure.
Order Sub-functionParameter or Status
checked or Action Display and notes Fault finding
2 (con-
tinued)Tyre
managementPR015:Slight under-
inflation threshold- 0.4 bar
None PR059:Puncture report
threshold- 0.6 bar
PR017:Cold over-inflation
threshold0.7 bar
PR018:Warm over-inflation
threshold0.8 bar
PR016:Driving range
following punctureX Km
X = 120 miles
(200 km) if no tyre
puncture is
detected.X = Mileage remaining
following a tyre puncture.
Edition 435B-21
