N I SSAN 350Z ADDITIONAL FEATU R E S
MIRROR ADJUSTMENT
The rear view mirror has two pivot points for adjustments.
Adjust the rear view mirror height at the rear pivot and tilt
the mirror at the front pivot. Position the mirror to provide
the best visibility through the rear window.
TIRE PRESSURE MONITORING SYSTEM
This system monitors tire pressure. Please remember, this system
does not detect a sudden drop in tire pressure (for example, a
blowout while driving). It also does not monitor the air pressure in
the spare tire.
If the low tire pressure warning light comes on, check the tire
pressure in all four tires. Adjust the low tire pressure to the recommended COLD tire
pressure shown on the Tire and Loading Information label to turn the low tire pressure
warning light off.
If TPMS is not functioning properly, the low tire pressure warning light will flash for
approximately 60 seconds when the key is turned on. The light will remain on after the
60 seconds. Have the system checked by a NISSAN dealer.
SCREW-IN RECOVERY HOOK
Your vehicle is supplied with a screw-in recovery
hook for pulling the vehicle forward. For example:
Pulling the vehicle onto a flat bed for towing.
The screw-in recovery hook tool is located in the
right rear luggage compartment area under the
cover along with the vehicle jack.
To install the recovery hook:
Remove the recovery hook cover from the
front bumper.
Install the recovery hook as shown in the photo.
Turn it clockwise until securely tightened.
FRONT SEAT ADJUSTMENTS
With Manual Seats
Pull up on the lever under the front of the
seat and slide backward or forward to the
desired position. Release the lever to lock
the seat in position.
Lift the lever on the side of the seat to
adjust your seatback backward or forward;
release the lever when you have found
a comfortable angle and the seat belt
fits properly.
Turn either dial to adjust the angle and
height of the seat cushion to the
desired position.
With Power Seats (if so equipped)
Move the sliding switch 01 forward
or
backward to adjust the seat cushion to the
desired position.
Move the reclining switch 02 forward
or
backward to adjust the seatback to the
desired angle.
Turn either dial to adjust the angle and
height of the seat cushion to the
desired position.
01
02
